2007 GMC SAVANA tow

Sliding Side Door
To open the sliding side door from the outside,
pull the handle toward the rear of the vehicle and
slide the door open.
To close the sliding side door from the outside,
use the handle to slide the door toward the front of
the vehicle.
When the door is closed, it will be flush with the
side of the body.To open the sliding side door from the inside, turn
the handle upward and toward the rear of the
vehicle. Then, slide the door toward the rear of the
vehicle.
To close the sliding side door from the inside,
grasp the handle and slide the door toward
the front of the vehicle.
Make sure the door is completely closed before
driving away.
111

60/40 Swing-Out Side Door
To open the front portion of a 60/40 door from the
outside, pull out on the handle and pull the
door toward you.To open the front portion of a 60/40 door from the
inside, pull the handle toward you and push
open the door.
112

To open the rear portion of a 60/40 door from the
outside, pull the handle on the side of the rear
door and pull the door toward you.To close the 60/40 side doors, close the rear door
first. Then close the front door. Check to make
sure that both doors are completely closed.
The front side swing-out door has a check strap
assembly in the door frame to keep the door from
opening beyond 90 degrees.
To open the door beyond 90 degrees, close the
door partially, pull the check strap toward you and
then open the door. When you close the door,
the check strap will automatically re-engage.
113

To open the rear doors from the outside, pull the
handle toward you to open the passenger side
rear door first.To open the driver side rear door, pull the latch
release at the inside edge of the door.
To close the rear doors, close the driver side rear
door first. Then, close the passenger side rear
door. Check to make sure both doors are
completely closed.
115

Swing-Out Windows
To open the side door swing-out window, pull up
on the latch at the edge of the window. Swing
the window out and push down on the latch to lock
the window into place.
To close the window, pull the latch toward you
and push down on the latch to lock it.Your vehicle also has rear swing-out windows.
The rear swing-out windows work the same way as
the side swing out window, but the latch is
located at the bottom edge of the window.
Side Swing-Out Window
Rear Swing-Out Windows
118

Starting and Operating Your
Vehicle
New Vehicle Break-In
Notice:Your vehicle does not need an
elaborate break-in. But it will perform better in
the long run if you follow these guidelines:
Keep your speed at 55 mph (88 km/h)
or less for the rst 500 miles (805 km).
Do not drive at any one constant speed,
fast or slow, for the rst 500 miles
(805 km). Do not make full-throttle starts.
Avoid downshifting to brake, or slow,
the vehicle.
Avoid making hard stops for the rst
200 miles (322 km) or so. During this time
your new brake linings are not yet
broken in. Hard stops with new linings
can mean premature wear and earlier
replacement. Follow this breaking-in
guideline every time you get new brake
linings.
Do not tow a trailer during break-in. See
Towing a Trailer on page 266for the
trailer towing capabilities of your vehicle
and more information.
Following break-in, engine speed and load can
be gradually increased.
120

Automatic Transmission Operation
There are several different positions for your
shift lever.
PARK (P):This position locks your rear wheels.
It is the best position to use when you start
your engine because your vehicle cannot move
easily.
{CAUTION:
It is dangerous to get out of your vehicle
if the shift lever is not fully in PARK (P)
with the parking brake rmly set. Your
vehicle can roll.
Do not leave your vehicle when the engine
is running unless you have to. If you have
left the engine running, the vehicle can
move suddenly. You or others could be
injured. To be sure your vehicle will not
CAUTION: (Continued)
CAUTION: (Continued)
move, even when you are on fairly level
ground, always set your parking brake
and move the shift lever to PARK (P).
SeeShifting Into Park (P) on page 129.
If you are pulling a trailer, seeTowing a
Trailer on page 266.
Make sure the shift lever is fully in PARK (P) before
starting the engine. Your vehicle has an automatic
transmission shift lock control system. You must
fully apply your regular brakes before you can shift
from PARK (P) with the ignition in RUN.
If you cannot shift out of PARK (P), ease pressure
on the shift lever and push the shift lever all the way
into PARK (P) as you maintain brake application.
Then move the shift lever into another gear. See
Shifting Out of Park (P) on page 130.
125

REVERSE (R):Use this gear to back up.
Notice:Shifting to REVERSE (R) while your
vehicle is moving forward could damage
the transmission. The repairs would not be
covered by your warranty. Shift to
REVERSE (R) only after your vehicle is
stopped.
To rock your vehicle back and forth to get out of
snow, ice or sand without damaging your
transmission, seeIf Your Vehicle is Stuck in Sand,
Mud, Ice, or Snow on page 258.
NEUTRAL (N):In this position, your engine does
not connect with the wheels. To restart when
you are already moving, use NEUTRAL (N) only.
Also, use NEUTRAL (N) when your vehicle is
being towed.
{CAUTION:
Shifting into a drive gear while your
engine is running at high speed is
dangerous. Unless your foot is rmly on
the brake pedal, your vehicle could move
very rapidly. You could lose control and
hit people or objects. Do not shift into a
drive gear while your engine is running at
high speed.
Notice:Shifting out of PARK (P) or
NEUTRAL (N) with the engine running at high
speed may damage the transmission. The
repairs would not be covered by your warranty.
Be sure the engine is not running at high
speed when shifting your vehicle.
126