2007 FIAT ULYSSE engine

CAR MAINTENANCE
187
Every 1,000 km or before long jour-
neys, check and top up if required:
– engine coolant fluid level;
– brake fluid level;
– windscreen washer fluid level;
– yre pressure and conditions;– light system operation (headlights,
direction indicators, hazard lights,
etc.);
– windscreen wiper/washer opera-
tion and windscreen/rear window
blade position/wear;Every 3,000 km check and top up if
required: engine oil level.
You are recommended to use FL
Selenia, products, designed and pro-
duced specifically for Fiat vehicles (see
table “Capacities” in section “Techni-
cal specifications”).
ROUTINE MAINTENANCE

CAR MAINTENANCE
188
Should prevailing use of the vehicle
be under one of the following special-
ly heavy conditions:
– trailer or caravan towing;
– dusty roads;
– short distances (less than 7-8 km)
repeated and with external tempera-
tures below zero;– frequently idling engines or long
distance low speed driving (e.g. door-
to-door deliveries) or in case of a long
term inactivity;
– driving in the city;
carry out the following checks more
frequently than required in the Service
Schedule:
– check front disk brake pad condi-
tions and wear;– check cleanness of locks, bonnet
and boot and lever cleanness and lu-
brication;
– sight inspect the conditions of: en-
gine, gearbox, transmission, pipes and
hoses (exhaust - fuel - brakes), rubber
parts (boots, sleeves, bushes, etc.);
– check battery charge and fluid lev-
el (electrolyte);
– visual check on various drive belt
conditions;
– check and replace pollen filter, if re-
quired;
– check and replace air cleaner, if re-
quired.
HEAVY-DUTY

Scarves, ties and loose
clothing may be caught in
the moving parts.Be careful not to mix up
the various types of fluids
when you are topping up:
they are all mutually incompati-
ble and could damage the vehicle.
CAR MAINTENANCE
189
CHECKING FLUID
LEVELS
IMPORTANT Open the engine
compartment according to the pro-
cedure described in the “Bonnet”
paragraph in the chapter “Getting to
know your vehicle”.Important. If the bonnet
support rod is not posi-
tioned correctly the bon-
net may fall violently.
Do not smoke while
working in the engine
compartment: the pres-
ence of flammable gas and
vapour could cause a fire.

CAR MAINTENANCE
190
1.Windscreen/rear window and
headlight (where fitted) washer fluid -
2.Engine coolant - 3.Power steering
fluid - 4.Engine oil - 5.Brake and hy-
draulic clutch fluid.
fig. 1 - Versions 2.0 JTD 120 HP - 136 HPF0B0442b

CAR MAINTENANCE
191
1.Windscreen/rear window and
headlight (where fitted) washer fluid -
2.Engine coolant - 3.Power steering
fluid - 4.Engine oil - 5.Brake and hy-
draulic clutch fluid.
fig. 2 - Versions 2.2 JTDF0B0600b

CAR MAINTENANCE
192
ENGINE OIL fig. 3-4
Check engine oil with the car on lev-
el ground and while the engine is still
warm (approximately five minutes af-
ter stopping the engine).
Extract dipstick Aand clean it, then
fully insert it again and check that the
level is between the MINand MAX
reference lines on the dipstick.
The space between the MINand the
MAXreference corresponds to ap-
proximately one litre of oil.Do not add oil with dif-
ferent specifications from
the oil already in the en-
gine.If the engine is hot, be
very careful when you put
your hands under the
bonnet as you risk burning your-
self. Remember that when the
engine is hot, the fan can start up
and cause injuries.
fig. 3
F0B0164b
fig. 4 - Versions 2.2 JTD
F0B0601b

CAR MAINTENANCE
193
If the oil level is near or even below
the MIN line, pour in oil through the
filler hole B, until it reaches the MAX
level.
IMPORTANTIf the oil results to
be over the MAX line, go to a Fiat
Dealershipand have the correct oil
level restored.
IMPORTANTAfter topping up or
changing the oil, let the engine turn for
a few seconds and wait a few minutes
after stopping it before you check the
level.
The oil level must never exceed the
MAX line.Used engine oil and re-
placed oil filters contain
substances which can
harm the environment. We rec-
ommend you have the vehicle
seen to at a Fiat Dealership for
the oil and filter change. It is suit-
ably equipped for disposing of
used oil and filters in an environ-
mentally-friendly way that com-
plies with the law. Engine oil consumption
The maximum oil consumption is ap-
proximately 400 grams every 1,000 km.
When the car is new, the engine
needs to run in, therefore the engine
oil consumption can only be consid-
ered stabilised after the first 5,000 -
6,000 km.
IMPORTANTOil consumption
depends on the driving style and the
conditions of use.

CAR MAINTENANCE
194
Do not remove the
reservoir cap when the
engine is hot: you risk
scalding yourself. ENGINE COOLANT fig. 5-6Check coolant level when the engine
is cold. The level should be included
between the MINand MAXrefer-
ence line on the reservoir.If the level is low, loosen the header
tank cap Aand slowly pour a mixture
of the fluid specified in the ”Lubricant
and fluid specifications” table in sec-
tion “Technical Specifications”,
through the filler neck until nearing the
MAXmark.
The antifreeze mixture contained in
the cooling circuit guarantees protec-
tion down to –40°C.
fig. 5 - Versions 2.0 JTD 120 HP - 136 HP
F0B0444b
fig. 6 - Versions 2.2 JTD
F0B0602b