2007 HONDA ACCORD SEDAN maintenance reset

This indicator comes on for a few
seconds when you turn the ignition
switch to the ON (II) position. It will
gooffifyouhaveinserteda
properly-coded ignition key. If it is
not a properly-coded key, the
indicator will blink and the engine
will not start (see page ).
This indicator also blinks several
times when you turn the ignition
switch from the ON (II) position to
the ACCESSORY (I) or LOCK (0)
position.
This indicator comes on when the
washer fluid level is low. Add washer
fluidwhenyouseethisindicator
come on (see page ).
This
indicator comes on when you
turn on the cruise control master
button (see page ).
This indicator comes on when you
set the cruise control. See page
for information on operating the
cruise control. This
indicator comes on for a few
seconds when you turn the ignition
switch to the ON (II) position. It
remindsyouthatitistimetotake
your vehicle in for scheduled
maintenance. The maintenance main
items and sub items will be displayed
in the information display. See page
f or more inf ormation on the
maintenance minder.
This indicator goes of f when your
dealer resets it after completing the
required maintenance service. 75
145 193
145
210
Canadian models only
Immobilizer System
Indicator
Cruise Control Main
Indicator Maintenance Minder
Indicator
Washer Level Indicator
Cruise Control Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
63

This shows how much fuel you have.
It may show slightly more or less
th an the actual amount. The needle
returns to the bottom after you turn
off the ignition. The
information display in the
instrument panel shows you the
engine oil life and maintenance
service items when the ignition
switch is in the ON (II) position. This
information helps to keep you aware
of the periodic maintenance your
vehicle needs for continued trouble-
free driving. Refer to page for
more information.
If
your fuel cap is loose or missing, a
‘‘CHECK FUEL CAP’’ message will
appear in the information display. As
soon as it is safely possible, turn the
engine off and check that the fuel
cap is installed. If it is, loosen the cap
and tighten it to at least 1 click.
Al though you can use the select/
resetknobtocyclethefuelcap
warningo ffofthedisplay,itwillbe
displayedagai neachtimetheengine
isstarted.Itwillta keseveraldaysof
normaldrivingforthevehicletotu rn
thewarningoff.
Ifthevehicleonboarddiagnostic
systemcontinue stodetecta
problem,the mal function indicator
lamp(MIL)willilluminate.Ifthe
MILdoesnotgo off, have your
de aler inspect the vehicle. For more
info rmation, see page . 193
254
Fuel Gauge
Check Fuel Cap IndicatorMaintenance Minder Display
Gauges
66
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.

CONTINUED
Your vehicle displays engine oil life
and maintenance service items on
the information display to show you
when you should have your dealer do
engine oil replacement and indicated
maintenance service.
Based on the engine operating
conditions and accumulated engine
revolutions, the onboard computer in
your vehicle calculates the remaining
engine oil life and displays it as a
percentage.
To see the current engine oil life,
turn the ignition switch to the ON
(II) position, and push and release
th e select/reset knob repeatedly
until the engine oil lif e display
appears (see page ). The remaining engine oil lif e is
shownonthedisplayaccordingto
this table:
64
Maintenance Minder
Engine Oil L if e Indicator
Maint enance
193
SELECT/RESET KNOB
ENGINE OIL LIFE INDICATOR
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ µ
µ
Calculated Engine
Oil Lif e (%)
100 % 91 % 90 % 81 %
80 % 71 %
70 % 61 %
60 % 51 %
50 % 41 %
40 % 31 %
30 % 21 %
20 % 16 %
15 % 11 %10 % 6 % 5% 1% 0% Displayed
Engine Oil Lif e (%) 100 %90 %
80 %
70 %
60 %
50 %
40 %
30 %
20 %
15 %
10 %5%
0%

If the rem aining engine oil life is 15
to 6 percent, you will see the engine
oil life indicator every time you turn
the ignition switch to the ON (II)
position. The maintenance minder
indicator will also come on, and the
maintenance item code(s) for other
scheduled maintenance items
needing service will be displayed
next to the engine oil life indicato r.When
the rem aining engine oil life is
5 to 1 percent, you will see a
‘‘SERVICE’’ message along with the
same maintenance item code(s),
everytimeyouturntheignition
switch to the ON (II) position. The
maintenance item code or codes
indicate the main and sub items
required at the time of the oil change
(see page ).
You can switch the information
display f rom the engine oil lif e
display to the odometer or the trip
meter. Press and release the Select/
Reset knob on the instrument panel.
When the engine oil lif e is 15 to 1
percent, the maintenance minder
indicator ( ) comes on every
time you turn the ignition switch to
the ON (II) position, then it goes out
if you switch the inf ormation display.
When you see this message, have
the indicated maintenance
perf ormed by your dealer as soon as
possible. 199
Maintenance Minder
194
MAINTENANCE ITEM CODE(S)
ENGINE OIL LIFE INDICATOR
MAINTENANCE MINDER INDICATOR

The maximum total mileage shown
is ‘‘ 9999.’’
When the remaining engine oil lif e is
0 percent, the engine oil lif e indicator
will blink. The display comes on
everytimeyouturntheignition
switch to the ON (II) position. The
maintenance minder indicator
( ) also comes on and remains
on in the instrument panel. When
you see this message, immediately
have the indicated maintenance
perf ormed by your dealer. If you do not perf orm the indicated
maintenance, negative mileage is
displayed and begins to blink af ter
the vehicle has been driven 10 miles
(10 km) or more.
Negative mileage means your
vehicle has passed the maintenance
required point.
Immediately have the indicated
maintenancedonebyyourdealer.To change the inf ormation display
f rom the engine oil lif e display to the
odometer or the trip meter, press
and release the Select/Reset knob.
When the engine oil lif e is 0 percent
or negative mileage, the
maintenance minder indicator
( )remainsonevenif you
change the inf ormation display.
Immediately have the service
perf ormed, and make sure to reset
the display as described on the next
page.
Maintenance Minder
Maint enance
195
NEGATIVE MILEAGE
µ

Turn the ignition switch to the ON
(II) position.
If
maintenance service is done by
someone other than your dealer,
reset the maintenance minder as
follows:
Presstheselect/resetknobuntil
theengineoillifeindicato ris
displayed.
Allmaintenanceitemsdisplayedin
th
einformationdisplayareincode.
Foranexplanationofthese
maintenancecodes,seepage. Yourdealerwillresetthedisplay
aftercompletingtherequired
maintenanceservi
ce.Youwillsee
‚‚ OILLI FE100%™ ™ontheinformation
displaythenexttimeyouturnthe
ignitionswitchtotheON(II)
position.
Pressthe select/resetknobfor
about10seconds.Theengineoil
lifeandthemaintenanceitem
code(s)willblink.
3.
1.
2.
199 Resetting the Engine Oil Lif e
Indicator
Maintenance Main Items and Sub
Items
Maintenance Minder
196
ENGINE OIL LIFE
INDICATOR
MAINTENANCE MAIN ITEM
MAINTENANCE SUB ITEM(S)

If you have the required service
done but do not reset the display, or
reset the display without doing the
service, the system will not show the
proper maintenance intervals. This
canleadtoseriousmechanical
problems because you will no longer
have an accurate record of when
maintenance is needed.
Your authorized Honda dealer
knows your vehicle best and can
provide competent, ef f icient service.However, service at a dealer is not
mandatory to keep your warranties
in effect. Maintenance may be done
by any qualif ied service f acility or
person who is skilled in this type of
automotive service. Make sure to
have the service f acility or person
reset the display as previously
described. Keep all receipts as proof
of completion, and have the person
who does the work fill out the
maintenance record. Check your
warranty booklet f or more
inf ormation.
We recommend the use of Honda
parts and f luids whenever you have
maintenance done. These are
manuf actured to the same high-
quality standards as the original
components, so you can be conf ident
of their performance and durability.
Press the select/reset knob
f or
another 5 seconds. The
maintenance item code(s) will
disappear, and the engine oil lif e
will reset to ‘‘100.’’
4.
CONT INUED
Important Maintenance
Precautions
Maintenance Minder
Maint enance
197

Check the condition of the battery
monthlybylookingatthetest
indicator window. The label on the
battery explains the test indicato r’s
colors. Check
the terminals for corrosion (a
white or yellowish powder). To
remove it, cover the terminals with a
solution of baking soda and water. It
will bubble up and turn brown. When
this stops, wash it off with plain
water. Dry off the battery with a
cloth or paper towel. Coat the
terminals with grease to help prevent
future corrosion. Battery
posts,
terminals, and related accessories
contain lead and lead compounds.
If you need to connect the battery to
a charger, disconnect both cables to
prevent damaging your vehic le’s
electrical system. Always disconnect
the negative ( ) cable first, and
reconnect it last.
If
additional battery maintenance is
needed, see your dealer or a
qualified mechanic.
If your vehicle’s battery is
disconnected, or goes dead, the time
setting is lost. To reset the time, see
page . 143
CONT INUED
WARNING:
Wash your hands af ter handling.
Checking the Battery
Maint enance
235
TEST INDICATOR WINDOW
4-cylinder models TEST INDICATOR WINDOW
V6 models
µ