Page 426 of 520

NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
WARNING!
A hot exhaust system can start a fire if you park over
materials that can burn. Such materials might be
grass or leaves coming into contact with your ex-
haust system. Do not park or operate your vehicle in
areas where your exhaust system can contact any-
thing that can burn.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may indicate severe
and abnormal catalyst overheating. If this occurs, the
vehicle should be stopped, the engine shut off and the
vehicle allowed to cool. Thereafter, service, including a
tune-up to manufacturer’s specifications, should be ob-
tained immediately.
To minimize the possibility of catalyst damage:
•Do not shut off the engine or interrupt the ignition
when the transmission is in gear and the vehicle is in
motion.
•Do not try to start engine by pushing or towing the
vehicle.
426 MAINTAINING YOUR VEHICLE
Page 434 of 520

Cooling System
WARNING!
•When working near the radiator cooling fan, dis-
connect the fan motor lead or turn the ignition
switch to the OFF position. The fan is temperature
controlled and can start at any time the ignition
switch is in the ON position.
•You or others can be badly burned by hot coolant
or steam from your radiator. If you see or hear
steam coming from under the hood, don’t open
the hood until the radiator has had time to cool.
Never try to open a cooling system pressure cap
when the radiator is hot.
Engine Coolant Checks
Check the engine coolant (antifreeze) protection every 12
months (before the onset of freezing weather, where applicable). If coolant is dirty or rusty in appearance, the
system should be drained, flushed and refilled with fresh
coolant. Check the front of the A/C condenser for any
accumulation of bugs, leaves, etc. If dirty, clean by gently
spraying water from a garden hose vertically down the
face of the condenser.
Check the coolant recovery bottle tubing for brittle rub-
ber, cracking, tears, cuts and tightness of the connection
at the bottle and radiator. Inspect the entire system for
leaks.
With the engine at normal operating temperature (but
not running), check the cooling system pressure cap for
proper vacuum sealing by draining a small amount of
coolant from the radiator drain cock. If the cap is sealing
properly, the engine coolant (antifreeze) will begin to
drain from the coolant recovery bottle. DO NOT RE-
MOVE THE COOLANT PRESSURE CAP WHEN THE
COOLING SYSTEM IS HOT.
434 MAINTAINING YOUR VEHICLE
Page 453 of 520
Cavity Cartridge Fuse Description
F28 40 Amp Green Power Windows
F30 40 Amp Green Headlight Washers (Export
Only)
F31 40 Amp Green Power Sliding Door
F32 40 Amp Green Power Liftgate
Cavity Mini Fuse Description
F1 20 Amp Yel- low Fog Lights
F2 15 Amp Blue Left Park/Tail Light
F3 15 Amp Blue Right Park/Tail Light
F5 20 Amp Yel- low RDO/IP Ignition
Cavity Mini Fuse Description
F6 20 Amp Yel- low 12 Volt Out Ignition or
Battery
F8 20 Amp Yel- low Horn
F11 20 Amp Yel- low EWD/ Rear Wiper
F12 25 Amp Natural Rear Blower
F14 20 Amp Yel- low Ignition Off Draw (IOD)
F15 20 Amp Yel- low Electronic Automatic
Transaxle (EATX) Battery
F15 25 Amp Natural ASD
F17 20 Amp Yel- low Fuel Pump
F18 15 Amp Blue A/C Clutch
MAINTAINING YOUR VEHICLE 453
7
Page 454 of 520
Cavity Mini Fuse Description
F21 25 Amp Natural Anti-Lock Brake System
(ABS) Module
F23 10 Amp Red Ignition Switch
F24 20 Amp Yel- low Hazard
F26 20 Amp Yel- low Stop Lamp
F33 15 Amp Blue Front/Rear Washer 20 Amp Yel-
low Spare (IOD)CAUTION!
•When installing the Integrated Power Module
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the Integrated Power
Module, and possibly result in a electrical system
failure.
•When replacing a blown fuse, it is important to
use only a fuse having the correct amperage
rating. The use of a fuse with a rating other than
indicated may result in a dangerous electrical
system overload. If a properly rated fuse contin-
ues to blow, it indicates a problem in the circuit
that must be corrected.
454 MAINTAINING YOUR VEHICLE
Page 455 of 520

The Heated Mirrors, Lower Instrument Panel Power
Outlet and Removable Floor Console, when in the front
position are fused with self resetting fuses that are only
serviceable by an authorized dealer. The power seats are
fused by a 30 Amp circuit breaker located under the
driver’s seat. The Power Windows are fused by a 25 Amp
circuit breaker located under the instrument panel near
the steering column. If you experience temporary or
permanent loss of these systems see your authorized
dealer for service.
VEHICLE STORAGE
If you are leaving your vehicle dormant for more than 21
days you may want to take steps to protect your battery.
You may:
•Remove the 20 Amp mini fuse in the Integrated Power
Module labeled Ignition-Off Draw (IOD).
•Or, disconnect the negative cable from the battery.
•Anytime you store your vehicle, or keep it out of
service (i.e. vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
insure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
REPLACEMENT LIGHT BULBS
LIGHT BULBS — Interior Bulb Number
Center & Rear Dome Light .................. 578
Center & Rear Reading Lights ............... 578
Front Door Courtesy Light .................. 578
Front Header Reading Lights — If Equipped ..... 578
Instrument Cluster Lights .................PC74
Liftgate Light(s) .......................... 578
Overhead Console Reading Lights ..........PC579
Removable Console Light — If Equipped ....... 194
Visor Vanity Lights .................... 6501966
MAINTAINING YOUR VEHICLE 455
7
Page 473 of 520
Miles 57, 000 60, 000 63, 000 66, 000 69, 000 72, 000
(Kilometers) (95 000) (100 000) (105 000) (110 000) (115 000) (120 000)
Change engine oil and engine oil filter. XXXXX X
Rotate Tires XX X
Inspect the brake linings. XX
Inspect the engine air cleaner filter, replace if
necessary. X XXX X
Replace the engine air cleaner filter. X
Replace the spark plugs & ignition cables
on
2.4 liter engines.X
Inspect the tie rod ends and boot seals. X
Inspect and adjust the power steering pump belt
tension on 2.4 liter engines. X
Inspect the generator belt on 2.4 liter engines,
replace if necessary. X
Inspect the PCV valve
and replace if necessary.X
Inspect the serpentine drive belt on 3.3 liter and
3.8 liter engines, replace if necessary. ‡ X
Change the automatic transmission fluid and fil-
ter. \b X
Replace the air conditioning filter. XX
SCHEDULE “B” 473
8
M
A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S
Page 475 of 520
Miles 93, 000 96, 000 99, 000 102, 000 105, 000
(Kilometers) (155 000) (160 000) (165 000) (170 000) (175 000)
Change engine oil and engine oil filter. XXXX X
Rotate Tires XX
Inspect the brake linings. X
Inspect the engine air cleaner filter, replace if neces-
sary. XXXX
Replace the engine air cleaner filter X
Inspect and adjust the power steering pump belt
tension on 2.4 liter engines. X
Inspect the generator belt on 2.4 liter engines, re-
place if necessary. X
Replace the engine timing belt
on 2.4 liter engines
only.X
Inspect the serpentine drive belt on 3.3 liter and 3.8
liter engines, replace if necessary. ‡ X
Replace the spark plugs & ignition cables
on 3.3
liter and 3.8 liter engines.X
Flush and replace the engine coolant. X
Replace the air conditioning filter. X
SCHEDULE “B” 475
8
M
A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S
Page 476 of 520
Miles 108, 000 111, 000 114, 000 117, 000 120, 000
(Kilometers) (180 000) (185 000) (190 000) (195 000) (200 000)
Change engine oil and engine oil filter. XXXXX
Rotate Tires XXX
Inspect the brake linings. XX
Inspect the engine air cleaner filter, replace if
necessary. XXXX
Replace the engine air cleaner filter. X
Replace the spark plugs & ignition cables on
2.4 liter engines. X
Inspect the tie rod ends and boot seals. X
Inspect the PCV valveand replace as neces-
sary. X
Inspect and adjust the power steering pump
belt tension on 2.4 liter engines. X
Inspect the generator belt on 2.4 liter engines,
replace if necessary. X
476 SCHEDULE “B”
8
M
A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S