2007 FORD FIESTA Subframe front

Handles, Locks, Latches and Entry Systems 501-14
Wipers and Washers 501-16
Bumpers 501-19
Safety Belt System 50
I -20A
Supplemental Restraint
System 501 -20B
Body Repairs
- General
Information 501 -25
Body Repairs
- Vehicle Specific
lnformation and Tolerance
Checks 501 -26
To the best of our knowledge, the illustrations,
technical information, data and descriptions in
this issue were correct at the time of going to
print. The right to change prices, specifications,
equipment and maintenance instructions at
any time without notice is reserved as part of
FORD policy of continuous development and
improvement for the benefit of our customers.
No part of this publication may be reproduced,
stored in a data processing system or
transmitted in any form, electronic, mechanical,
photocopy, recording, translation or by any
other means without prior permission of
Ford-Werke Aktiengesellschaft. No liability can
be accepted for any inaccuracies in this
publication, although every possible care has
been taken to make it as complete and
accurate as possible.
Copyright
O
FORD-WERKE AKTIENGESELLSCHAFT
Service training programs D-FIGT-1
Printed in Germany
- rewi druckhaus, Wissen -
Printed on environmentally friendly
chlorine-free paper. (GB) Front End Sheet Metal Repairs
50 1 -27
Roof Sheet Metal Repairs 50 1 -28
Side Panel Sheet Metal Repairs 501 -29
Rear End Sheet Metal Repairs 501
-30
Paint
- General Information 501
-36
Frame and Mounting
Uni-Body, Subframe and Mounting
System 502-00
0512005 2006.0 Fiesta
procarmanuals.com

GROUP
Body and Paint
SECTION TITLE PAGE
Body and Paint
........................................................................\
.... Body System . General Information .50 1.00
........................................................................\
......................... Front End Body Panels .50 1.02
........................................................................\
........................................ Body Closures 501 -03
Interior Trim and Ornamentation ........................................................................\
............ 501-05
........................................................................\
.......... Exterior Trim and Ornamentation .50 1-08
........................................................................\
.................................. Rear View Mirrors 50 1 -09
........................................................................\
................................................... Seating 501 -10
........................................................................\
........... Glass, Frames and Mechanisms .SO1 1-1
........................................................................\
............... Instrument Panel and Console 502 1-1
............................................................... Handles, Locks, Latches and Entry Systems -501 -1 4
........................................................................\
............................. Wipers and Washers -501 -1 6
Bumpers ........................................................................\
................................................. 501 -1 9
........................................................................\
................................. Safety Belt System 50 I -2OA
........................................................................\
............. Supplemental Restraint System .50 I -2OB
Body Repairs - General Information ........................................................................\
...... 501-25
Body Repairs - Vehicle Specific Information and Tolerance Checks ............................. 501-26
........................................................................\
............. Front End Sheet Metal Repairs .50 1-27
........................................................................\
..................... Roof Sheet Metal Repairs -50 I -28
Side Panel Sheet Metal Repairs ........................................................................\
............ 501-29
........................................................................\
.............. Rear End Sheet Metal Repairs 50 1-30
........................................................................\
.................... Paint - General Information 501 -36
Frame and Mounting
Uni-Body, Subframe and Mounting System ................................................................... 502-00
0512005 2006.0
Fiesta
procarmanuals.com

204-00-4 Suspension System - General Information 204-00-4
DIAGNOSIS AND TESTING
Suspension System
I I Alignment Pins, Subframe I
lnspection and Verification
Mechanical
Wheel knuckles
Tie-rod ends
Front suspension lower arm ball joints
Front suspension lower arm bushings
Front strut and spring assemblies
Front stabilizer bar and connecting links
Rear springs
Rear shock absorbers
Rear suspension beam axle and bushings
1.
Verify the customer concern.
I
2. Visually inspect for obvious signs of mechanical
damage.
3. If an obvious cause for an observed or reported Visual Inspection Chart concern is found, correct the cause (if possible)
I I Wheels and tires
Mechanical
Tire pressure(s)
Symptom Chart
before proceeding to the next step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
Symptom Chart
Symptom
Drift left or right
Possible Sources Action
Steering System (Diagnosis
and Testing),
Steering System
- 1.6L
Duratorq-TDCi (DV) Diesel
(Diagnosis and Testing).
Vehicle attitude incorrect (front
or rear is high or low).
Steering gear or linkage worn
or damaged.
I Brake system. I CHECK the brake system. I
CHECK for abnormal loading,
spring sag or non-standard
springs.
CHECK the steering system.
REFER to: (21 1-00 Steering
System
- General Information)
REFER to: Brake System (206-
00 Brake System
- General
Information, Diagnosis and
REFER to: Specifications (204-
'!
00 Suspension System -
i
General Information,
Specifications).
Incorrect wheel alignment.
2006.0 Fiesta 1212006 GI 49885en
Testing).
ADJUST the wheel alignment. ,'-
procarmanuals.com

204-01 -9 Front Suspension 204-0 I -9
REMOVAL AND INSTALLATION
Front Stabilizer Bar(l4 752 0)
i , Special Tool(s1
General Equipment
205524
I Transmission jack 1
Alignment Pins, Subframe
205-524 (1 5-1 22)
I Wooden block I
Removal
1. N0TE:Make sure the road wheels are in the
straight ahead position.
Centralize the steering and lock
it in position.
2. Detach the steering column shaft from the
steering gear pinion.
Discard the retaining bolt.
3. Raise and support the vehicle.
For additional information, refer to: Jacking
(100-02 Jacking and Lifting, Description
and Operation)
I Lifting (1 00-02 Jacking and Lifting,
Description and Operation).
4. N0TE:Use a 5 mm Allen key to prevent the
ball joint from rotating.
Detach the stabilizer bar connecting link from
the stabilizer bar on both sides.
5. Remove the engine support insulator.
2006.0 Fiesta 1212006 GI 83758en
procarmanuals.com

211 -00-5 Steering System - General Information 211 -00-5
DIAGNOSIS AND TESTING
Steering System
/ Special Tool(s)
Alignment Pins, Subframe
205-524
Simulator, Driver and
passenger ~ir Bags and Side
Air Curtains 50
1 -073A
General Eaui~ment
I Worldwide Diagnostic System (WDS) I
Principles of Operation
The steering wheel rotational movement is
transferred to the steering gear through the steering
column shaft. The steering gear converts this
rotational movement, through the action of the rack
and pinion gear into lateral movement. This
movement in turn is transferred to the wheel
knuckles through the tie-rods and tie-rod ends.
Hydraulic fluid under pressure is supplied to the
steering gear by the power steering pump. As the
steering wheel is rotated, the hydraulic fluid is
allowed to pass through the steering gear valve to
one side of a double acting piston, dependent on
which direction the steering wheel is rotated. The
fluid moves the piston, which forms part of the
steering gear, giving power assistance to the effort
required to rotate the steering wheel.
Vehicles with petrol engines, due to the extra load
on the engine imposed by the power steering
pump, have a power steering pressure (PSP)
switch. The switch, which is normally closed, sends a signal
to the powertrain control module (PCM)
during low speed parking manoeuvres. The PCM
responds by maintaining the engine idle speed.
lnspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of mechanical
or electrical damage.
Visual lnspection Chart
I Mechanical I Electrical I
Tire pressure(s)
Accessory drive belt
Tie-rod ends
Tie-rod (s)
Steering gear housing
Front strut and
spring assemblies
Front suspension
lower arm ball joints
Front suspension
lower arm bushings
Pinch bolt on
steering column
shaft flexible coup-
ling Power
steering pres-
sure (PSP) switch
Wheels and tires
Power steering line
fluid leaks
Steering gear
bellows
3. If an obvious cause for an observed or reported
concern is found, correct the cause (if possible)
before proceeding to the next step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
Symptom Chart
Symptom Possible Sources Action
Drift left or right
2006.0 Fiesta 1212006 Gl49906en
Vehicle attitude incorrect (front
or rear is high or low). CHECK for abnormal loading,
coil spring sag or non-standard
springs.
procarmanuals.com

21 1 -02-30 Power Steering 21 1 -02-30
REMOVAL AND INSTALLATION
Steering Gear to Power Steering Fluid Reservoir Return Line -
2.OL Duratec-HE (M14) RHD (' ,
Centralize the steering and lock it in position. table(s).
Special Tool(s)
2006.0 Fiesta 1212006 G458167en
2. Detach the steering column shaft from the
steering gear pinion.
Discard the steering column shaft to steering
gear pinion retaining bolt.
Pp
205524
24003
Alignment Pins, Subframe
205-524
Removerllnstaller, Hose
Clamp
303-397
General Equipment
Transmission jack 3. Remove the front wheels and tires.
Materials For
additional information, refer to: Wheel
and Tire (204-04 Wheels and Tires, Removal
Name Specification and Installation).
4. Lower the vehicle.
Grease
1. N0TE:Make sure that the road wheels are in 5. Remove the components in the order
the straight ahead position.
indicated in the following illustration(s) and
SA-M 1 C9107-A
procarmanuals.com