2007 FIAT BRAVO lock

141
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
GENERAL WARNINGS ...................................................... 142
LOW BRAKE FLUID.............................................................. 142
HANDBRAKE ON ................................................................. 142
BRAKE PAD WEAR .............................................................. 142
AIR BAG FAILURE ................................................................. 143
FRONT PASSENGER AIR BAG/
SIDE BAGS DEACTIVATED ......................................................... 143
SEAT BELTS NOT FASTENED ........................................... 144
LOW BATTERY CHARGE .................................................. 144
LOW ENGINE OIL PRESSURE........................................... 144
EXHAUSTED OIL ................................................................. 144
LOW ENGINE OIL LEVEL .................................................. 145
“DUALDRIVE” ELECTRIC POWER
STEERING FAILURE............................................................... 145
“DUALDRIVE” ELECTRIC POWER STEERING
ACTIVATION ........................................................................ 145
ENGINE COOLANT HIGH TEMPERATURE................. 146
INCOMPLETE DOOR LOCKING..................................... 146
BOOT OPEN ........................................................................... 146
BONNET OPEN ..................................................................... 146
GENERIC FAILURE INDICATION .................................. 147
DIESEL PARTICULATE FILTER CLOGGED .................. 147
FUEL RESERVE......................................................................... 148
EOBD/INJECTION SYSTEM FAILURE ............................. 148
ESP SYSTEM ............................................................................ 149
HILL HOLDER FAILURE ..................................................... 149GLOW PLUG WARMING ................................................. 149
GLOW PLUG WARMING FAILURE ................................ 149
WATER IN DIESEL FUEL FILTER ...................................... 150
ABS SYSTEM FAILURE .......................................................... 150
EBD SYSTEM FAILURE ......................................................... 150
CAR PROTECTION SYSTEM
FAILURE FIAT CODE............................................................ 151
ALARM FAILURE .................................................................... 151
THEFT ATTEMPT ................................................................... 151
LOW TYRE PRESSURE ........................................................ 151
CHECK TYRE PRESSURE ................................................... 151
TYRE PRESSURE UNSUITABLE FOR SPEED ................. 151
EXTERNAL LIGHTS FAILURE ............................................ 153
BRAKE LIGHTS FAILURE..................................................... 153
REAR FOGLIGHTS ................................................................ 153
FRONT FOG LIGHTS ........................................................... 153
LEFT-HAND DIRECTION INDICATOR ........................ 153
RIGHT-HAND DIRECTION INDICATOR .................... 153
SIDE/TAILLIGHTS AND LOW BEAMS............................ 154
FOLLOW ME HOME ............................................................ 154
MAIN BEAMS ........................................................................... 154
CRUISE CONTROL ............................................................. 154
POSSIBLE PRESENCE OF ICE ON THE ROAD ............ 154
LIMITED RANGE ................................................................... 154
ASR SYSTEM ........................................................................... 154
SPEED LIMIT EXCEEDED ................................................... 154
SPORT FUNCTION ACTIVATION ................................. 154
W W
A A
R R
N N
I I
N N
G G
L L
I I
G G
H H
T T
S S
A A
N N
D D
M M
E E
S S
S S
A A
G G
E E
S S
141-154 BRAVO GB 10-05-2007 9:17 Pagina 141

146
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
ENGINE COOLANT
HIGH TEMPERATURE
(red)
Turning the ignition key to MAR
the warning light turns on, but it should go
off after few seconds.
The warning light turns on when the en-
gine is overheated.
If the warning light comes on, proceed as
follows:
❒normal driving conditions: stop the
car, switch off the engine and check
whether the water level in the reser-
voir is not below the MIN mark. Oth-
erwise wait for few seconds to allow
engine cooling, then open slowly and
carefully the cap, top up coolant and
check whether its level is falling be-
tween MIN and MAX marks in the
reservoir. Check visually any leak and if
when restarting the warning light
comes on again, contact a Fiat Dealer-
ship.
❒Car heavy duty(e.g.: towing trailer
uphill of fully laden car): decrease speed,
if the warning light stays on, stop the
car. Wait for 2 or 3 minutes leaving the
engine on and slightly accelerated to
further activate the circulation of the
coolant fluid, then switch the engine off.
Check proper coolant level as de-
scribed previously.
IMPORTANT Under severe use of the
car, keep the engine on and slightly accel-
erated for few minutes before switching it
off.
The display will show the dedicated mes-
sage.
ç
INCOMPLETE DOOR
LOCKING (red)
The warning light (or the sym-
bol on the display) turns on when
one or more doors are not properly shut.
The buzzer will sound when one or more
doors are open and the car is moving.
´
BOOT OPEN
The symbol (where provided)
on the display turns on when
the boot is not properly shut.
On certain versions the warning light
´turns on instead.
R
BONNET OPEN
The symbol (where provided)
on the display turns on when
the bonnet is not properly shut.
On certain versions the warning light
´turns on instead.
S
141-154 BRAVO GB 10-05-2007 9:17 Pagina 146

150
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
WATER IN DIESEL
FUEL FILTER
(Multijet versions)
(amber)
Turning the ignition key to MARthe
warning light turns on, but it should go off
after few seconds.
The warning light turns on when there is
water in the diesel fuel filter.
The display will show the dedicated mes-
sage.
c
The presence of water in the
fuel circuit may cause serious
damage to the entire injection
system and cause irregular en-
gine operation. If the warning light
cturns on (together with the message on
the display), contact Fiat Dealership as
soon as possible to have the system re-
lieved. If the above indications come on
immediately after refuelling, water has
probably been poured into the tank:
turn the engine off immediately and
contact Fiat Dealership.
EBD SYSTEM
FAILURE
(red)
(amber)
The turning on at the same time of warn-
ing lights
xand >with the engine run-
ning indicates an EBD system failure or
that the system is unavailable; in this case
heavy braking may cause the rear wheels
to lock before time, with the possibility of
skidding.
Drive with the utmost care to the near-
est Fiat Dealership to have the system
checked.
The display will show the dedicated mes-
sage. ABS SYSTEM FAILURE
(amber)
Turning the ignition key to
MARthe warning light turns on,
but it should go off after few seconds.
The warning light turns on when the sys-
tem is inefficient or unavailable. In this case
the braking system keeps its effectiveness
unchanged, but without the potential of-
fered by the ABS system.
Caution is advisable and it is necessary to
contact Fiat Dealership.
The display will show the dedicated mes-
sage.
>x>
141-154 BRAVO GB 10-05-2007 9:17 Pagina 150

166
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
FOR CHECKING AND
RESTORING PRESSURE ONLY
The compressor can be also used just for
restoring pressure. Disconnect the quick
connection and connect it directly to the
tyre valve fig. 16; in this way the cylinder
is not connected to compressor and the
sealing fluid will not flow into the tyre. CYLINDER REPLACEMENT
PROCEDURE
To replace the cylinder proceed as fol-
lows:
❒disconnect connection B-fig. 17;
❒turn counter-clockwise the cylinder to
replace and raise it;
❒fit the new cylinder and turn it clock-
wise;
❒connect connection Bto the cylinder
and fit the transparent tube Ainto the
proper space.
fig. 16F0Q0517mfig. 17F0Q0512m
❒if at least 1.8 bar pressure is read, re-
store proper pressure (with engine
running and handbrake on) and restart;
❒drive with the utmost care to the near-
est Fiat Dealership.
It is of vital importance to
communicate that the tyre
has been repaired using the quick tyre
repair kit. Hand the instruction
brochure to the personnel charged
with treating the tyre repaired with
the kit.
WARNING
If the pressure falls below 1.8
bars, do not drive any fur-
ther: the quick tyre repair kit Fix & Go
automatic cannot guarantee proper
hold because the tyre is too much
damaged. Contact Fiat Dealership.
WARNING
155-190 BRAVO GB 10-05-2007 9:19 Pagina 166

168
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
F0Q0391m
C Tubular bulbs: free them from their
contacts to remove.
D-E Halogen bulbs: to remove the bulb,
release the clip holding the bulb in
place.
F Gas-discharge bulbs (Bi-Xenon).
fig. 18
TYPES OF BULBS fig. 18
Various types of bulbs are fitted to your
car:
A All glass bulbs: these are pressed on.
Pull to remove.
B Bayonet type bulbs: press the bulb,
turn counterclockwise to remove this
type of bulb from its holder.
155-190 BRAVO GB 10-05-2007 9:19 Pagina 168

171
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
SIDELIGHTS
To change the bulb, proceed as follows:
❒remove the protective cover A-fig. 19;
❒turn the bulb holder A-fig. 21coun-
terclockwise and then withdraw it;
❒remove the bulb Band replace it;
❒fit the new bulb, refit the bulb holder
A-fig. 21 and then refit the protective
coverB-fig. 19correctly.MAIN BEAM HEADLIGHTS
To change the bulb, proceed as follows:
❒remove the protective cover A-fig. 19;
❒release the bulb holder catch A-fig. 22;
❒remove the bulb Cand replace it;
❒fit the new bulb, making the tabs of the
metallic part coincide with the grooves
on the reflector, reconnect the electri-
cal connector Bthen hook the bulb
holder catch A;
❒refit the protective cover B-fig. 19cor-
rectly.
fig. 21F0Q0706mfig. 22F0Q0707mfig. 23F0Q0708m
DIRECTION INDICATORS
Front
To change the bulb, proceed as follows:
❒turn the protective cover C-fig. 19
counterclockwise;
❒remove the bulb B-fig. 23and replace
it;
❒refit the protective cover Acorrectly.
155-190 BRAVO GB 10-05-2007 9:19 Pagina 171

172
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
REAR LIGHT UNITS fig. 26
Rear light units contain taillights, direction
indicators and brake light (stop) bulbs.
The bulbs are arranged inside the light unit
fig. 26as follows:
B taillights/brake light (double light);
C direction indicators. Side
To change the bulb, proceed as follows:
❒push the transparent cover A-fig. 24
to compress the internal catch B, then
remove the unit;
❒turn the bulb holder C counterclock-
wise, remove the snap-fitted bulb D
and replace it;
❒refit the bulb holder Cin the lens by
turning it clockwise;
❒refit the unit making sure the catch
clicks into place B.FRONT FOG LIGHTS fig. 25
(where provided)
Contact Fiat Dealership to have front fog
lights replaced.
fig. 24F0Q0709mfig. 25F0Q0710mfig. 26F0Q0714m
155-190 BRAVO GB 10-05-2007 9:19 Pagina 172

174
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
NUMBER PLATE LIGHTS
To change the bulb proceed as follows:
❒work in the point shown by the arrow
and remove lens unit A-fig. 34;
❒turn the bulb holder B-fig. 35clock-
wise;
❒remove the bulb C and replace it. THIRD BRAKE LIGHT
To change the bulb proceed as follows:
❒open the tailgate;
❒remove cover A-fig. 32;
❒remove the lens unit B-fig. 33and dis-
connect the electric connector;
❒press the tabs C-fig. 33and remove
the bulb holder;
❒remove the snap-fitted bulb and replace
it.
❒refit cover A-fig. 32and then close the
tailgate.
fig. 33F0Q0751m
fig. 32F0Q0716m
fig. 34F0Q0718m
fig. 35F0Q0719m
155-190 BRAVO GB 10-05-2007 9:19 Pagina 174