2007 Lancia Musa ECO mode

126
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
POWER WINDOWS
For the 2-button version (only front power
windows) no type of automatism (either opening or
closing) is provided.
For the 4-button version (front and rear power
windows), the driver side is provided with both
opening and closing automatism, whereas the
passenger side is only provided with opening
automatism (where provided also closing
automatism). Rear windows are only provided with
opening automatism.
Power windows with opening and closing (where
provided) automatism are fitted with crush-
prevention seal safety system capable of reversing
the window stroke when an obstacle comes into
contact with glass and seal and therefore capable of
detecting the presence of an obstacle during the
front window closing motion.
IMPORTANT In the event that the anti-crushing
function is activated 5 times in only 1 minute, the
system will automatically enter the “recovery” mode
(self-protection). This conditions is pointed out by
the fact that, in the closing phase, the window goes
up in jerks.
WARNING
The system conforms to Standard 2000/4/CE concerning the safety of passengers
leaning out from the compartment. At the same time, the upper outer gasket is not
equipped with anti-crush protection in order to guarantee protection against
unwanted access from outside the car.So, it is necessary to carry out the system restore
procedure, acting as follows:
❒perform opening control;
or
❒turn the key to STOP and then to MAR.
The logic is restored if no malfunction is present,
the window returns to its normal operation
automatically; otherwise contact a Lancia
Dealership.
IMPORTANT With the ignition key at STOP or
removed, the power windows remain activated for
about 2 minutes and are deactivated immediately
the moment a door is opened.

OPERATION
The gearbox can work in two operating modes:
❒the first mode is manual (MANUAL): the driver directly requests
gearshifting;
❒the second mode is automatic (AUTO): the system directly decides
when shifting gears. With this operating logic it is possible to
activate the ECO (Economy) function to contain consumption by
pressing button E on the gearbox mask.
To shift gears and to select the operating mode (MANUAL or AUTO)
use the gear lever A set on the central console (see figure).
190
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D0332m
L0D0334m

To return to manual mode, set the gear lever back to A/M.
With the car stationary and the key removed, it is possible to shift the
lever with/without the brake pedal pressed. The system will perform
no actuation when shifting the lever and the gear engaged will be the
one stored before removing the ignition key.
IMPORTANT With the engine off and the car stationary, any error
between lever position and gear engaged is indicated by warning light
(è) coming on for a few seconds on the instrument panel together
with the message on the multifunction display.
192
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D0333m

Automatic operation (AUTO - ECO)
The ECO function can be activated only with automatic mode active.
To activate the ECO function press button E set on the mask near the
gearshift lever. After activating this function, the display shows the
gear engaged and words AUTO and E (see figure).
With ECO function active the system will select the most suitable gear
(according to car speed, engine rpm and how the accelerator pedal is
pressed) to save as much fuel as possible.
If necessary (e.g.: overtaking) the system will change gears in order
to provide suitable torque and power for acceleration (this will take
place in automatic mode regardless of ECO function condition, ON or
OFF).
195
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D1244g
L0D0334m

ENGAGED GEAR DISPLAYING
One second after turning the ignition key to MAR, the gear engaged
and the last operating mode adopted (AUTO or MANUAL) will be
displayed on the display:
N = neutral;
1 = first gear;
2 = second gear
3 = third gear;
4 = fourth gear;
5 = fifth gear;
R = reverse.
If the ECO function is on, the display will show E (Economy) next to
the gear engaged.
IMPORTANT If after 10 seconds (with ignition key to MAR) the
display does not show the gear engaged, turn the ignition key to
STOP and wait for the display to turn off, then repeat system switch
on. If the fault persists, contact Lancia Dealership.
196
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D1243g
L0D1244g

211
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
GENERAL WARNINGS
Failure indications shown on the reconfigurable
multifunction display together with buzzer
sounding (adjustable) and warning light (if any)
coming on on the cluster, are accompanied by
specific warning messages (e.g.: “Switch off
engine”, etc...). These indications are concise and
cautionary and are aimed to suggest the prompt
action the driver must adopt when a car
malfunctioning appears. These indications,
however, shall not be considered as exhaustive
and/or as an alternative to the specifications
contained in this “Owner Handbook”, which shall
always be read through carefully and thoroughly. In
case of failure indication always refer to the
specifications contained in this section.
IMPORTANT Failure indications displayed on the
reconfigurable multifunction display are divided
into two categories: very serious failures and
serious/minor failures.
The message and the warning indication
corresponding to very serious failures are displayed
alternately for few seconds. This “cycle” is repeated
indefinitely and it stops any previous indication on
the display. It is displayed every time the ignition
key is turned to MAR, until the cause of
malfunctioning is removed. Should failure disappear, message and warning light
will however stay on for about 2 seconds.
Eliminating the failure, the warning light and the
displayed message will go off. It is possible to stop
this “cycle” by pressing button Q; in this case the
screen active before the failure will be resumed and
the warning light will stay on until eliminating the
failure cause.
The message and the warning indication
corresponding to serious/minor failures are
displayed alternately for few seconds. This “cycle”
is repeated for about 20 seconds and then goes off,
but it comes on again every time the ignition key is
turned to MAR.
Should failure disappear during the 20 seconds
displaying, message and warning light will stay on
for about 2 seconds. Eliminating the failure, the
warning light and the displayed message will go off.
At the end of the display cycle (which lasts approx.
20 seconds), or if button Qis pressed, the screen
active before the failure will be resumed and the
warning light will stay on until eliminating the
failure cause.
Q= Press button “MODE” for less than two seconds
R= Press button “MODE” for over two seconds

1.416V1.48V(◊)1.9 Multijet
litres
–
–
47
5 - 7
6.0
–
–
2.85
3.0
1.98
0.70
0.45
1.5 litres
47
5 - 7
–
–
4.5
2.5
2.7
–
–
1.65
0.70
0.45
1.5 litres
47
5 - 7
–
–
4.5
2.4
2.6
–
–
1.65
–
0.45
1.5kg
–
–
–
–
–
2.2
2.35
–
–
1.5
0.59
–
– kg
–
–
–
–
–
2.1
2.25
–
–
1.5
–
–
–kg
–
–
–
–
–
–
–
2.54
2.65
1.8
0.59
–
–litres
–
–
47
5 - 7
6.5
–
–
4.2
4.4
1.65
–
0.45
1.5kg
–
–
–
–
–
–
–
3.75
3.9
1.5
–
–
–
332
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARDAND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
CAPACITIES
Fuel tank:
including a reserve of:
Fuel tank: including a reserve of:
Engine cooling
system:
Engine sump:
Engine sump and filter:
Engine sump:
Engine sump and filter:
Gearbox/differential casing:
Dual FuNction System
gearbox hydraulic system
Hydraulic brake circuit
Windscreen and rear
window washer fluid reservoir
(◊) Engine model provided for certain versions/markets only1.3 Multijet Specified fuels
Recommended products
Unleaded Premium petrol
with no less than 95 R.O.N
(EN228 Specifications)
Diesel fuel for motor vehicles
(Specification EN590)
Mixture of distilled water
andPARAFLU UPat 50%
SELENIA 20K
SELENIA WR
TUTELA CAR TECHNYX
TUTELA CAR CS SPEED
TUTELA TOP 4
Mixture of water and
TUTELA PROFESSIONAL
SC 35