2007 DODGE NITRO lights

Follow the shift pattern on the gearshift knob.
NOTE:The backup lights will come on when your
vehicle is in R (Reverse) gear and the ignition is in the ON
position.WARNING!
When parking your vehicle, always leave a manual
transmission in first gear and apply the parking
brake fully to guard against vehicle movement and
possible injury or damage. Never use any gear as a
substitute for the parking brake.
CAUTION!
To drive as safely as possible and to prolong the life
of your manual transmission, follow these tips:
•Before shifting from a forward gear into reverse, or
from reverse to a forward gear, stop vehicle com-
pletely. Otherwise, accelerated transmission wear may
result.
Manual Shift Controls
244 STARTING AND OPERATING

Trailer brakes are recommended for trailers over 1,000
lbs (454 kg) and required for trailers in excess of 2,000
lbs (907 kg).
CAUTION!
If the trailer weighs more than 1,000 lbs (454 kg)
loaded, it should have its own brakes and they
should be of adequate capacity. Failure to do this
could lead to accelerated brake lining wear, higher
brake pedal effort, and longer stopping distances.
WARNING!
Do not connect trailer brakes to your vehicle’s hy-
draulic brake lines. It can overload your brake sys-
tem and cause it to fail. You might not have brakes
when you need them and could have an accident.
Towing any trailer will increase your stopping dis-
tance. When towing you should allow for additional
space between your vehicle and the vehicle in front
of you. Failure to do so could result in an accident.
Towing Requirements — Trailer Lights & Wiring
Whenever you pull a trailer, regardless of the trailer size,
stop lights and turn signals on the trailer are required for
motoring safety.
The Trailer Tow Package may includea4and7pin
wiring harness. Use a factory approved trailer harness
and connector.
318 STARTING AND OPERATING

▫Rear Tail, Stop, Turn Signal, And
Back-Up Lights.......................381
▫Center High Mounted Stop Light (CHMSL) . . . 381

Fluid Capacities........................382
Fluids, Lubricants And Genuine Parts........383
▫Engine.............................383
▫Chassis............................384
MAINTAINING YOUR VEHICLE 337
7

CAUTION!
•When installing the Integrated Power Module
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the Integrated Power
Module, and possibly result in a electrical system
failure.
•When replacing a blown fuse, it is important to
use only a fuse having the correct amperage
rating. The use of a fuse with a rating other than
indicated may result in a dangerous electrical
system overload. If a properly rated fuse contin-
ues to blow, it indicates a problem in the circuit
that must be corrected.
REPLACEMENT LIGHT BULBS
LIGHT BULBS — Interior Bulb No.
Dome Light........................ WL212–2
Liftgate Lamp........................... 567
Overhead Console Lights............. PLW214–2A
Reading Light....................... WL212–2
LIGHT BULBS — Outside Bulb No.
Headlight..........................9008 H13
Front Park/Turn......................3157AK
Front Sidemarker......................... 168
Back-Up.............................4057K
Center High Mounted Stoplight.............. 921
Fog Lamp.......................... H109145
License Plate Light....................... 168
Rear Tail, Stop, Turn Signal................4057K
378 MAINTAINING YOUR VEHICLE

Rear Tail, Stop, Turn Signal, and Back-Up Lights
1. Open the lift gate.
2. Remove the two push pins.
3. Pull lamp straight back and disconnect electrical con-
nection.
4. Remove the two screws attaching the backplate to the
lamp assembly.
5. Pull the backplate straight back from the lamp hous-
ing.
6. Disconnect the electrical connector.
7. Remove the bulb from the backplate.
Center High Mounted Stop Light (CHMSL)
1. Remove the two screws securing the CHMSL.
2. Disconnect the electrical connector and washer hose (if
equipped) from CHMSL.
3. Replace the CHMSL.
MAINTAINING YOUR VEHICLE 381
7

Once a Month
•Check the tire pressure and look for unusual wear or
damage.
•Inspect the battery and clean and tighten the terminals
as required.
•Check the fluid levels of the coolant reservoir, brake
master cylinder, and transmission, and add as needed.
•Check all lights and all other electrical items for correct
operation.
At Each Oil Change
•Change the engine oil filter.
•Inspect the exhaust system.
•Inspect brake hoses.
•Inspect the CV joints (If equipped) and front suspen-
sion components.
•Check the coolant level, hoses, and clamps.
•After completion of off-road operation, the underside
of the vehicle should be thoroughly inspected. Exam-
ine threaded fasteners for looseness.
388 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Selection of Coolant (Antifreeze)......356,382,383
Temperature Gauge..................... 164
Corrosion Protection..................... 366
Crankcase Emission Control System.......... 350
CupHolder ............................ 147
Customer Assistance..................... 412
Data Recorder, Event...................... 61
Daytime Running Lights................... 122
Dealer Service.......................... 343
Defroster, Rear Window................... 156
Defroster, Windshield................ 76,230,231
Delay (Intermittent) Wipers................. 122
Diagnostic System, Onboard................ 340
Dimmer Switch, Headlight..............120,166
Dipsticks
Oil (Engine).......................... 343
Disposal
Engine Oil........................... 346Used Coolant (Antifreeze)................ 358
Door Locks............................. 27
Door Locks, Automatic.................... 30
Door Opener, Garage..................... 134
DriveBelts ............................ 347
Driving ............................... 262
DVD Player (Video Entertainment System)...... 225
Electric Remote Mirrors.................... 83
Electrical Outlet, Auxiliary (Power Outlet)...... 144
Electrical Power Outlets................... 144
Electronic Brake Control System............. 128
Electronic Speed Control (Cruise Control)...... 125
Electronic Stability Program (ESP).........131,166
Electronic Vehicle Information Center (EVIC).... 179
Emergency, In Case of
Hazard Warning Flasher................. 324
Jacking............................. 326
Towing ............................. 334
INDEX 423
10

Flooded Engine Starting................... 240
Fluid, Brake........................... 384
Fluid Capacities......................... 382
Fluid Leaks............................. 76
Fluid Level Checks...................... 366
Automatic Transmission................. 363
Engine Oil........................... 343
Manual Transmission................... 364
Power Steering........................ 352
Fluids, Lubricants and Genuine Parts.......... 383
Fog Light Service........................ 380
Fog Lights..........................121,380
Folding Rear Seat........................ 115
Four Wheel Drive....................... 259
Operation........................... 259
Systems............................. 259
Four Wheel Drive Operation................ 259
Four-Way Hazard Flasher.................. 324
Front Axle (Differential)................... 366Fuel................................. 296
Filler Cap (Gas Cap).................... 300
Filter ............................... 350
Gasoline............................ 296
Gauge.............................. 164
Materials Added....................... 298
Octane Rating......................296,383
Requirements......................... 382
Tank Capacity........................ 382
Fuel System Caution................298,301,302
Fuses................................ 371
Garage Door Opener (HomeLink) ........... 134
Gas Cap (Fuel Filler Cap)............300,302,340
Gas Gauge (Fuel Gauge)................... 164
Gasoline (Fuel)......................... 296
Gasoline, Reformulated................... 297
Gasoline/Oxygenate Blends................ 297
INDEX 425
10