2007 DODGE CHARGER SRT fuel cap

Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
ªCheck Gascapº message will display in the Electronic
Vehicle Information Center (EVIC). If this occurs, tighten
the fuel filler cap properly and press the odometer reset
button to turn off the message. If the problem continues,
the message will appear the next time the vehicle is
started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
Refer to ªOnboard Diagnostic Systemº in Section 7 of this
manual for more information.
VEHICLE LOADING
The load carrying capacity of your vehicle is shown on
the ªVehicle Certification Label.º This information
should be used for passenger and luggage loading as
indicated.
If the seatbacks are folded for carrying cargo, do not
exceed the specified GVWR and GAWR.
Vehicle Certification Label
Your vehicle has a certification label attached to the rear
of the driver's door.
The label contains the following information:
²Name of manufacturer
²Month and year of manufacture
²Gross Vehicle Weight Rating (GVWR)
²Gross Axle Weight Rating (GAWR) front
²Gross Axle Weight Rating (GAWR) rear
²Vehicle Identification Number (VIN)
²Type of Vehicle
STARTING AND OPERATING 243
5

MAINTAINING YOUR VEHICLE
CONTENTS
m6.1L Engine Compartment...............263
mOnboard Diagnostic System Ð OBD II......264
NLoose Fuel Filler Cap..................264
mEmissions Inspection And Maintenance
Programs
............................265
mReplacement Parts.....................266
mDealer Service........................266
mMaintenance Procedures.................267
NEngine Oil..........................267
NEngine Oil Filter......................270
NDrive Belts Ð Check Condition And Tension . . 270
NSpark Plugs.........................270NEngine Air Cleaner Filter................271
NFuel Filter..........................271
NCatalytic Converter....................271
NMaintenance-Free Battery................273
NAir Conditioner Maintenance.............274
NA/C Air Filter Ð If Equipped............275
NPower Steering Ð Fluid Check............276
NFront & Rear Suspension Ball Joints........276
NSteering Linkage......................276
NBody Lubrication.....................276
NWindshield Wiper Blades................277
7

NWindshield Washers...................277
NExhaust System......................278
NCooling System.......................278
NHoses And Vacuum/Vapor Harnesses.......283
NFuel System.........................283
NBrake System........................284
NAutomatic Transmission................286
NFront And Rear Wheel Bearings...........287
NAppearance Care And Protection From
Corrosion...........................287
NCleaning The Center Console Cup Holders . . . 291
mFuses (Power Distribution Centers).........291
NFuses (Front Power Distribution Center).....291
NFuses (Rear Power Distribution Center)......293
mVehicle Storage........................297
mReplacement Light Bulbs................298
mBulb Replacement......................299
NLow Beam Headlight, High Beam
Headlight, Park/Turn Light, And Front Side
Marker Light........................299
NBackup Light, Side Marker Light, Tail/Turn
Light, And Tail/Stop Light...............301
NLicense Light........................304
mFluids And Capacities...................304
mFluids, Lubricants, And Genuine Parts......305
NEngine.............................305
NChassis............................306
262 MAINTAINING YOUR VEHICLE

ONBOARD DIAGNOSTIC SYSTEM Ð OBD II
Your vehicle is equipped with a sophisticated onboard
diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and automatic
transmission control systems. When these systems are
operating properly, your vehicle will provide excellent
performance and fuel economy, as well as engine emis-
sions well within current government regulations.
If any of these systems require service, the OBD II system
will turn on the ªMalfunction Indicator Light.º It will
also store diagnostic codes and other information to
assist your service technician in making repairs. Al-
though your vehicle will usually be drivable and not
need towing, see your dealer for service as soon as
possible.CAUTION!
Prolonged driving with the ªMalfunction Indicator
Lightº on could cause further damage to the emis-
sion control system. It could also affect fuel economy
and driveability. The vehicle must be serviced before
any emissions tests can be performed.
If the ªMalfunction Indicator Lightº is flashing
while the engine is running, severe catalytic con-
verter damage and power loss will soon occur. Im-
mediate service is required.
Loose Fuel Filler Cap
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
ªCheck Gascapº message will display in the Electronic
Vehicle Information Center (EVIC) Ð if equipped. If this
occurs, tighten the fuel filler cap properly and press the
odometer reset button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.
264 MAINTAINING YOUR VEHICLE

A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle's emissions control system.
Failure to pass could prevent vehicle registration.
For states, which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.Your vehicle has a simple ignition key actuated test,
which you can use prior to going to the test station. To
check if your vehicle's OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off
the ignition key or start the engine. This means that
your vehicle's OBD system isnot readyand you
shouldnotproceed to the I/M station.
MAINTAINING YOUR VEHICLE 265
7

License Light
1. Remove the screws securing the light to the rear fascia.
2. Remove the bulb and socket assembly.
3. Pull the bulb out of the socket assembly.
4. Push the replacement bulb into the socket assembly.
5. Reinstall the bulb and socket assembly.6. Reattach the light to the rear fascia, and then install the
screws.
FLUIDS AND CAPACITIES
U.S. Metric
Fuel (approximate)
6.1 Liter Engine 19 gal-
lons72 liters
Engine Oil with Filter
6.1 Liter Engine (SAE 0W-40) 7 qts. 6.6 liters
Cooling System *
6.1 Liter Engine (Mopart
Antifreeze/Coolant 5 Year/
100,000 Mile Formula) or
equivalent.15.2 qts 14.4 li-
ters
* Includes heater and coolant recovery bottle filled to
MAX level.
1 Ð License Light Bulb
2 Ð Socket 304 MAINTAINING YOUR VEHICLE

Fluid Type.......................... 306
Shifting............................ 196
Special Additives..................... 287
Autostick..........................198,200
Ball Joints............................ 276
Battery............................... 273
Emergency Starting.................... 254
Jump Starting........................ 254
Keyless Transmitter Replacement (RKE)..... 19
Location.........................255,273
Bearings.............................. 287
Belts, Drive........................... 270
Belts, Seat............................. 29
Body Mechanism Lubrication.............. 276
B-Pillar Location....................... 217
Brake Assist System..................... 209
Brake Control System, Electronic........... 208
Brake, Parking......................... 203
Brake System.......................204,284
Anti-Lock (ABS)...................204,208
Fluid Check......................285,306
Hoses.............................. 284Master Cylinder...................... 285
Parking............................ 203
Warning Light....................128,204
Brakes............................... 204
Brake/Transmission Interlock.............. 195
Break-In Recommendations, New Vehicle...... 54
Bulb Replacement...................... 299
Bulbs, Light........................... 298
Calibration, Compass.................... 136
Capacities, Fluid....................... 304
Caps, Filler
Fuel............................... 240
Oil (Engine)......................... 269
Radiator (Coolant Pressure).............. 281
Car Washes........................... 288
Carbon Monoxide Warning.............55,240
Cassette Tape and Player Maintenance....... 173
Catalytic Converter..................... 271
CD (Compact Disc) Player.............144,151
Cellular Phone.......................... 65
Chains, Tire........................... 227
Chart, Tire Sizing....................... 214
INDEX 337
10

Door Locks............................ 20
Door Locks, Automatic................... 22
Door Opener, Garage.................... 104
Drive Belts............................ 270
Driving
On Slippery Surfaces.................. 202
DVD Player (Video Entertainment System).... 166
Electric Remote Mirrors................... 64
Electrical Power Outlets.................. 112
Electronic Brake Control System............ 208
Electronic Speed Control (Cruise Control)..... 100
Electronic Stability Program (ESP).......... 209
Electronic Throttle Control Warning Light..... 124
Electronic Vehicle Information Center (EVIC) . . 132
Emergency, In Case of
Freeing Vehicle When Stuck............. 257
Hazard Warning Flasher................ 248
Jump Starting........................ 254
Overheating......................... 248
Towing............................. 258
Emission Control System Maintenance....265,308
Engine............................... 263Air Cleaner.......................... 271
Block Heater......................... 192
Break-In Recommendations............... 54
Checking Oil Level.................... 267
Compartment........................ 263
Coolant (Antifreeze)................278,305
Cooling............................ 278
Exhaust Gas Caution................55,240
Fails to Start......................... 191
Flooded, Starting..................... 191
Fuel Requirements.................237,304
Oil ..........................267,304,305
Oil Change Interval................... 268
Oil Filler Cap........................ 269
Oil Selection......................269,304
Overheating......................... 248
Temperature Gauge................... 125
Enhanced Accident Response Feature......... 44
Ethanol.............................. 238
Event Data Recorder..................... 45
Exhaust Gas Caution.............55,56,240,278
Exhaust System......................55,278
Exterior Folding Mirrors.................. 63
INDEX 339
10