6
OWNER MAINTENANCE
35
Specifications: "H" Horizontal centre line of headlights from ground. : 26.5 in.(675 mm) "W" Distance between each headlight cen-tre. : 46.3 in. (1,177 mm) "L" Distance between the headlights andthe wall that the lights are tested against. : 118 in. (3,000 mm).
G290B02FC-EAT
Adjustment After Headlight As- sembly Replacement If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using the aiming screenas shown in the illustration. Turn on the headlight switch. (Low Beam Posi- tion)
1. Adjust headlights so that main axis of light is parallel to the centre lineof the body and is aligned with point "P" shown in the illustration.
2. Dotted lines in the illustration show the centre of the headlights. G290B01L-D
L
W
H
H Cut-off line
"P"
30mm (1.18 in.)
Vertical lineHorizontal line
Ground line
REPLACING LIGHT BULBS
SG250A2-E In the event of bulb failure being expe- rienced, ensure that the relative light- ing circuit is turned off prior to attempt-ing to replace the bulb. The illustra- tions on the following page will assist in locating and removing the variousbulbs. Ensure that the replacement bulb has the same cap configuration and wattage as the original. See page 6-37 for the wattage descriptions.
! CAUTION:
Keep the lamps out of contact with
petroleum products, such as oil, petrol, etc.
fcuk-6.p65 12/27/2006, 10:16 AM
35
