Page 345 of 475

JACKING AND TIRE CHANGING
WARNING!
•Being under a jacked-up vehicle is dangerous.
The vehicle could slip off the jack and fall on you.
You could be crushed. Never put any part of your
body under a vehicle that is on a jack. Never start
or run the engine while the vehicle is on a jack. If
you need to get under a raised vehicle, take it to a
service center where it can be raised on a lift.
•The jack is designed to use as a tool for changing
tires only. The jack should not be used to lift the
vehicle for service purposes. The vehicle should
be jacked on a firm level surface only. Avoid ice or
slippery areas.
Jack Location
The scissor jack and tire changing tools are stowed under
the second row seat.
The jack is secured in place with a winged stud and a
fixed stud. It is very important to secure the jack tightly
in place by engaging the slot in the base to the fixed stud
under the middle seat. The winged stud inserts through
the eyelet in the end of the jack’s worm screw.
WHAT TO DO IN EMERGENCIES 345
6
Page 352 of 475

WARNING!
Carefully follow these tire changing warnings to help prevent
personal injury or damage to your vehicle:
•Always park on a firm, level surface as far from the edge of
the roadway as possible before raising the vehicle.
•Block the wheel diagonally opposite the wheel to be
raised.
•Apply the parking brake firmly before jacking.
•Never start the engine with the vehicle on a jack.
•Do not let anyone sit in the vehicle when it is on a jack.
•Do not get under the vehicle when it is on a jack.
•Only use the jack in the positions indicated.
•If working on or near a roadway, be extremely careful of
motor traffic.
•To assure that spare tires, flat or inflated are securely
stowed, spares must be stowed with the value stem facing
the ground.
To Stow The Flat Or Spare
Turn the wheel so that the valve stem is down. Slide the
wheel retainer through the center of the wheel and
position it properly across the wheel opening.
For convenience in checking the spare tire inflation, stow
with the valve stem toward the rear of the vehicle.
Rotate the winch mechanism until the wheel is drawn
into place against the underside of the vehicle. Continue
to rotate until you feel the winch mechanism slip or click
2 times. It cannot be overtightened. Push against the tire
several times to be sure it is firmly in place.
352 WHAT TO DO IN EMERGENCIES
Page 386 of 475

•Do not change the thermostat for summer or winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs may
result in unsatisfactory coolant performance, poor gas
mileage, and increased emissions.
Emission Related Components
Fuel System Hoses And Vapor/Vacuum Harnesses
When the vehicle is serviced for scheduled maintenance,
inspect surface of hoses and nylon tubing for evidence of
heat and mechanical damage. Hard and brittle rubber,
cracking, checking, tears, cuts, abrasions, and excessive
swelling suggest deterioration of the rubber. Particular
attention should be given to examining hose surfaces
nearest to high heat sources, such as the exhaust mani-
fold.
Insure nylon tubing in these areas has not melted or
collapsed.Inspect all hose clamps and couplings to make sure they
are secure and no leaks are present.
NOTE:Fluids such as oil, power steering fluid, and
brake fluid are used during assembly plant operations to
ease the assembly of hoses to couplings. Therefore, oil
wetness at the hose-coupling area is not necessarily an
indication of leakage. Actual dripping of hot fluid when
systems are under pressure (during vehicle operation),
should be noted before hose is replaced based on leakage.
You are urged to use only the manufacturer’s specified
hoses and clamps, or their equivalent in material and
specification, in any fuel system servicing. It is manda-
tory to replace all clamps that have been loosened or
removed during service. Care should be taken in install-
ing new clamps to insure they are properly torqued.
386 MAINTAINING YOUR VEHICLE
Page 413 of 475
License Lights
1. Remove the two screws securing the lens to the
liftgate.
MAINTAINING YOUR VEHICLE 413
7
Page 414 of 475
2. Rotate the socket 1/4 turn counterclockwise.
3. Pull bulb from socket.Center High-Mounted Stoplight
1. Remove two screws securing stoplight housing assem-
bly to the liftgate.
414 MAINTAINING YOUR VEHICLE
Page 458 of 475

ABS (Anti-Lock Brake System)............188,271
Adding Fuel........................... 314
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 372
Air Conditioner Maintenance............230,375
Air Conditioning........................ 230
Air Conditioning, Operating Tips............ 242
Air Conditioning, Rear Zone................ 234
Air Conditioning Refrigerant.............375,377
Air Conditioning System................230,375
AirFilter .....................360,361,362,372
Air Pressure, Tires....................294,303
Airbag............................. 51,194
Airbag Light.......................... 59,73
Alarm, Panic............................ 22
Alarm (Security Alarm)................. 17,188
Alignment and Balance................... 302
Alterations/Modifications, Vehicle............. 8
Antenna, Satellite Radio................... 226
Antifreeze (Engine Coolant)...........382,383,417Disposal............................ 384
Anti-Lock Brake System (ABS)............271,275
Anti-Lock Warning Light.................. 188
Anti-Theft System..................... 17,188
Appearance Care........................ 393
Arming Theft System (Security Alarm)......... 18
AutomaticDimmingMirror ............... 80,83
Automatic Door Locks..................... 28
Automatic Headlights.................... 133
Automatic Transaxle.................... 12,254
Automatic Transmission.............251,254,389
Adding Fluid......................... 389
Fluid and Filter Changes................. 390
Fluid Level Check...................... 389
FluidType ........................390,419
Gear Ranges.......................... 254
Special Additives...................... 391
Torque Converter...................... 258
AxleFluid ............................. 419
458 INDEX
Page 471 of 475

Seat Belt Reminder....................... 48
Seat Belts.......................... 38,39,73
And Pregnant Women................... 50
Child Restraint....................... 62,63
Extender............................. 50
Front Seat............................ 39
Pretensioners.......................... 48
Reminder............................ 186
Seats................................. 108
Adjustment.......................... 108
Cleaning............................ 395
Fold and Tumble Rear................ 115,117
Heated.............................. 112
Lumbar Support....................... 110
Memory............................. 124
Rear Folding....................... 115,117
Reclining ............................ 109
Security Alarm (Theft Alarm)............. 17,188
Selection of Coolant (Antifreeze)..........382,418Selection of Oil......................... 369
Sentry Key (Immobilizer)................... 15
Service and Maintenance................366,422
Service Assistance....................... 448
Service Contract......................... 450
Service Manuals........................ 452
Setting the Clock................195,199,207,219
Settings, Personal........................ 155
Shifting
Automatic Transmission................. 254
Transfer Case......................... 259
Transfer Case, Shifting into Transfer
Case Neutral (N)........................ 338
Transfer Case, Shifting out of Transfer
Case Neutral (N)........................ 340
Shoulder Belt Upper Anchorage.............. 44
Shoulder Belts........................... 39
Signals, Turn.....................135,185,409
Snow Chains (Tire Chains)................. 303
INDEX 471
10