2007 Lexus GS350 light

426
4-3. Do-it-yourself maintenance
■Luggage compartment
FuseAmpereCircuit
1RR S/SHADE7. 5Rear sunshade
2PSB30Pre-collision seat belt
3RR-IG210
4RR-IG110Pre-collision seat belt, seat belt pre-
tensioners
5RR-B10Trunk light
6RR FOG7. 5
7STOP LP L10Stoplights, back-up light
8STOP LP R10High mounted stoplights
9RR TAIL10Tail lights, license plate lights

427
4-3. Do-it-yourself maintenance
4
Maintenance and care
■Luggage compartment 
(vehicles with active stabilizer suspension system)
FuseAmpereCircuit
1STB FR50Front stabilizer
2STB RR30Rear stabilizer
3STB DC/DC30DC/DC converter
■After a fuse is replaced
●If the lights do not turn on even afte r the fuse has been replaced, a bulb may
need replacement. ( P. 4 3 8 )
●If the replaced fuse blows again, have the vehicle inspected by your Lexus
dealer.
■If there is an overload in the circuits
The fuses are designed to blow before th
e entire wiring harness is damaged.

429
4-3. Do-it-yourself maintenance
4
Maintenance and care
Headlight aim
■Gauges
High beam vertical position
Low beam vertical position
High beam horizontal posi -
tion
Low beam horizontal position
■ A
djustment bolts
High beam horizontal adjust-
ment
High beam vertical adjust-
ment
Low beam adjustment bolt A
Low beam adjustment bolt B
■ Befor
e checking the headlight aim
Make sure the vehicle has a full ta nk of gas and the ar
ea around
the headlight is not deformed.
Park the vehicle on level ground.
Sit in the driver’s seat.
Bounce the vehicle several times.STEP1
STEP2
STEP3
STEP4

430
4-3. Do-it-yourself maintenance
■Adjusting the headlight aim
Low beam (vertical adjustment)
Using a Phillips-head screw-
driver, turn adjustment bolt A so
that the bubble is within the 2
center lines.
Remember the turning direction
and the number of turns.
Turn bolt B the same number of
turns and in the same direction
as step 1.
Low beam (horizontal adjustment)
Turn adjustment bolt A so that the re d line on the gauge is in the middle
of the “0” mark (within the blue lines to either side of the gaug\
e).
High beam (vertical and horizontal adjustment)
Turn each adjustment bolt in either dir
ection so that the bubble in
within the 2 center lines (vertical), an d the red line on the gauge is in
the middle of the “0” mark (within th e blue lines to either side of the
gauge) (horizontal).
If you feel that there is a large de
viation, have the headlight aim
adjusted at a Lexus dealer.
STEP1
STEP2

431
4-3. Do-it-yourself maintenance
4
Maintenance and care
Light bulbs
You may replace the following bulbs yourself. For more information about
replacing other light bulbs, contact your Lexus dealer.
■Prepare a replacement light bulb.
Check the wattage of the light bulb being replaced. ( P
. 507)
■ R
emove the engine compartment cover if necessary.
 P.
3 7 8
■ F
ront bulb locations
■Rear bulb locations
Parking light
Headlight high beam
Rear turn signal light Back-up light

432
4-3. Do-it-yourself maintenance
Replacing light bulbs
■Headlight high beam
Unplug the connector while push-
ing the lock release.
Turn the bulb base counterclock -
wise to remove it.
STEP1
STEP2

433
4-3. Do-it-yourself maintenance
4
Maintenance and care
■Parking light
Turn the bulb base counterclock-
wise.
Remove the light bulb.
■ B
ack-up light
Open the trunk lid. Remove the
trunk handle and panel co
ver clips.
Partly remove the trunk panel
co
ver and turn bulb bases coun -
terclockwise.
STEP1
STEP2
STEP1
STEP2

434
4-3. Do-it-yourself maintenance
Remove the light bulb.
■ R
ear turn signal light
Open the trunk lid and remove the
co
ver.
Turn the bulb base counterclock -
wise.
Remove the light bulb.
STEP3
STEP1
STEP2
STEP3