2007 GMC YUKON buttons

Getting to Know YourYukon/Yukon Denali2
Instrument Panel
See Section 3 of your Owner Manual.
A.Air Outlets
B.Turn Signal/Multifunction Lever
C.Instrument Panel Cluster
D.Shift Lever
E.Tow/Haul Selector Button
(ifequipped)
F.Driver Information Center ControlsG.Audio System
H.Exterior Lamps Control
I.Dome Lamp Override Button
J.Automatic Transfer Case Control
K.Cruise Control Buttons
L.Tilt Steering Wheel Lever
M.HornN.Audio Steering Wheel Controls
O.Climate Controls
P.Accessory Power Outlets
Q.StabiliTrak Button (if equipped)
R.Glove Box
A
B
C
D
E
F
G
A
H
I
J
K
L
M
N
O
P
Q
R
A
DRIVER INFORMATION
P

Getting to Know YourYukon/Yukon Denali4
Vehicle Symbols
Following are examples of symbols you
may find on your vehicle. It is importantto become familiar with them, as theyalert you to various vehicle operatingconditions.
Air Bag Readiness Light
Air Conditioning (A/C)
Antilock Brake System
Warning Light
Brake System Warning Light
(Parking Brake Set)
Cruise Control SetHeadlamps
Malfunction Indicator Lamp
(Check Engine Light)
Off
Off/On
On
Rear Window Defogger
Safety Belt Reminder Light
2
Safety Belt Reminder Light,
Passenger
Security Light
StabiliTrak Warning Light
Tire Pressure LightTow/Haul Mode Light
Traction Control Off Light
Driver Information Center
Your vehicle’s Driver Information Center
(DIC) provides vehicle information, vehi
cle warning messages and vehicle fea
ture customization. The DIC messageswill be shown on your instrument panel
cluster display. To operate the DIC, theignition switch must be on.
DIC Buttons
The DIC buttons are located on the right
side of the instrument panel cluster.
(Trip/Fuel):Press this button to
display the odometer, trip odometer, fuel
range, average economy, fuel used,
timer, transmission temperature, instantaneous economy (if equipped) andActive Fuel Management™ indicator
(if equipped).

Getting to Know YourYukon/Yukon Denali6
Warnings and Messages
The DIC provides a variety of vehicle
messages (depending on optional equipment) as well as warnings if a problemis sensed in a vehicle system.
To acknowledge a message and clear it
from the display, press any of the DICbuttons. Some urgent messages cannot
be cleared from the DIC display.
If your vehicle is equipped with OnStar
and a warning message appears, youcan press the blue OnStar button and
speak to an OnStar Advisor. In many
vehicles, OnStar Advisors can accesscertain diagnostic information and cantell you how serious the condition is andwhat you should do about it.
See Section 3 of your Owner Manual.
The Remote
Keyless Entry
(RKE) transmitter includes
the followingfunctions:
(Remote
Vehicle Start)
(if equipped): If
your vehicle hasthis feature, itcan be used tostart the engine.
(See Remote Vehicle Start.)
(Lock):Press this button to lock all
the doors. If enabled through the DriverInformation Center (DIC), the parkinglamps will flash once and/or the horn willchirp to indicate locking has occurred.
(Unlock):Press this button to unlock
the driver’s door. If the button is pressedagain within five seconds, all remainingdoors will unlock. If enabled through theDIC, the parking lamps will flash once toindicate unlocking has occurred.
(Liftglass):Press and hold this
button to open the liftglass.
(Power Liftgate) (if equipped):
Press and hold this button to open or
close the liftgate. The taillamps will flashand a chime will sound to indicate theliftgate is activated.
(Vehicle Locator/Panic Alarm):Press this button to locate your vehicle.
The parking lamps will flash and thehorn will sound three times.
Note:Your vehicle’s warnings and mes
sages provide critical information thatcan prevent damage to your vehicle.Review your Owner Manual to becomefamiliar with the information displayedand the action required.
Remote Keyless Entry
SAFETY & SECURITY

7
Press and hold the button to activate the
panic alarm. The parking lamps will flashand the horn will sound for 30 seconds.
Press the button again or turn the ignition to Run to cancel the panic alarm.
See Section 2 of your Owner Manual.
To arm the content theftdeterrent alarm
system, lock the doors using the RKE
transmitter. The security light on theinstrument panel cluster will flash forapproximately 30 seconds to indicate
the alarm is activated. To disarm thesystem, unlock the doors using the RKE
transmitter.
The alarm system will not be armed or
disarmed if the doors are locked or
unlocked with a key, the manual doorlock or the power door lock switch.
See Section 2 of your Owner Manual.
The OnStar system provides invehicle
safety, security and phone services,
available 24 hours a day, 7 days aweek. These services are easily
accessed using the three OnStar
buttons located on the inside rearview mirror.
For more information about OnStar
features, refer to the OnStar Owner’s
Guide and enclosed audio CD in yourglove box.
See Section 2 of your Owner Manual.
The power seat controls for the driver
and front passenger seats are locatedon the outboard side of the seats.
Power Seat: Use the control (A) to
move the seat forward/rearward andup/down as well as to raise/lower thefront or rear of the seat cushion.
Power Recline (if equipped): Use the
control (B) to recline/raise the seatback.
Power Lumbar (if equipped): Use the
control (C) to increase/decrease lumbarsupport and to raise/lower the height ofthe support.
See Section 1 of your Owner Manual.
Power Seat Controls
(if equipped)
A
B
C
Content TheftDeterrent System
OnStar®(if equipped)
COMFORT

Getting to Know YourYukon/Yukon Denali8
To operate the heated seats, the engine
must be on. The heated seat operation
turns off when the ignition is turned off.
Front Seats
The heated front seat controls are locat
ed on the front doors.
(Heated Seatback):Press the top
button to turn on the heated seatback.
(Heated Seat/Seatback):Press the
bottom button to turn on the heated seatand seatback.
Continue to press the desired button to
cycle through the temperature settingsof High (three indicator lights), Medium(two indicator lights), Low (one indicator
light) and Off (all indicator lights are off).
2ndRow Seats
The heated rear seat controls are on the
rear control panel, located on the backof the floor console.
(Heated Seat):Press the button
to turn on the heated seat and cyclethrough the temperature settings.
See Section 1 of your Owner Manual.
The memory buttons are located on
the driver’s door. Settings can be pro
grammed for the driver’s seat, outsidemirrors and the adjustable pedals (ifequipped) for two drivers.
To save memory settings:1.Adjust the driver’s seat, outside mir
rors and pedals to a comfortableposition.
2. Press and hold button 1 or 2 until two
beeps sound.
Repeat these steps for a second driver.
To recall the settings, press memory
button 1 or 2 with the vehicle in Park.
If the Remote Keyless Entry transmitteris used to enter the vehicle and thememory seat recall feature is on (seeCustomization Features), the settings
will be recalled automatically.
EasyExit Seat
The easyexit seat button is located
between the two memory buttons.Withthe vehicle in Park, press the
(EasyExit) button to move the driver’s
seat to the exit position.
If the easyexit seat feature is on (see
Customization Features), automatic seatmovement will occur when the key isremoved from the ignition.
See Section 1 of your Owner Manual.
Heated Seats (if equipped)Memory Settings (if equipped)

Getting to Know YourYukon/Yukon Denali10
The automatic climate control system
maintains the desired individual temper
ature for the driver and front seat pas
senger. The system adjusts the airflowmode, fan speed, air conditioning andrecirculation functions to reach the settemperature(s) as quickly as possible.
Automatic Operation
To set the automatic mode:
1. Press the AUTO button.
2. Set the driver’s and front passenger’s
temperature using the + or – temperature buttons.
Manual Operation
To operate the system manually, use the
following controls:
(On/Off):Press this button to turn the
system on or off.
Temperature Control:Press the + or –
temperature button(s) to raise or lowerthe temperature setting(s).
(Fan):Press the up or down arrow
to increase or decrease fan speed.
(Mode):Press the up or down but
ton to change the direction of the airflowas well as to select the defog mode.
Automatic Climate Controls
(if equipped)PASS (Passenger Temperature
Control):Press this button to turn off
the passenger temperature setting.
(Recirculation):Press this button
to recirculate inside air through the vehi
cle. This mode keeps outside air fromentering the vehicle.
(Air Conditioning):Press this but
ton to turn the air conditioning system
on or off.
AUX (Rear Climate Control):Press this
button to turn the rear climate control
system on or off.
(Defrost):Press this button to
direct most of the air to the windshieldand some air to the side window outlets.
(Rear Window Defogger):Press
this button to activate the rear windowdefogger and the heated outsiderearview mirrors (if equipped). The
defogger and heated mirrors will shut
off automatically or can be turned off
by pressing the button again.
See Section 3 of your Owner Manual.
The rear seat climate control system can
be operated using the front climate con
trols on the instrument panel or the rearcontrol panel, located near the 2ndrowseats in the headliner or integrated withthe Rear Seat Audio (RSA) controls
(if equipped) on the back of the floorconsole.
To turn the rear system on or off, press
the AUX button on the front control
panel. The settings in the rear will be the
same as in the front until they arechanged using the rear controls.
Rear Seat Climate Controls
(if equipped)

11
Rear Control Panel System
To operate the system, use the following
rear controls:
(Fan):Turn the fan control knob to
adjust fan speed.
Temperature Control:Turn the temper
ature control knob to adjust the temperature setting.
(Mode):Turn the airflow mode con
trol knob to adjust the direction of the
airflow.
Rear Controls with RSA
To operate the system, use the following
rear controls that are integrated with the
RSA controls:
AUTO:Press the (Mode) button until
AUTO is displayed to control temperature, airflow and fan speed.
(Fan):Press the up or down fan
arrow to manually adjust fan speed.
Temperature Control:Press the + or –
temperature button to adjust the temper
ature setting.
(Mode):Press the Mode button
tomanually adjust the direction of the
airflow.
See Section 3 of your Owner Manual.
While most of the features on your radio
will look familiar, following are some that
may be new.
(Power/Volume):Press this knob to
turn the system on or off. Turn the knobto adjust the volume.
(Information):Press this button to
display additional text information relat
ed to the current FMRDS or XM station,
or MP3 song.
(Tune):Turn this knob to select radio
stations or, when a CD is playing, toselect a track or MP3 file.
Press the knob to display the tone con
trol (bass/treble) or speaker control (balance/fade) label. Press the pushbutton
under the desired label. Turn the knob toadjust the setting. To adjust all tone and
speaker controls to the middle position,
press and hold the Tune knob for more
than two seconds. A beep will sound.
FAV (Favorite):Press this button to go
through up to six pages of any combina
tion (AM; FM; or XM, if equipped) ofpreset favorite radio stations. On eachpage, up to six stations are available byusing the six pushbuttons below theradio station frequency labels on the
radio display.
Audio System Features
(NonNavigation Radios only)
ENTERTAINMENT

Getting to Know YourYukon/Yukon Denali12
BAND:Press this button to switch to
AM; FM; or XM (if equipped). With a CD
loaded or a portable audio player connected, press this button to switchbetween radio and CD/portable audioplayer operation.
(Seek/Scan): Press the right or
left arrow button to go to the next or pre
vious radio station or, when a CD is
playing, to the next track or MP3 file, or
the start of the current track or MP3 file.
To enter the scan mode, press and hold
either arrow button for a few seconds (a
beep will sound). Radio stations will bescanned. Press either arrow buttonagain to stop scanning.
(Reverse):Press and hold this but
ton to reverse playback quickly within atrack or MP3 file.
(Forward):Press and hold this but
ton to advance playback quickly within atrack or MP3 file.
CD/AUX:Press this button to play a CD
instead of the radio. Press again and thesystem will automatically search for anauxiliary input device such as a portable
audio player.
EQ (Automatic Equalization):Press
this button to select preset equalizationsettings.
CAT (Category):Press this button to
find XM stations (if equipped) within a
desired category.
Auxiliary Input Jack:Aportable audio
player can be connected to the auxiliaryinput jack located on the radio.
Setting Favorite Stations
Before setting your favorite stations,
shift the vehicle into Park.
To set up the number of favorite station
pages:
1.Press the MENU button to display the
radio setup menu.
2. Press the pushbutton located below
the FAV 1– 6 label on the radiodisplay.
3.Select the desired number of favorite
station pages.
4. Press the FAV button. You may now
begin storing your favorite stations forthe chosen number of pages.
To store favorite stations:
1. Press the BAND button to select the
band (AM; FM; or XM, if equipped).
2.Tune to the desired radio station.
3. Press the FAV button to display the
page where the station is to bestored.
4. Press and hold one of the six push
buttons until a beep sounds.
5. Repeat the steps for each pushbutton
on each page.
Note:Choosing to engage in extended
searching for specific audio stations orsongs by using buttons and knobs — or
to give extended attention to entertainment tasks — can lead you to lookaway from the road frequently or longerthan usual. Looking away from the roadfor prolonged periods may cause you tomiss seeing things on the road that youneed to see. Be sure to keep your eyeson the road and mind on the drive —
and avoid engaging in extended searching for specific items while driving.