2007 HONDA ACCORD COUPE window

µ
µ µ
µ
You can also open both power
windows from outside the vehicle
with the remote transmitter (see
page ).
Press this button once
to unlock the driver’s door. Push it
twice to unlock the passenger’s door.
Some exterior lights will f lash twice
each time you push the button.
The ceiling light (if the ceiling light
switch is in the door activated
position) will come on when you
press the UNLOCK button. If you do
not open either door within 30
seconds, the lights f ade out. If you
relock the doors with the remote
transmitter before 30 seconds have
elapsed, the lights will go of f
immediately.
Press this button once to
lock both doors. Some exterior lights
will f lash once.
When you push the LOCK button
twice within 5 seconds, the lights will
flash and the horn will beep to verify
that the doors are locked and that
the security system has set. The
LOCK button will not work this way
if either door is not f ully closed.
When the key is in the ignition
switch, the f unctions of each button
are disabled.
Press this
button f or about 1 second to open
the trunk.
Press and hold this
button for about 2 seconds to attract
attention: the horn will sound and
the exterior lights will f lash f or about
30 seconds. To cancel panic mode,
press any other button on the remote
transmitter, or turn the ignition
switch to the ON (II) position.
If you do not open either door within
30 seconds, the doors automatically
relock and the security system sets. 92
UNL OCK
LOCK T RUNK REL EA SE
PA NIC
Remote Transmitter
78
UNLOCK
BUTTON
LOCK
BUTTON
TRUNK
RELEASE
BUTTON
PANIC
BUTTON
——y

y
(#yy

µ
CONT INUED
Turn the ignition switch to the ON
(II) position to raise or lower either
window. To open the window, push
the switch down and hold it. Release
the switch when you want the
window to stop. Pull back on the
switchandholdittoclosethe
window.
Thewindowsoperateforupto10
minutes after you turn off the
ignition switch. Opening either door
cancels this f unction.If the MAIN switch is off, the
passenger’s windows cannot be
raised or lowered. Keep the MAIN
switch of f when you have children in
the vehicle so they do not injure
themselves by operating the
windows unintentionally. To open or close the
driver’s window, push or pull the
window switch firmly down or up to
the second detent, and release it.
The window will automatically go
down or up all the way. To stop the
window, pull or push the window
switch brief ly.
Power Windows
AUTO
Inst rument s and Cont rols
91
MAIN SWITCH
DRIVER’S WINDOW SWITCH
Closing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.
——y

y
(#yy

µPress the UNLOCK button once
to unlock the driver’s door.
Press the UNLOCK button a
second time, and hold it. The
passenger’s door unlocks, and
both windows start to open. To
stop the windows, release the
button.
You can open both windows f rom the
outside with the remote transmitter.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it. To open the windows f urther,
press the button again (within 10
seconds).
You cannot close the windows with
the remote transmitter.
If the driver’s
window senses any obstacle while it
is closing automatically, it will
reverse direction, and then stop. To
close the window, remove the
obstacle, then use the window switch
again. If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window f use is removed, the
AUTO f unction may be disabled. If
the AUTO f unction is disabled, the
power window system will need to be
reset af ter reconnecting the battery
or installing the f use.
If the power windows do not operate
properly af ter resetting, have your
vehicle checked by your dealer.Start the engine. Push down and
hold the driver’s window switch
until the window is f ully open.
Pull and hold the driver’s window
switch to close the window
completely, then hold the switch
f or about 2 seconds.
1. 2. 1. 2. 3.
Power Windows
Opening the Windows with the
Remote Transmitter
AUTO REVERSE
92
——y
y
(#yy

You can open and close the windows
with the key in the driver’s door lock.Insert the key in the driver’s door
lock.
Turn the key counterclockwise,
then release it.
Turn the key counterclockwise
again, and hold it. Both windows
starttoclose.Tostopthewindows,
release the key.
To close the windows f urther, turn
andholdthekeyagain(within
10 seconds).
NOTE: If the windows stop bef ore
the desired position, repeat steps 2
and 3.
Insert the key in the driver’s door
lock.
Turn the key clockwise, then
release it.
Turnthekeyclockwiseagain,and
hold it. Both windows start to open.
To stop the windows, release thekey.
To open the windows f urther, turn
andholdthekeyagain(within
10 seconds).
NOTE: If the windows stop bef ore
the desired position, repeat steps 2
and 3.
To open: To close:
1. 2.3.
4.
3.
4.
1.2.
Opening/Closing the Windows
with the Key
Power Windows
Inst rument s and Cont rols
93
Open
Close
UNLOCK BUTTON
——y
y
(#yy

In this position, the sun visor can be
adjusted by moving it on its slider.
Make sure you put the sun visor
back in place when you are getting
into or out of the vehicle.Pull up the vanity mirror cover to use
it. The lights beside the mirror come
on when you pull up the cover.
These sockets are intended to supply
power f or 12 volt DC accessories
that are rated 120 watts or less (10
amps).
To use an accessory power socket,
the ignition switch must be in the
ACCESSORY (I) or ON (II) position.
None of the sockets will power an
automotive type cigarette lighter
element. When both sockets are
being used, the combined power
rating of the accessories should be
120 watts or less (10 amps). To use the sun visor, pull it down.
Whenusingthesunvisorforthe
side window, remove the support rod
f rom the clip, and swing it out.
Do not use the sun visor extension
over the inside mirror.
Sun Visor Vanity Mirror
Interior Convenience Items
Inst rument s and Cont rols
101
SUN VISOR
——y
y
(#y
y

Turn the dial clockwise to increase
the fan speed and airflow. Turn the
dial counterclockwise to decrease it.
Turning this dial clockwise increases
the temperature of the airflow.
This button turns the air
conditioning on and of f . The
indicator above the button is on
when the A/C is on.
Fan Control Dial
T emperature Control Dial
Air Conditioning (A/C) Button
Heating and A /C
108
FAN CONTROL DIAL
TEMPERATURE
CONTROL DIAL
MODE BUTTONS
RECIRCULATION BUTTON
MAX A/C BUTTON REAR WINDOW
DEFOGGER
BUTTON
AIR CONDITIONING
(A/C) BUTTON
LX, EX, SE, and LX-V6 models
——y
y
(#y

y

Air f lows f rom the def roster
vents at the base of the windshield.
When you select or ,
the system automatically switches to
f resh air mode and turns on the A/C.
In this case, you cannot turn the A/C
of f .
When you select , the system
automatically switches to f resh air
mode.
Each time you press a mode button,
the indicator above the button is on.
This button turns the rear window
def ogger of f and on (see page ).
When the recirculation indicator is
on, air f rom the vehicle’s interior is
sent throughout the system again.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air mode).
The outside air intakes f or the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode. The system automatically
turns on the A/C,
selects , and switches to
recirculation mode. Each indicator
abovethebuttonisonwhenMAX
A/C is turned on.
Use the mode control buttons to
select the vents air flows from. Some
air will f low f rom the dashboard
corner vents in all modes.
Air flows from the center
and corner vents in the dashboard.
Airf low is divided between
the vents in the dashboard and the
f loor vents.
Air f lows f rom the f loor
vents.
Airf low is divided between
the f loor vents and def roster vents at
the base of the windshield. 72
MAX A/C Button
Rear Window Def ogger Button
Mode Control
Recirculation Button
Heating and A /C
Features
109
——y
y
(#y

y

The f low-through ventilation system
draws in outside air, circulates it
through the interior, then exhausts it
through vents near the rear window.Set the temperature to the lower
limit.
Make sure the A/C is of f .
Select and fresh air mode.
Set the f an to the desired speed. The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes bef ore you
f eel warm air coming f rom the
system.
Select .
When you select , the system
automatically switches to the fresh
air mode.
Set the f an to the desired speed.
Adjust the warmth of the air with
the temperature control dial. Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge (see page
). If it moves near the red zone,
turn of f the A/C until the gauge
reading returns to normal.
Turn on the A/C by pressing the
button. The indicator above the
button comes on when a f an speed
is selected.
Make sure the temperature is set
to maximum cool.
Select .
Set the f an to the desired speed.
1.
1.
2. 3.4. 2.3.1. 2. 3. 5.64
Ventilation Using the Heater Using the A /C
Heating and A /C
110
——y
y
(#y

y
air is dry, select f resh air mode.
4.
If the outside air is humid, select
recirculation mode. If the outside