2007 GMC ACADIA check engine

3
Instrument Panel Cluster
A
B
C
D
E
F
L
G
H
I
K
J
See Section 3 of your Owner Manual.
Your vehicle’s instrument panel is
equipped with this cluster or one verysimilar to it. The instrument panel cluster
includes these key features:
A.Engine Coolant Temperature Gauge
B.Tachometer
C.Malfunction Indicator Lamp (Check
Engine Light)
D.Tire Pressure Warning Light
E.Driver Information CenterF.Fuel Gauge
G.Speedometer
H.Security Light
I.Cruise Control Set Light
J.Antilock Brake System
Warning Light
K.StabiliTrak Warning Light
L.Voltmeter
Note:
The instrument panel cluster
is designed to let you know aboutmany important aspects of yourvehicle’s operation. It is important
toread your Owner Manual and
become familiar with the informationbeing relayed to you by the lights,gauges and indicators, as well aswhat action can be taken to ensuresafety and to prevent damage.
Acadia 2007 A 10/3/06 3:06 PM Page 3

Getting to Know YourAcadia6
If you change your seat position, you
may have to readjust the HUD image forproper viewing.
(Page):Press and hold this button to
change the display format. Release thebutton when the desired display isshown.
If the ignition is on and you cannot see
the HUD image, check to see whether:
• Something is covering the HUD lens
• The brightness is adjusted properly
• The HUD image is adjusted to the
proper height
• The windshield and HUD lens are
clean (do not spray glass cleaner
directly on the HUD lens)
• You are wearing polarized sunglass
es, which could make the imageharder to see
• A fuse is blown (see your Owner
Manual)
See Section 3 of your Owner Manual.
(Lock):Press this button to lock all
the doors. RKE feedback (light flashand/or horn chirp) can be programmedusing the Driver Information Center(DIC).
(Unlock):Press this button to unlock
the driver’s door. Press it again withinfive seconds to unlock all remainingdoors. RKE feedback (light flash) can beprogrammed using the DIC.
(Power Liftgate)(if equipped):
Press and hold this button until the liftgate starts moving to open and close
the liftgate. The taillamps will flash and
a chime will sound when the liftgate ismoving.
(Vehicle Locator/Panic Alarm):Press and release this button to locate
your vehicle. The turn signal lamps will
flash and the horn will sound three
times.
Press and hold the button to activate the
panic alarm. The turn signal lamps willflash and the horn will sound for 30 sec
onds. Press the button again or turn theignition to On to cancel the panic alarm.
See Section 2 of your Owner Manual.Remote Keyless Entry
SAFETY & SECURITY
The Remote
Keyless Entry (RKE)transmitter allowsyou to lock andunlock your vehicleand perform otherfunctions while up toapproximately 195feet away from thevehicle. RKE functions include:
(Remote Vehicle Start)(if
equipped): This feature can be used to
start the engine from outside the vehicle.
(See Remote Vehicle Start.)
OnStar®
The OnStar system provides invehicle
safety, security and phone services,available 24 hours a day, 7 days a
week. These services are easily
accessed through the three OnStarbuttons in your vehicle.
For more information about OnStar
features, refer to the OnStar Owner’s
Guide and enclosed audio CD located
inyour glove box.
See Section 2 of your Owner Manual.
Acadia 2007 A 10/3/06 3:07 PM Page 6

21
There are several ways to open and
close the power liftgate:
• Press and hold the (Power
Liftgate) button on the RemoteKeyless Entry transmitter until theliftgate starts moving. Press it againto reverse operation.
• Press the (Power Liftgate) button
on the center console in front of the
shift lever. Press it again to reverse
operation.
• Press the touchpad on the liftgate
handle to open. Press it again toreverse operation.
• Press the
button on thebottom of theliftgate, next tothe liftgatelatch, to close.Press it again to reverse operation.
To disable all power liftgate controls,
switch the button on the center
console to the OFF position. The liftgate
can be opened and closed manually.
See Section 2 of your Owner Manual.
Power Liftgate (if equipped)
Remote Vehicle Start
(if equipped)
This feature allows you to start the
engine from outside the vehicle by using
the RKE transmitter. The remote startcapability must be turned on using theDriver Information Center.
The vehicle’s automatic climate control
system (if equipped) will default to aheating or cooling mode based onoutside temperature, and the manualclimate control system will turn on at the
same setting as when the vehicle was
last turned off.
Starting the Vehicle
To remote start the vehicle:
1.Aim the RKE transmitter at the
vehicle. (Transmitter range is withinapproximately 195 feet of the vehicle.)
2. Press and release the (Lock)
button on the transmitter.
3. Immediately press and hold the
(Remote Start) button for about fourseconds. When the vehicle starts, theparking lamps will light and remain on
while the engine is running. The enginewill continue running for 10 minutes.
4. Repeat these steps for a 10minute
time extension. Only two consecutiveremote starts are allowed.
When you enter the vehicle after a
remote start, the key must be inserted inthe ignition and turned to the On positionbefore driving.
Canceling a Remote Start
If you wish to turn off the engine instead
of driving after a remote start, performone of the following functions:
•Press and hold the (Remote Start)
button until the parking lamps turn off.
•Press and release the Hazard
Warning Flashers button. Press it
again to turn off the flashers.
• Turn the key in the ignition switch to
the On position and then off.
See Section 2 of your Owner Manual.
Note:The Remote Vehicle Start feature
will not operate if the key is in the ignition, the hood or liftgate is open, or theCheck Engine light is illuminated on the
instrument panel cluster.
Acadia 2007 A 10/3/06 3:07 PM Page 21

23
Tire Pressure Monitor
The Tire Pressure Monitor alerts you
when a significant reduction in pressure
occurs in one or more of your vehicle’s
tires by illuminating the (Low Tire
Pressure) warning light on the instru
ment panel. The low tire pressurewarning light will remain on until youcorrect the tire pressure.
A CHECK TIRE PRESSURE message
may appear on the DIC.
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must fill the tire to the
proper tire inflation pressure. The Tire
and Loading Information label, located
on the center pillar below the driver’sdoor latch, shows the correct inflationpressure for the tires when they’re cold.“Cold” means your vehicle has beensitting for at least three hours or drivenno more than one mile.
You can temporarily remove the DIC
message by acknowledging it with yourDIC controls. However, at the next
vehicle startup, the DIC message will
reappear if the tire pressure has notbeen corrected.
You may notice during cooler conditions
that the low tire pressure warning lightwill appear when the vehicle is first
started and then turn off as you start todrive the vehicle. This could be an early
indicator that your tire pressures are getting low and need to be inflated to theproper pressure.
See Section 5 of your Owner Manual.
Note:The Tire Pressure Monitor can
alert you about low tire pressure, but itdoesn’t replace normal monthly tiremaintenance.
Resetting the Oil Life System
The Oil Life System calculates engine oil
life based on vehicle use and displays
CHANGE OIL SOON in the Driver
Information Center (DIC) when it’snecessary to change your engine oil and
filter. The Oil Life System should bereset to 100% only following an oilchange.
To reset the Oil Life System (without
DIC):
1. Turn on the ignition, with the engine
off.
2. Fully press and release the accelera
tor pedal slowly three times withinfive seconds.
3. Turn off the ignition.
To reset the Oil Life System (with DIC):
1. Turn on the ignition, with the engine
off.
2. Press the (Vehicle Information)
button until the DIC displays OILLIFE
REMAINING.
3. Press and hold the (Set/Reset)
button until 100% is displayed.
4. Turn off the ignition.
See Section 5 of your Owner Manual.
Acadia 2007 A 10/3/06 3:07 PM Page 23