2007 Lexus GS350 light

104
2-1. Driving procedures
Turn signal lever
■Turn signals can be operated when
The engine switch is in “IG-ON” mode.
■If the indicators flash faster than usual
Check that a light bulb in the front or rear
turn signal lights has not burned out.
Left turn
Right turn
Move and hold the lever part-
way to signal a lane change
The left hand signal will flash
until you release the lever.
Move and hold the lever part -
way to signal a lane change
The right hand signal will flash
until you release the lever.

107
2-2. Instrument cluster
2
When driving
Odometer/trip meter and trip meter reset button
Changes the display
Resets the trip meter driving
range to “0”.
Instrument panel light control
The brightness of the instrument panel lights excluding the clock and out-
side temperature display, can be adjusted.
Brighter
Darker
Maximum brightness

108
2-2. Instrument cluster
Light sensitive optitron meter
To reduce glare or reflection of the instrument cluster, the cluster glass is
tinted automatically or manually. You can select a setting from 7 modes.
Display the present setting, then
change the mode.
To change the mode, press the but-
ton once and then again within 6
se
conds. 
Each time you press the button, the
mode changes in the
following
order;
1. “AUTO - Norm”
2. “AUTO - Lo”
3. “AUTO - Hi”
4. “MANUAL - 1”
5. “MANUAL - 2”
6. “MANUAL - 3”
7. “ M A N U A L - 4 ”
Mode 1 to 3: The cluster glass tint
will be adjusted automatically
depending on t

he intensity of sun -
light in the surrounding. 
Mode 4 to 7: The cluster glass tint
will be
fixed when a certain level of
sunlight is reached in the surround -
ing. 
(“Norm” to “Hi”, “1” to “4” referring
to the le
vel of cluster glass tint.)

109
2-2. Instrument cluster
2
When driving
NOTICE
■To prevent damage to the engine and its components
●Do not let the indicator needle of the tachometer enter the red zone, which indi-
cates the maximum engine speed.
●The engine may be overheating if the temperature gauge is in the red zone (“H”). In
this case, immediately stop the vehicle in a safe place. Check the engine after it has
cooled completely. ( P. 4 9 2 )
■To activate the light sensitivity function properly
Do not affix a sticker or window tint to the rear window glass, or put an object
behind the rear seat.

110
2-2. Instrument cluster
Indicators and warning lights
The indicator and warning lights on the instrument cluster and center
panel inform the driver of the status of the vehicle’s various systems.
Instrument cluster
Center panel

111
2-2. Instrument cluster
2
When driving
■Indicators
The indicators inform the driver of the operating state of the vehi-
cle’s various systems.
Turn signal indicator 
( P. 1 0 4 )Cruise control indicator 
(  P. 1 2 4 )
Headlight high beam indi-
cator ( P. 116)Damping mode indicator 
(GS430) ( P. 1 5 8 )
(U.S.A.)
Headlight indicator 
(  P. 116)“AFS OFF” indicator 
( P. 117)
(Canada)
Tail light indicator 
( P. 116)
(if equipped)
Intuitive parking assist
indicator ( P. 1 3 7 )
Fog light indicator 
( P. 1 1 9 ) Slip indicator ( P. 1 6 0 )
Shift position and shift
range indicators 
( P. 1 0 2 )“VSC OFF” indicator
(P. 1 6 0 )
“ECT PWR” indicator 
(  P. 1 0 1 )SRS airbag on-off
indicator ( P. 7 2 )
“ECT SNOW” indicator 
(  P. 1 0 1 )
*
*
*

112
2-2. Instrument cluster
CAUTION
■If a safety system warning light does not come on
Should a safety system light such as ABS and the SRS airbag warning light not
come on when you start the engine, this could mean that these systems are not
available to help protect you in an accident, which could result in death or serious
injury. Have the vehicle inspected by your Lexus dealer immediately if this occurs.
■ Warning lights
Warning lights inform the driver of malfunctions in the indicated
vehicle’s systems. ( P. 4 4 9 )
*: These lights turn on when the engine switch is turned to “IG-ON” mode
to indicate that a system check is being performed. They will turn off
after the engine is started or afte r a few seconds. There may be a mal -
function in a system if the lights do not come on, or turn off. Have the
vehicle inspected by your Lexus dealer.
(U.S.A.)(Canada)(U.S.A.)(Canada)
(U.S.A.)(Canada)(if equipped)
*******
*****
*

116
2-3. Operating the lights and windshield wipers
Headlight switch
Turning on the high beam headlights
With the headlights on, push the
lever forward to turn on the high
beams.
Pull the lever back to the center
position to turn the high beams off.
Pull the lever toward you to turn
on the high beams.
Release to turn them off. You can
flash the high beams with the head-
lights on or off.
The headlights can be operated manually or automatically.
The side marker, parking,
tail, license plate and
instrument panel lights
turn on.
The headlights and all lights listed above turn
on

.
The headlights and all the lights listed above turn
on and of

f automatically.
(When the engine switch
is in “IG-ON” mode.)
U.S.A.
Canada