2007 JEEP WRANGLER belt

WARNING!
Do not use volatile solvents for cleaning purposes.
Many are potentially flammable, and if used in
closed areas they may cause respiratory harm.
Glass Surfaces
All glass surfaces should be cleaned on a regular basis
with MoparGlass Cleaner or any commercial
household-type glass cleaner. Never use an abrasive type
cleaner. Use caution when cleaning inside rear windows
equipped with electric defrosters. Do not use scrapers or
other sharp instruments which may scratch the elements.
When cleaning the rear view mirror, spray cleaner on the
towel or rag that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft tissue.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage will also weaken the fabric.
If the belts need cleaning, use MoparTotal Clean, a mild
soap solution, or lukewarm water. Do not remove the
belts from the vehicle to wash them.
MAINTAINING YOUR VEHICLE 397
7

Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
Appearance Care For Fabric Top Models
CAUTION!
To maintain the appearance of your vehicle’s interior
trim and top, follow these precautions:
•Avoid leaving your vehicle unattended with the top
down, as exposure to sun or rain may damage interior
trim.
•Do not use harsh cleaners or bleaching agents on top
material, as damage may result.
•Do not allow any vinyl cleaner to run down and dry
on the paint, leaving a streak.
•After cleaning your vehicle’s fabric top, always make
sure it is completely dry before lowering.
•Be especially careful when washing the windows by
following the directions for “Care of Fabric Top Win-
dows.”
WASHING —Use MoparCar Wash or mild soap suds,
lukewarm water, and a brush with soft bristles. If extra
cleaning is required, use MoparConvertible Cloth Top
Cleaner or a mild foaming cleaner on the entire top, but
support top from underneath.
RINSING —Be sure to remove all trace of cleaner by
rinsing the top thoroughly with clean water. Remember
to allow the top to dry before lowering it.
398 MAINTAINING YOUR VEHICLE

Miles 33,000 36,000 39,000 42,000 45,000
(Kilometers) (55 000) (60 000) (65 000) (70 000) (75 000)
Change the engine oil and engine oil filter, if not
replaced at 3 months.X X XXX
Rotate the tires. X X
Inspect the engine air filter element, replace if
necessary.X
Inspect the brake linings. X
Drain and refill the front and rear axle fluid. X
Inspect the transfer case fluid, add if necessary. X
Inspect the drive belt, and replace as needed. X
Clean and lubricate soft top zippers (if equipped). X X X X X
422 SCHEDULE “B”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 48,000 51,000 54,000 57,000 60,000
(Kilometers) (80 000) (85 000) (90 000) (95 000) (100 000)
Drain and refill the automatic transmission fluid.
Replace main sump filter and spin-on cooler return
filter (if equipped).‡X
Inspect the drive belt, and replace as needed. Not
required if belt was previously.X
Drain and refill the transfer case fluid. X
Flush and replace the engine coolant/anti-freeze. X
Clean and lubricate soft top zippers (if equipped). X X X X X
424 SCHEDULE “B”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 63,000 66,000 69,000 72,000 75,000
(Kilometers) (105 000) (110 000) (115 000) (120 000) (125 000)
Change the engine oil and engine oil filter, if not
replaced at 3 months.X X XXX
Rotate the tires. X X
Inspect the engine air filter element, replace if
necessary.X
Inspect the brake linings. X
Inspect the transfer case fluid, add if necessary. X
Drain and refill the front and rear axle fluid. X
Inspect the drive belt, and replace as needed. Not
required if belt was previously replaced.X
Clean and lubricate soft top zippers (if equipped). X X X X X
SCHEDULE “B” 425
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 78,000 81,000 84,000 87,000 90,000
(Kilometers) (130 000) (135 000) (140 000) (145 000) (150 000)
Change the engine oil and engine oil filter, if not
replaced at 3 months.X X XXX
Rotate the tires. X X X
Inspect the engine air filter element, replace if
necessary.X
Inspect the PCV Valve, and replace if necessary.X
Inspect the brake linings. X
Drain and refill the front and rear axle fluid. X
Inspect the drive belt, and replace as needed. Not
required if belt was previously replaced.X
Inspect the manual transmission fluid, add as nec-
essary.X
Inspect the transfer case fluid, add if necessary. X
Clean and lubricate soft top zippers (if equipped). X X X X X
426 SCHEDULE “B”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 93,000 96,000 99,000 102,000 105,000
(Kilometers) (155 000) (160 000) (165 000) (170 000) (175 000)
Change the engine oil and engine oil filter, if not replaced at
3 months.XXXXX
Rotate the tires. X X
Inspect the engine air filter element, replace if necessary.X
Replace the spark plugs.X
Replace the ignition cables.X
Inspect the brake linings. X
Change the brake fluid. If vehicle is used for trailer towing. X
Drain and refill the front and rear axle fluid. X
Inspect the transfer case fluid, add if necessary. X
Inspect the drive belt, and replace as needed. Not required if
belt was previously replaced.X
Flush and replace the engine coolant/anti-freeze, if not done
at 60,000 miles (100 000 km).X
Clean and lubricate soft top zippers (if equipped). X X X X X
SCHEDULE “B” 427
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 108,000 111,000 114,000 117,000 120,000
(Kilometers) (180 000) (185 000) (190 000) (195 000) (200 000)
Change the engine oil and engine oil filter, if not replaced at
3 months.XXXXX
Rotate the tires. X X X
Inspect the engine air filter element, replace if necessary.X
Inspect the PCV Valve, and replace if necessary.X
Inspect the brake linings. X X
Drain and refill the front and rear axle fluid. X
Inspect the manual transmission fluid, add as necessary. X
Drain and refill the automatic transmission fluid. Replace main
sump filter and spin-on cooler return filter (if equipped).‡X
Inspect the drive belt, and replace as needed. Not required if
belt was previously replaced.X
Drain and refill the transfer case fluid. X
Flush and replace the engine coolant/anti-freeze, if not re-
placed at 102,000 miles (170 000 km).X
Clean and lubricate soft top zippers (if equipped). X X X X X
428 SCHEDULE “B”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S