2007 HONDA FIT headlights

µµµ
µ
µ
µ
Ì Engine
oil level Check every
time you fill the fuel tank. See
page .
Engine coolant level Check the
radiator reserve tank every time
you fill the fuel tank. See page .
Automatic transmission Check
the fluid level monthly. See page
.
Brakes Check the fluid level
monthly. See page .
Tires Check the tire pressure
monthly. Examine the tread for
wear and foreign objects. See page
.
Lights Check the operation of
the headlights, parking lights,
taillights, high-mount brake light,
and licen se plate lights monthly.
See page .
Youshouldcheckthefollowing
items
at the specified interval s. If
you are unsure of how to perf orm
any check, turn to the appropriate
page listed. U.S. Vehicles:
According to state and federal
regulations, f ailure to perf orm
maintenance on the items marked
with will not void your emissions
warranties. However, all
maintenance services should be
perf ormed in accordance with the
intervals indicated by the
inf ormation display.
However, service at a dealer is not
mandatory to keep your warranties
in effect. Maintenance may be done
by any qualif ied service f acility or
person who is skilled in this type of
automotive service. Make sure to
have the service f acility or person
reset the display as previously
described. Keep all receipts as proof
of completion, and have the person
who does the work fill out the
maintenance record. Check your
warranty booklet f or more
inf ormation.
We recommend using Honda parts
and fluids whenever you have
maintenance done. These are
manuf actured to the same high-
quality standards as the original
components, so you can be conf ident
of their perf ormance and durability. 135
136
183 185
199
186
Maintenance Minder
Owner’s Maintenance Checks Maintenance,
replacement, or repair of
emissions control devices and
systems may be done by any
automotive repair establishment
or individual using parts that are
‘‘certif ied’’ to EPA standards.
172

Your vehicle has halogen headlight
bulbs. When replacing a bulb, handle
it by its base, and protect the glass
f rom contact with your skin or hard
objects. If you touch the glass, clean
it with denatured alcohol and a clean
cloth.To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
lef t.
Use a f lat-tip screwdriver to
remove the holding clip f rom the
inner f ender, then pull the inner
f ender cover back.
Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
cargo area, readjustment may be
required. Adjustments should be
done by your dealer or other
qualif ied mechanic.
1.
2.
Headlight A iming Replacing a Headlight Bulb
Lights
186
HOLDING CLIP
Halogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.

Remove the electrical connector
f rom the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.Make sure that the hold-down
wire is installed properly and
securely. You can check its
installation f rom the inspection
window on the headlight assembly. Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.Install the rubber seal over the
back of the headlight assembly.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
Reinstall the inner f ender cover.
Then reinstall the holding clip, and
lock it in place by pushing on its
center.
Unclip the end of the hold-down
wire f rom its slot. Pivot the wire
out of the way, then remove the
bulb.
5. 6.
3.
4. 7.8.
9.
10.
Lights
Maint enance
187
RUBBER WEATHER SEAL
HOLD-DOWN
WIRE BULB
ELECTRICAL
CONNECTOR
HOLD-DOWN
WIRE
INSPECTION WINDOW

When you turn the ignition switch to
the START (III) position, you do not
hear the normal noise of the engine
trying to start. You may hear a
clicking sound or series of clicks, or
nothing at all.
Check these things:
Check the transmission interlock.
If you have a manual transmission,
the clutch pedal must be pushed
all the way to the floor or the
starter will not operate. With an
au tomatic transmission, it must be
in Park or neutral.
Turn the ignition switch to the ON
(II) position. Turn on the
headlights, and check their
brightness. If the headlights are
very dim or do not come on at all,
the battery is discharged. See on page .
You can hear the starter motor
operating normally, or the starter
motor sounds like it is spinning
f aster than normal, but the engine
does not start up and run. You hear nothing, or almost
nothing. The engine’s starter
motor does not operate at all, or
operates very slowly.
Diagnosing why the engine won’t
start f alls into two areas, depending
on what you hear when you turn the
ignition switch to the START (III)
position:
Make sure the wire support ring is
ontheoutersideof thetirevalve
as shown.
3.
214
Changing a Flat Tire, If the Engine Won’t Start
Nothing Happens or the Starter
Motor Operates Very Slowly
Jump Starting
If the Engine Won’t Start
212
WIRE SUPPORT RING

Turn the ignition switch to the
START (III) position. If the
headlights do not dim, check the
condition of the fuses. If the fuses
areOK,thereisprobably
something wrong with the
electrical circuit for the ignition
switch or starter motor. You will
need a qualified technician to
determine the problem. See
on page .
If the headlights dim noticeably or
go out when you try to start the
engine, either the battery is
discharged or the connections are
co rroded. Check the condition of the
battery and terminal connections
(see page ). You can then try
jump starting the vehicle from a
booster battery (see page ). In
this case, the starter motor’s
speed sounds normal, or even faster
than normal, when you turn the
ignition switch to the START (III)
position, but the engine does not run.
Are you using the proper starting
procedure? Refer to
on page .
Are
you using a properly coded
key? An improperly coded key will
cause the immobilizer system
indicator in the instrument panel
to blink rapidly (see page ). Do
you have fuel? Check the fuel
gauge; the low fuel indicator may
not be working.
There may be an electrical
problem, such as no power to the
fuel pump. Check all the fuses
(see page ).
Ifyoufindnothingwrong,youwill
need a qualified technician to find
the problem. See
on page .
226
203 214 76
148 221
226
If theEngineWon’tStart
Emergency T owing T he Starter Operates Normally
Starting the
Engine Emergency
Towing
T aking Care of t he Unexpect ed
213

If something electrical in your
vehicle stops working, check for a
blown fuse first. Determine from the
chart on pages and , or the
diagram on the f use box lid, which
f use or f uses control that device.
Check those f uses f irst, but check all
the f uses bef ore deciding that a
blown f use is the cause. Replace any
blown f uses, and check if the device
works.
Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are of f .
Remove the cover f rom the f use
box. Check each of the large f uses in
the under-hood f use boxes by
looking through the top at the wire
inside. Removing these f uses
requires a Phillips-head
screwdriver.
Check the smaller f uses in the
primary under-hood f use box and
all the f uses in the interior f use
box by pulling out each one with
the f use puller provided in the
interior f use box.
3.
1.
2. 4.
224 225
Fuses
Checking and Replacing Fuses
222
FUSE
BLOWN FUSE PULLER

µµµ
Î
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î Î
Î Î
Specifications
T
echnical Inf ormat ion
233
Air Conditioning
Battery Lights Fuses
Tires Alignment
HFC-134a
(R-134a)
14.1 15.9 oz (400 450 g)
SP-10
12 V
12 V 60/55
W
21 W
12 V
12
V
12
V
12
V
12
V
12
V
12
V
12
V
12
V
21 W
5W
Refrigerant
type
Charge quantity
Lubricant type
Capacity 12
V
Headlights
Front
turn signal lights
Parking lights/side marker
lights
Fog lights
Rear turn signal lights
Stop/Taillights
Back-up lights
License plate lights
Ceiling light
Cargo area Light
Taillights
High-mount brake light 8W 3CP
21
W
21/5
W
21
W
5W
55
W
3CP See
page 224 or the fuse label
attached to the back of the driver’s
coin tray.
Interior
Under-hood
0.0in(0mm)
0.10 in (2.5 mm)
0°
1°30’
3°45’
Size
Pr essure P175/65R14
81S
P195/55R15 84H
T115/70D14 88M
T125/70D14 93M
32 psi (220 kPa , 2.2 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm)
60 psi (420 kPa , 4.2 kgf/cm)
Toe-in
Camber
Caster
See page225or the fuse box
cover.
12 V 40 AH/20 HR 34 AH/5 HR
12 V 12 V 32 AH/5 HR Front
Rear
Front
Rear
Front
High/Low
(Amber)
1:
2:
(HB2)
(Amber) (H11)
Front/Rear
Spare
Front
Rear
Spare
All models except Sport
Sport model
(Amber)
1 2
2 1

CONT INUED
....................................
Accessories . 138
ACCESSORY (Ignition Key .......................................
Position) .77
...............
Accessory Power Socket . 98
....................
Additives, Engine Oil . 177
.......
Adjusting the Steering Wheel . 74
...........................
Advanced Airbags .27
...............................
Airbag (SRS) . 9, 22
..............
Air Conditioning System . 100
.........................................
Usage .101
.......................
Air Pressure, Tires .198
.......................
Alcohol in Gasoline .132
......................................
Antif reeze .180
Anti-lock Brakes (ABS) ...............................
Indicator . 62, 162
...................................
Operation .162
..............
Anti-thef t, Audio System . 124
.
Anti-thef t Steering Column Lock . 77
................................
Audio System .105
...
Automatic Seat Belt Tensioners . 20
.............
Automatic Speed Control . 127
..............
Automatic Transmission . 151
..........................
Capacity, Fluid .232
...............
Checking Fluid Level . 183..........................
Paddle Shif ters .156
.......................................
Shif ting .151
Shif t Lever Position ...............................
Indicators .151
................
Shif t Lever Positions . 152
....................
Shif t Lock Release . 155
............................
Capacities Chart .232
.............
Carbon Monoxide Hazard . 53
..............................................
Cargo .140
Battery
Charging System ...........................
Indicator . 60, 218
............................
Jump Starting .214
..............................
Maintenance .203
............................
Specif ications .233
..............................
Bef ore Driving .131
....................................
Belts,Seat .8 , 18
...........................
Beverage Holders . 97
..................................
Booster Seats . 50
Brakes ...........
Anti-lock System (ABS) . 162
.............
Break-in, New Linings . 132
....................
Bulb Replacement .190
...........................................
Fluid .185
.........................................
Parking . 95
.................
System Indicator . 60, 220 ..........................
System Design .161
........................
Wear Indicators .161
.............................
Braking System .161
.................
Break-in, New Vehicle . 132
..
Brightness Control, Instruments . 73
..................
Brights, Headlights . 71,72
Bulb Replacement ..........................
Back-up Lights .190
..............................
Brake Lights .190
Front Parking Lights/ ...
Front Side Marker Lights . 188
.................................
Fog Lights .189
.................................
Headlights .186
.........
High-mount Brake Light . 191
............................
Specif ications .233
....................................
Taillights .190
.............
Turn Signal Lights . 188,190
..............................
Bulbs, Halogen .186
Index
A
B
C
INDEX
I