Page 82 of 480

Restraint System Check
Checking the Restraint Systems
Now and then, make sure the safety belt reminder
light and all your belts, buckles, latch plates,
retractors and anchorages are working properly.
Look for any other loose or damaged safety
belt system parts. If you see anything that might
keep a safety belt system from doing its job, have
it repaired. SeeCare of Safety Belts on page 409
for more information.
Torn or frayed safety belts may not protect you in
a crash. They can rip apart under impact forces.
If a belt is torn or frayed, get a new one right away.
Also look for any opened or broken airbag
covers, and have them repaired or replaced. The
airbag system does not need regular maintenance.Notice:If you damage the covering for the
driver’s or the right front passenger’s airbag,
or the side impact airbag covering (if equipped)
on the ceiling near the side windows, the airbag
may not work properly. You may have to replace
the airbag module in the steering wheel, both
the airbag module and the instrument panel
for the right front passenger’s airbag, or side
impact airbag module and ceiling covering for
roof-mounted side impact airbags (if equipped.)
Do not open or break the airbag coverings.
82
Page 85 of 480

Keys.............................................................. 87
Remote Keyless Entry (RKE) System.......... 88
Remote Keyless Entry (RKE)
System Operation.................................... 89
Doors and Locks.......................................... 92
Door Locks................................................. 92
Power Door Locks....................................... 93
Programmable Automatic Door Locks.......... 94
Lockout Protection....................................... 94
Swing-gate.................................................. 95
Windows....................................................... 96
Power Windows.......................................... 97
Sun Visors.................................................. 97
Theft-Deterrent Systems............................... 98
Content Theft-Deterrent............................... 98
Passlock
®.................................................. 100Starting and Operating Your Vehicle......... 101
New Vehicle Break-In................................ 101
Ignition Positions....................................... 101
Retained Accessory Power (RAP)............. 103
Starting the Engine.................................... 103
Engine Coolant Heater.............................. 105
Automatic Transmission Operation............. 106
Manual Transmission Operation................. 109
Full-Time Four-Wheel Drive....................... 111
Parking Brake........................................... 116
Shifting Into Park (P)
(Automatic Transmission)....................... 117
Shifting Out of Park (P)
(Automatic Transmission)....................... 119
Parking Your Vehicle
(Manual Transmission)........................... 119
Parking Over Things That Burn................. 119
Engine Exhaust......................................... 120
Running the Engine While Parked............. 121
Section 2 Features and Controls
85
Page 87 of 480
Keys
{CAUTION:
Leaving children in a vehicle with the
ignition key is dangerous for many
reasons. They could operate the power
windows or other controls or even make
the vehicle move. The children or others
could be badly injured or even killed.
Do not leave the keys in a vehicle with
children.
87
Page 96 of 480
Windows
{CAUTION:
Leaving children, helpless adults, or pets
in a vehicle with the windows closed is
dangerous. They can be overcome by the
extreme heat and suffer permanent
injuries or even death from heat stroke.
Never leave a child, a helpless adult, or a
pet alone in a vehicle, especially with the
windows closed in warm or hot weather.
96
Page 97 of 480

Power Windows
The power window controls are located on the
armrest of each door.
The driver’s door has switches for the passenger
windows as well. Your power windows will work
when the ignition is in ACC (Accessory) or ON, or
when Retained Accessory Power (RAP) is active.
SeeRetained Accessory Power (RAP) on page 103.
Pull up the front edge of the control to raise the
window.
Press the front edge of the control down to lower
the window.
Express-Down Window
The driver’s window has an express-down feature
that allows you to lower the window without
holding the switch. Press the front edge of the
switch past the rst position to activate the
express-down mode. The express-down mode can
be canceled at any time by pulling up on the
switch. To open the window partway, press the
front of the switch to the rst position until
the window is at the desired level.
Window Lockout
o
(Window Lockout):The window lockout
button is located forward of the window switches.
This feature disables the passenger’s window
switches when the button is pressed. Press the
button again to turn the lockout off. A red band on
the side of the button can be seen when the
windows are not locked out.
Sun Visors
To block glare, pull the visor down. It can also be
detached from the center mount and moved to
the side to block glare from that direction.
There are extenders that can be pulled out for
further coverage.
97
Page 103 of 480

The battery could be drained if you leave the key
in the ignition while your vehicle is parked.
You may not be able to start your vehicle after it
has been parked for an extended period of time.
Retained Accessory Power (RAP)
Your vehicle has Retained Accessory Power (RAP)
which allows certain features of your vehicle to
continue working for up to 20 minutes after
the ignition key is turned to LOCK.
The radio, front wipers, power windows, and a
sunroof if your vehicle has one, will work when the
ignition key is in ON or ACC. Once the key is turned
from ON to LOCK, these features continue working
for up to 20 minutes or until a door is opened.
Starting the Engine
Place the transmission in the proper gear.
Automatic Transmission
Move your shift lever to PARK (P) or
NEUTRAL (N). Your engine will not start in
any other position -- this is a safety feature.
To restart when you are already moving, use
NEUTRAL (N) only.
Notice:Do not try to shift to PARK (P) if your
vehicle is moving. If you do, you could
damage the transmission. Shift to PARK (P)
only when your vehicle is stopped.
Manual Transmission
The shift lever should be in the NEUTRAL position
and the parking brake engaged. Hold the clutch
pedal to the oor and start the engine. Your
vehicle will not start if the clutch pedal is not all
the way down. That is a safety feature.
Starting Procedure
1. With your foot off the accelerator pedal, turn
the ignition key to START. When the engine
starts, let go of the key. The idle speed will go
down as the engine gets warm. Do not race the
engine immediately after starting it. Operate
the engine and transmission gently to allow the
oil to warm up and lubricate all moving parts.
103
Page 120 of 480
Engine Exhaust
{CAUTION:
Engine exhaust can kill. It contains the
gas carbon monoxide (CO), which you
cannot see or smell. It can cause
unconsciousness and death.
You might have exhaust coming in if:
Your exhaust system sounds strange
or different.
Your vehicle gets rusty underneath.
Your vehicle was damaged in a
collision.
CAUTION: (Continued)
CAUTION: (Continued)
Your vehicle was damaged when
driving over high points on the road
or over road debris.
Repairs were not done correctly.
Your vehicle or exhaust system has
been modi ed improperly.
If you ever suspect exhaust is coming into
your vehicle:
Drive it only with all the windows
down to blow out any CO; and
Have your vehicle xed immediately.
120
Page 123 of 480

Automatic Dimming Mirror Operation
The automatic dimming mirror function is turned on
automatically each time the ignition is started.
To operate the automatic dimming mirror, do the
following:
1. Make sure the green indicator light, located to
the left of the on/off button, is lit. If it is not,
press and hold the on/off button for
approximately six seconds until the green light
comes on, indicating that the mirror is in
automatic dimming mode.
2. Turn off the automatic dimming mirror function
by pressing and holding the on/off button for
approximately six seconds, until the green
indicator light turns off.
Compass Calibration
The compass may need calibration if one of the
following occurs:
After approximately ve seconds, the display
does not show a compass heading, N for
North, for example, there may be a strong
magnetic eld interfering with the compass.
Such interference may be caused by a
magnetic antenna mount, magnetic note pad
holder, or a similar magnetic item.
The compass does not display the correct
heading and the compass zone variance
is set correctly.
In order to calibrate, CAL must be displayed in the
mirror compass windows. If CAL is not displayed,
push the on/off button for approximately
12 seconds or until CAL is displayed.
The compass can be calibrated by driving the
vehicle in circles at 5 mph (8 km/h) or less until the
display reads a direction.
123