2007 FIAT BRAVO fuel

184
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
COMPONENTS FUSE AMPERE FIGURE
Fuel motor pump on tank F21 15 51
Engine diagnosis system primary loads (injectors, ignition coils) F22 15 51
Engine diagnosis system primary loads
(injectors, ignition coils, engine control unit for diesel versions) F22 20 51
Braking system control unit (NFR) (electronic control unit, solenoid valves) F23 30 51
Electric steering control unit (NGE) F24 7.5 51
Remote switch coils on fuse box in engine compartment (CVM)/
Body Computer control unit (NBC) F31 5 49
Hi-Fi system subwoofer F32 15 49
Rear left power window F33 20 49
Rear right power window F34 20 49
Brake pedal control (normally closed contact NC)/
water in diesel fuel sensor/flow meter F35 5 49
155-190 BRAVO GB 10-05-2007 9:19 Pagina 184

193
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
SERVICE SCHEDULE
30 60 90 120 150 180
●● ● ●● ●
●● ● ●● ●
●● ● ●● ●
●● ● ●● ●
●● ● ●● ●
●●●
●● ● ●● ●
●● ● ●● ●
●● ● ●● ●
●●●
●●
●●
●●
●●●
Thousands of km
Check tyre conditions/wear and adjust pressure if necessary
Check lighting system operation (headlights, direction indicators,
hazard lights, luggage compartment lights, passenger
compartment lights, glove compartment lights, instrument
panel warning lights, etc.)
Check operation of windscreen wiper system and
adjust sprays if necessary
Check position/wear of front/rear windscreen wiper blades
Check condition and wear of front disc brake pads and
operation of pad wear indicator
Check conditions and wear of rear disc brake pads
Visually check that the following are in good condition
and intact: body exterior, under body protection,
pipe rigid and flexible sections (exhaust-fuel system-brakes),
rubber parts (gaiters, sleeves, bushes, etc.)
Check cleanliness of locks, bonnet, engine and boot,
clean and lubricate linkages
Check and top-up fluids (hydraulic brakes/clutch,
windscreen washer, battery, engine coolant, etc.)
Check and adjust handbrake lever travel
Check visually conditions of auxiliary drive belt/s
Visually check conditions of toothed timing belt
(1.4 16V, 1.4 T-JET,1.9 Multijet 8V versions)
Check tension and adjust auxiliary drive belt
(except for engines with automatic tensioners)
Check and adjust tappet clearance (1.9 Multijet 8V version)
191-212 BRAVO GB 10-05-2007 9:21 Pagina 193

194
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
Thousands of km
Check exhaust emissions (petrol versions)
Check emissions/fumes (diesel versions)
Check evaporation control system (petrol versions)
Check operation of engine control systems
(by means of test interface)
Replace accessory drive belt/s
Replace toothed timing belt (petrol versions) (*)
Replace toothed timing belt (1.9 Multijet 8Vversions) (*)
Replace toothed timing belt (1.9 Multijet 16Vversions) (*)
Replace spark plugs (petrol versions)
Replace fuel filter (diesel versions)
Replace air filter cartridge (petrol versions)
Replace air filter cartridge (diesel versions)
Replace engine oil and oil filter (petrol versions)
(or every 24 months)
Change engine oil and oil filter (diesel versions without DPF)
(or every 24 months)
Change engine oil and oil filter (diesel versions with DPF) (**)
Change brake fluid (or every 24 months)
Change pollen filter (or every 12 months)
(*) Irrespective of mileage, the timing drive belt must be replace every 4 years for heavy duty applications, cold climates, town use, long
periods idling) or at least every 5 years.
(**)The engine oil and oil filter should be changed depending on their actual condition, which is indicated by a warning light/message on the
control panel or at least every 2 years.
For 1.4 T-JET 150 HP version, in order to ensure correct operation and avoid significant damages to the engine, it is mandatory:
- to use spark plugs specifically certified for the T-JET engine only, of the same type and brand (see paragraph “Engine”);
- to replace the plugs as often as required by the Programmed Maintenance Plan;
- we recommend to refer to the Fiat Dealership.
If the car is used mainly on urban routes or if the yearly kilometres travelled are less than 10,000 km, the engine oil and filter must be changed every 12 months.
30 60 90 120 150 180
●● ● ●● ●
●● ● ●● ●
●●
●● ● ●● ●
●
●
●
●
●● ● ●● ●
●●●
●●●
●●●
●● ● ●● ●
●● ● ●● ●
●●●
●● ● ●● ●
191-212 BRAVO GB 10-05-2007 9:21 Pagina 194

195
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
ROUTINE
MAINTENANCE
Every 1,000 km or before long journeys,
check and top up if required:
❒engine coolant fluid level;
❒brake fluid level;
❒windscreen washer fluid level;
❒tyre pressure and conditions;
❒light system operation (headlights, di-
rection indicators, hazard lights, etc.);
❒windscreen wiper/washer operation
and windscreen/rear window blade
position/wear;
Every 3,000 km check and top up if re-
quired: engine oil level.
You are recommended to use FL Sele-
nia, products, designed and produced
specifically for Fiat cars (see table “Ca-
pacities” in section “Technical specifica-
tions”).
HEAVY-DUTY
Should prevailing use of the car be under
one of the following specially heavy con-
ditions:
❒trailer or caravan towing;
❒dusty roads;
❒short distances (less than 7-8 km) re-
peated and with external tempera-
tures below zero;
❒frequently idling engines or long dis-
tance low speed driving (e.g. door-to-
door deliveries) or in case of a long
term inactivity;
❒driving in the city;
carry out the following checks more fre-
quently than required in the Service
Schedule:
❒check front disk brake pad conditions
and wear;
❒check cleanness of locks, bonnet and
boot and lever cleanness and lubrica-
tion;
❒sight inspect the conditions of: engine,
gearbox, transmission, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.);
❒check battery charge and fluid level
(electrolyte) (only to be carried out by
skilled personnel or at Fiat Dealership
– see also paragraph “Battery” in this
section);
❒visual check on various drive belt con-
ditions;
❒check and replace pollen filter, if re-
quired;
❒check and replace air cleaner, if re-
quired.
191-212 BRAVO GB 10-05-2007 9:21 Pagina 195

205
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
RUBBER HOSES
As far as the brake system and fuel rubber
hoses are concerned, carefully follow the
“Service schedule” in this section.
Indeed ozone, high temperatures and pro-
longed lack of fluid in the system may
cause hardening and cracking of the hoses,
with possible leaks. Careful control is
therefore necessary.Remember that road holding
depends also on the correct
tyre inflating pressure.
WARNING
If the pressure is too low the
tyre overheats and this can
cause it serious damage.
WARNING
Do not cross switch the
tyres, moving them from the
right of the car to the left and vice
versa.
WARNING
Never submit alloy rims to
repainting treatments re-
quiring to use temperatures exceed-
ing 150°C since the mechanical prop-
erties of the wheels could be im-
paired.
WARNING
191-212 BRAVO GB 10-05-2007 9:21 Pagina 205

213
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
TECHNICAL
SPECIFICATIONS
IDENTIFICATION DATA ................................................... 214
ENGINE CODES - BODYWORK VERSIONS .............. 216
ENGINE .................................................................................... 217
FUEL FEED/IGNITION ........................................................ 218
TRANSMISSION .................................................................... 218
BRAKES ..................................................................................... 219
SUSPENSIONS......................................................................... 219
STEERING ................................................................................. 219
WHEELS .................................................................................... 220
DIMENSIONS .......................................................................... 224
PERFORMANCE ..................................................................... 225
WEIGHTS ................................................................................. 226
CAPACITIES ........................................................................... 227
FLUIDS AND LUBRICANTS ............................................... 228
FUEL CONSUMPTION ........................................................ 230
CO
2EMISSIONS .................................................................... 231
RADIO FREQUENCY REMOTE CONTROL:
MINISTERIAL HOMOLOGATION .................................. 232
T T
E E
C C
H H
N N
I I
C C
A A
L L
S S
P P
E E
C C
I I
F F
I I
C C
A A
T T
I I
O O
N N
S S
213-236 BRAVO GB 16-05-2007 10:11 Pagina 213

1.9
Multijet 8V
192A8000
Diesel
4 in line
82.0 x 90.4
1910
18
88
120
4000
255
26
2000
–
Diesel fuel for
motor vehicles
(Specification
EN590)
217
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
TECHNICAL
SPECIFICATIONS
1.4 16V
192B2000
Otto
4 in line
72.0 x 84.0
1368
11
66
90
5500
128
13
4500
NGK
DCPR7E-N-10
Unleaded
petrol
95 RON
(Specification
EN228)
1.9
Multijet 16V
937A5000
Diesel
4 in line
82.0 x 90.4
1910
17.5
110
150
4000
305
31
2000
–
Diesel fuel for
motor vehicles
(Specification
EN590)
1.9
Multijet 8V (●)
192B5000
Diesel
4 in line
82.0 x 90.4
1910
18
66
90
4000
255
26
2000
–
Diesel fuel for
motor vehicles
(Specification
EN590)
1.9
Multijet 8V (●)
192B4000
Diesel
4 in line
82.0 x 90.4
1910
18
85
115
4000
255
26
2000
–
Diesel fuel for
motor vehicles
(Specification
EN590)
1.4 T-JET
150 HP
198A1000
Otto
4
in line
72.0 x 84.0
1368
9.8
110
150
5500
206
21
2250
NGK
IKR9F8
Unleaded
petrol
95 RON
(Specification
EN228)
ENGINE
GENERAL
Engine code
Cycle
Number and layout of cylinders
Piston bore and stroke mm
Total displacement cm3
Compression ratio
Maximum power (EEC) kW
HP
corresponding ratio rpm
Maximum torque (EEC) Nm
kgm
corresponding ratio rpm
Spark plugs
Fuel
(●)Versions for specific markets
213-236 BRAVO GB 16-05-2007 10:11 Pagina 217

218
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
TECHNICAL
SPECIFICATIONSDASHBOARD
AND CONTROLSModifications or repairs to the fuel system that are not carried out properly or do not take the system’s techni-
cal specifications into account can cause malfunctions leading to the risk of fire.
Six forward gears
and reverse
with synchromesh for
forward gear
engagement
Self-adjusting pedal
without idle
stroke
FrontFive forward gears
and reverse
with synchromesh for
forward gear
engagement
Self-adjusting pedal
without idle
stroke
Front
FUEL FEED/IGNITION
1.4 16V1.4 T-JET 150 HP 1.9 Multijet 8V1.9 Multijet 16V
Fuel feed Multipoint sequential Multipoint sequential phased Direct injection with
phased electronic injection electronic injection with electronically controlled
returnless system turbosupercharger Multijet “Common Rail”
and intercooler turbosupercharger
and intercooler
TRANSMISSION
1.4 16V- 1.4 T-JET 150 HP - 1.9 Multijet 16V1.9 Multijet 8V
Gearbox
Clutch
Drive
213-236 BRAVO GB 16-05-2007 10:11 Pagina 218