2007 Lancia Thesis Owner handbook (in English)

224
After battery disconnec-
tion or fuse interruption,
the anti-trap system must
be initialized again as follows:
1) turn selector A clockwise and
fully to its stop, to position 3 cor-
responding to maximum pivoting
(fig. 184)
2) keep selector A depressed
until the sunroof jolts along to the
maximum pivoting position
3) release the selector after the
sunroof has stopped for at least 2
seconds
4) press, within 5 seconds, the
selector again and keep it
depressed
5) the sunroof will start moving
within 5 further seconds and will
perform a complete opening and
closing cycle, after which it will
stop in the closed position
6) release the selector after the
sunroof has stopped for at least 2
seconds.The system is thus initialized
and resumes its normal opera-
tion. If this does not occur, con-
tact your Lancia Dealership.
If the operation is interrupted
before it is completed, repeat the
procedure from the start.Regularly check that the
water draining holes A
(fig. 187 set at the corners
of the sunroof housing, are not
obstructed.
fig. 187
L0A0283b

225
CENTRAL SUNROOF AND
WINDOW LOCKING SYSTEM
Central locking/opening of sunroof
and windows can be actuated at the
following conditions:
– ignition key removed
– all doors closed correctly.To actuate central locking by
means of the remote control, keep
button B(fig. 188) depressed for
more than 3 seconds after closing
the doors: the sunroof and window
winders will be actuated until they
are completely closed or the button
is released.
To actuate central locking by
means of the remote control, keep
button A(fig. 188) depressed for
more than 3 seconds after opening
the doors: the sunroof and windows
winders will be actuated until they
are completely open or the button is
released.
This function can be used before
getting into the car when it has been
parked in the sun, in order to aerate
the passenger compartment.Central locking can also be actuat-
ed by turning the key in the lock of
one of the front doors: keep the key
turned to 2(fig. 189) for more than
3 seconds. The sunroof and window
winders are actuated until they are
completely closed or the key is
released.
By keeping the key turned to 1(fig.
189) for more than 3 seconds, both
the sunroof and all the windows will
open. The sunroof and window
winders are actuated until they are
completely open or the key is
released.
fig. 188
L0A0174b
fig. 189
L0A0176b

226
SOLAR CELLS
The upper part of the sunroof
incorporates 21 solar cells that pro-
duce a maximum power of 24 W to
feed the climate control system fan,
when the car is parked with the sun-
roof closed or in pivoting position.
Fan actuation is automatic and air
distribution corresponds to the latest
setting made before switching the
car off.
This function is useful especially on
summer days, since it greatly
reduces the temperature inside the
passenger compartment as well as
the duration of the cooling cycle
after car start-up, thus avoiding the
accumulation of warm air in the air-
conditioning unit lines.
In winter, the ventilation function
reduces dampness inside the passen-
ger compartment.EMERGENCY MANOEUVRE
In case the electric actuation device
fails to operate, the sunroof can be
actuated manually, proceeding as
follows:
1)Take the Allen screw wrench D
(fig. 191) out of the tool kit and use
it to actuate the sunroof in an emer-
gency.
2)Remove front ceiling light caps
Aand B(fig. 190) by levering with
a screwdriver on the outer side (the
caps are press-fitted).
3)Take out screws C(fig. 191)
and remove the ceiling light by
releasing it from the front clamps.
IMPORTANTDo not disconnect
the ceiling light connectors.4)Insert the Allen screw wrench D
into the hexagonal seat of the sun-
roof starter motor, then turn it:
– clockwise to open the sunroof
– counterclockwise to close the
sunroof.
5)After completing the closing or
opening operation, put the ceiling
light back to its place by fitting in
the front clamps first and then fixing
the rear screws.
IMPORTANTWhen refitting the
ceiling light, check that the electric
cables are positioned correctly.
6)Press-fit the screw cover caps.
fig. 190
L0A0129b
fig. 191
L0A0329b

227
BOOT
The boot can be opened both from
the outside and the inside of the car.
IMPORTANT Faulty closing of the
boot is signalled by the lighting of
the relevant symbol on the multi-
function display, together with mes-
sage “BOOT OPEN”With the battery flat, or
after the interruption of
one of the protection
fuses, or if you want to disconnect
a loaded battery (e.g. for a car
stop period), before opening the
luggage compartment bonnet
carefully read and comply with
the instructions contained in the
paragraph “If battery is to be dis-
connected” in the chapter “In an
emergency”.
OPENING FROM THE INSIDE
Boot tailgate is opened electrically.
It can be opened only when the igni-
tion key is at MARand the car is
stopped, or for 3 minutes after turn-
ing the key to STOPwithout open-
ing or closing a door.
To open the boot, press button A
(fig. 192), placed on the central con-
sole, as follows:
– a short pressure of the button will
release the boot lock– a prolonged pressure of the but-
ton will release the lock and open
the boot.
Boot lifting is facilitated by the
action of gas dampers.
The dampers are cali-
brated so as to ensure
correct lifting of the boot
tailgate with the weights estab-
lished by the manufacturer.
Addition of extra equipment (e.g.
spoiler, etc.) can adversely affect
operation and safety of use.
fig. 192
L0A0167b

228
OPENING FROM THE OUTSIDE
WITH THE KEY (fig. 193)
The boot lock is electrified: press
button Aon the tailgate to open it.
In an emergency (battery run down
or electrical system failure), the tail-
gate can be opened by fully turning
counterclockwise the key in the lock
and exerting at the same time a
slight pressure on the lower edge of
the number plate holder to reduce
the opening effort.
IMPORTANTIf the boot was
opened using the key, at closing the
automatic function will be deacti-
vated. To restore the automatic
function press button A.OPENING BY MEANS OF THE
REMOTE CONTROL
The tailgate can be opened from
the outside by pressing button A
(fig. 194) on the remote control,
even when the electronic alarm is on.
When the electronic alarm is on,
boot opening is accompanied by
double flashing of direction indica-
tors; boot closing is accompanied by
one flashing.
IMPORTANTIf the boot is opened
with the key when the electronic
alarm is on, the latter will not be
deactivated.If the electronic alarm is on, both
the volumetric protection and the
boot control sensor will be switched
off, and the system will emit (except
for versions of certain markets) two
beeps.
fig. 193
L0A0181b
fig. 194
L0A0179b

229
Boot lock opening/closing by remote control
Central door locking system condition
To open the
boot tailgate
To close
the boot tailgate
Off
Press tailgate button
When the boot is
closed, the lock
remains
unlockedBound to central door locking Not bound to central door locking
On
Press remote control
button
A(fig. 194),
then press the tailgate
button
or keep remote
control button
depressed
(more than 1 second)
When the boot is
closed, the lock
remains unlocked.
To lock the
tailgate lock, press
remote control button
B(fig. 194) On
Press remote control
button
A(fig. 194),
then press the tailgate
button
or keep remote
control button
depressed
(more than 1 second)
When the boot is
closed, the lock
remains unlocked.
To lock the
tailgate lock, press
remote control button
B(fig. 194) Off
Press remote control
button
A(fig. 194),
then press the tailgate
button
or keep remote
control button
depressed
(more than 1 second)
When the boot is
closed, the lock
remains unlocked.
The lock will automat-
ically lock when the
car speed
exceeds 20 km/h
FUNCTIONS THAT CAN BE
MODIFIED BY THE CONNECT
MENU
The CONNECT enables to switch
on/off the following functions:
– locking/unlocking the boot
together with central door
locking/opening– automatic locking of the boot,
door locks and fuel filler cap, when
the car speed exceeds 20 km/h.
To actuate these settings, refer to
the CONNECT supplement provid-
ed with the car.The following tables summarize
the operation logic of the boot lock,
depending on the functions that
have been actuated.

230
Boot lock opening/closing by metal insert of the key
Central door locking system condition
To open the
boot tailgate
To close
the boot tailgate
On
Turn the key clock-
wise in the
lock latch
When the boot is
closed, the lock
remains
unlocked.
To lock the
tailgate lock, turn the
key counterclockwise
in the lock latch Off
Turn the key clock-
wise in the
lock latch
When the boot is
closed, the lock
remains
unlocked.
To lock the
tailgate lock, turn the
key counterclockwise
in the lock latch.
In any case, the lock
will automatically
lock when the car
speed exceeds 20
km/hOn
Turn the key clock-
wise in the
lock latch
When the boot is
closed, the lock
remains
unlocked.
To lock the
tailgate lock, turn the
key counterclockwise
in the lock latch Off
Press the tailgate but-
ton
When the boot is
closed, the lock
remains
unlockedNot bound to central door locking Bound to central door locking

231
CLOSING THE BOOT
To close the bonnet,
lower it down until you lay
it on the lock, without
however slamming it. The lock is
electric and the bonnet will close
automatically. BOOT CEILING LIGHT (fig. 195)
The boot is lit by ceiling light A,
which switches on automatically
when the tailgate is opened.
The light switches off automatical-
ly when the tailgate is closed.
If the tailgate is left open, the ceil-
ing light will switch off after about
20 minutes: to switch it on again,
close and then open again the tail-
gate.LUGGAGE NETS
The boot is equipped with a fixed
net (fig. 196) set on the left side,
and (optional for versions/markets
where applicable) a mobile net.
fig. 195
L0A0180b
fig. 196
L0A0049b