2007 FIAT PANDA brake

2
FIAT PANDA 4 x 4
The ELD (Electronic Locking Differential)
is a further aid when driving or starting the
car in poor grip conditions (snow, ice,
mud, etc.) since it enables to distribute
power adequately to the same axle when
one or more wheels are slipping.
The ELD actually brakes the wheels that
are loosing grip (or that are slipping more
than others) and it transmits power to
wheels having best grip.This function can be engaged manually and
it operates at a car speed below 30 km/h.
Exceeding this speed it will disengage au-
tomatically.
ABS SYSTEM
This version is provided as standard with
the ABS system and includes:
❒EBD (Electronic Braking Force Distrib-
ution), that distributes the braking ef-
fect between front and rear wheels;
❒MSR (Motor Schleppmomenten
Regelung - Engine braking torque con-
trol system), that in case of sudden gear
shifting cuts in (preventing wheel lock-
ing at slow down when releasing the ac-
celerator) providing torque to the en-
gine thus preventing excessive driving
wheel drive that, specially in poor grip
conditions can lead to the loss of sta-
bility.
ELD - ELECTRONIC LOCKING DIFFERENTIAL
(where provided)
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 2

4
FIAT PANDA 4 x 4
IF A TYRE
IS PUNCTURED
General instructions
The car can be delivered (upon request/if
provided) with space-saver spare wheel
or with quick tyre repair kit (called Fix &
Go).
Wheel changing and correct use of the jack
and space-saver spare wheel call for some
precautions as listed in the Owner Hand-
book this Supplement is attached to. In the
Owner Handbook you will also find how
to use the Fix & Go kit (quick tyre repair
kit).
To change a wheel proceed as follows:
❒stop the car in a position that is not
dangerous for oncoming traffic where
you can change the wheel safely. The
ground should be flat and adequately
firm;
❒turn the engine off and pull up the hand-
brake;
❒engage first gear or reverse;
❒take out the tool bag fig. 3set under the
driver’s seat and take it near the wheel
to be changed;
❒loosen the clamping device B-fig. 4;
❒take the space-saver spare wheel A;
❒loosen the bolts on the wheel to be
replaced with the wrench provided A-
fig. 5;
❒turn the jack handle to open it partly;
❒place the jack near the wheel to be
changed in line with mark Oon the
sidemember fig. 6;
❒make sure the groove Fon the jack fits
correctly into the sidemember ridge G;
❒alert other passengers that the car is
about to be raised; all persons should
be kept away from the car until it has
been lowered again;
fig. 3F0G0607m
fig. 4F0G0608m
fig. 5F0G0609m
fig. 6F0G0610m
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 4

8
FIAT PANDA 4 x 4
❒loosen the three fastening screws A-
fig. 15and remove the headlight cov-
er;
❒remove the cover by removing the
catches B;
❒remove the lens fig. 16by loosening
the three fastening screws A;
❒turn connector A-fig. 17counter-
clockwise and remove it;
❒remove the bulb B-fig. 17and fit the
new bulb.
To change the direction indicator bulb,
proceed as follows:
❒loosen the two fastening screws A-
fig. 18and remove the cover B;
❒loosen the fastening screws A-fig. 19
and remove the lens B;
❒remove the cap A-fig. 20from the lens
Band remove the bulb holder C;
❒remove bulb Dby pushing it slightly and
turning it counter-clockwise, then fit
the new bulb.
To change side direction indicators, third
brake light and number plate light bulbs re-
fer to paragraph “When needing to change
a bulb” in section “In an emergency” in the
attached Owner Handbook.
fig. 15F0G0620mfig. 17F0G0622m
fig. 16F0G0621mfig. 18F0G0623m
fig. 19F0G0624m
fig. 20F0G0631m
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 8

9
FIAT PANDA 4 x 4
REAR LIGHT UNITS
The bulbs are arranged inside the light unit
as follows fig. 21:
A12V-W5W, double filament bulb for
brake lights/taillights.
B12V-P21W bulb for direction indica-
tors.
C12V-P21W bulb for rear fog light (left
headlight) or reversing light (right head-
light).To change a bulb proceed as follows:
❒loosen the three screws A-fig. 22then
pull gently the headlight outwards un-
til releasing it from the three catches;
fig. 22F0G0625mfig. 23F0G0626m
❒loosen the four screws A-fig. 23and
disconnect the two connectors;
❒remove the required bulb holder turn-
ing it counter-clockwise;
❒remove the required bulb (A, Bor C-
fig. 21), pushing it slightly and turning
it counter-clockwise (bayonet cou-
pling), then fit the new bulb.
fig. 21F0G0627m
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 9

10
FIAT PANDA 4 x 4
WASHING THE CAR
After using the car off-road (wheels, body,
underengine and underbody protections
very dirty), remember to wash it and to
clean accurately radiators (engine and air-
conditioner), radiator fan and wheels (rims
and wheelhouses), underengine and un-
derbody protections to preserve their
regular operation and to guarantee prop-
er ventilation of brake discs, perfect wheel
geometry and regular operation of the
propeller shaft.
TOWING THE CAR
The car can only be towed in one of the
following ways (always and exclusively
with the engine off, gearbox in neutral and
handbrake disengaged):
– with the 4 wheels on the roadbed;
– with front wheels raised or resting on
the wrecking car floor and rear wheels
resting on a suitable truck;
– with rear wheels raised or resting on the
wrecking car floor and front wheels rest-
ing on a suitable truck;
– on wrecking car, with front and rear
wheels resting on the wrecking car floor.
TOWING TRAILERS
IMPORTANT If the car is used at its max.
towing capacity on sloping road, change
engine oil every 10,000 km.
As concerns tow hook installation in-
structions and warnings refer to the at-
tached Owner Handbook.
The assembly diagram with the new tow
hook fixing points is given below.
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 10

12
FIAT PANDA 4 x 4
20 40 60 80 100 120 140 160 180
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●● ● ●
●●●●● ●●●●
●●●●● ●●●●
●
●● ● ●
●● ● ●
●● ● ●
●●
SERVICE SCHEDULE
Thousands of km
Check tyre conditions/wear and adjust pressure
if required
Check light system operation (headlights, direction indicators,
hazard lights, passenger compartment lights, boot lights,
warning lights, etc.)
Check windscreen wiper/washer operation,
adjust nozzles
Check windscreen/rear window blade
position/wear
Check front disk brake pad conditions and wear
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: body external parts,
underbody protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever cleanness
and lubrication
Check tension and adjust accessory drive belts
(excluding engines with automatic belt tighteners)
Sight inspect accessory drive belt conditions
Check and adjust tappet clearance (petrol versions)
Check handbrake lever stroke
Check antievaporation system (petrol versions)
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 12

13
FIAT PANDA 4 x 4
20 40 60 80 100 120 140 160 180
●● ●
●● ●●●●●●●
●●
●
●●●●
●●●●
●●
●● ●●●●●●●
●● ●
●● ●●●●●●●
●●●●
●● ●
Thousands of km
Change air cleaner cartridge
(every 30,000 km/for 1.3 Multijet engine)
Top up fluids
(engine coolant, brakes, windscreen, battery, etc.)
Check timing belt
(excluding 1.3 Multijet engines)
Replace timing belt (*)
(excluding 1.3 Multijet engine)
Change spark plugs (petrol versions)
Check engine control system operation
(through diagnosis socket)
Check mechanical transmission oil level
Change engine oil and oil filter
(every 30,000 km/for 1.3 Multijet engine)
Change brake fluid (or every 2 years)
Change pollen filter (or every year)
Check exhaust emissions/smoke (1.3 Multijet engine)
Replace fuel filter cartridge (Green-filter)
(1.3 Multijet engine)
(*) Or every 3 years for particularly demanding use:
– cold/hot climates,
– driving in the city, idling for a long time,
– dusty roads or roads covered with sand and/or salt.
Or every 5 years, regardless of the km covered and the car conditions of use.
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 13

20
FIAT PANDA 4 x 4
1.2
30
4.5
–
–
4.6
2.5
2.8
–
–
2.7
0.9
0.55
4.51.3 Multijet
–
–
30
4.5
6.5
–
–
2.85
3.0
2.7
0.9
0.55
4.5Specified fuels
and recommended products
Unleaded premium petrol with no
less than 95 R.O.N
(EN 228 Specification)
Diesel fuel for motor vehicles
(EN 590 Specification)
Mixture of 50% water and 50%
PARAFLU UP
SELENIA 20K(*)
SELENIA WR
TUTELA CAR TECHNYX (**)
TUTELA W90/M-DA(***)
TUTELA TOP 4
Mixture of water and
TUTELA PROFESSIONAL SC 35
CAPACITIES
Fuel tank: litres
including a reserve of: litres
Fuel tank: litresincluding a reserve of: litres
Engine cooling system: litres
Engine sump: litres
Engine sump and filter: litres
Engine sump: litres
Engine sump and filter: litres
Gearbox/differential: litres
Rear differential: litres
Hydraulic brake circuit: kg
Windscreen/rear window and
headlight washer fluid reservoir litres
(*) For use in particularly harsh weather conditions SELENIA PERFORMER MULTIPOWERengine oil is recommended
(**) SAE 75W-85synthetic oil that passes API GL4 PLUS, MIL - L - 2105 D Lev specifications
(***) SAE 80W-90mineral oil that passes API GL5, MIL - L - 2105 D Lev specifications
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 20