2007 Citroen C6 DAG sensor
[x] Cancel search: sensorPage 75 of 216
77
II
As the vehicle approaches the obstacle, the sound signal becomes more and more urgent and the shaded areas are displayed closer and closer to the vehicle.
Proximity sensors are located in the front and rear bumpers of your vehi-cle.
When manœuvring in either forward or reverse gear, at a low speed less than approx. 10 km / h (6 mph), they inform you of the presence of any obstacle that is within their zone of detection by: A sound signal emitted by the front or rear loudspeakers.ADisplay of the outline of your vehicle with shading corresponding t o the area where an obstacle is detected.
As the vehicle approaches the obstacle, the sound signal tells you the posi-tion of the obstacle according to whether the sound is coming from the front LH or RH or the rear LH or RH loudspeakers.Note: The sound volume of your audio equipment reduces automatically when a signal is being emitted.
Page 76 of 216
78
II
1
ACTIVATION/DEACTIVATION
You can activate/deactivate the parking assistance by pressing button 1. When the parking assist-ance is inactive, the warning lamp on button 1 is lit up.
Activation/deactivation of the park-ing assistance is memorised when you stop the vehicle.
Remark: If you wish to tow a trailer, it is necessary to deactivate the parking assistance by pressing button 1. The warning lamp on the button lights up.
OPERATION
When you engage reverse gear, a s o u n d s i g n a l c o n fi r m s t o y o u that the system is active. The out-line of your vehicle appears on the screen. Any obstacles located to the rear or to the front of the vehi-cle can be detected.
When moving forward at a speed less than approx. 10 km / h (6 mph), whether in neutral or in gear, the vehi-cle outline appears on the screen as soon as an obstacle is detected in front of the vehicle. Any obstacles located to the rear or to the front of the vehicle can be detected.
Remarks:The proximity sensors cannot detect objects that are immedi-ately under or over the bump-ers.
A thin object such as a spike, Aa bollard or similar, can only be detected at the start of the manœuvre but not when the vehicle arrives close up to it.In poor weather or in winter, you need to ensure that the sensors are not covered with mud or with ice or snow.
Page 78 of 216
80
II
1
L A N E D E P A R T U R E W A R N I N G S Y S T E M
This driving assistance device warns you when you unwittingly cross a l a n e m a r k i n g ( e i t h e r a c o n t i n u o u s o r a d o t t e d l i n e o n t h e r o a d s u r f a c e ) . I t is designed for use on motorways and dual carriageways, operatin g only above speeds of approx. 80 km / h (50 mph).
ACTIVATION/DEACTIVATION
A press on button 1 activates the function, the warning lamp on the button lights up.
A second press on button 1 deactivates the function, the warning lamp on the button goes out.
W h e n y o u s t a r t t h e e n g i n e , t h e m o d e ( a c t i v a t e d / d e a c t i v a t e d ) s e l e c t e d w h e n you stopped the engine is retained.
OPERATION
A b o v e a s p e e d o f a r o u n d 8 0 k m / h ( 5 0 m p h ) , i f y o u c r o s s a l a n e m a r k i n g , y o u a r e a l e r t e d t o t h i s b y a v i b r a t i o n w i t h i n the cushion of your seat:On the right hand side if you cross a lane marking to the right.On the left hand side if you cross a lane marking to the left.
The system does not alert you if one of your direction indicators is operating and for approx. 20 seconds after the direction indicator has stopped.
Remarks
T h i s s y s t e m i s d e s i g n e d t o i d e n t i f y t r a f fi c l a n e m a r k i n g s .
In certain cases it may trigger an alert that is unnecessary, for e xample if the vehicle passes over a directional arrow or some unusual road marking.
The system may be affected temporarily by conditions external to th e vehicle:Detection o f l a n e m a r k i n g s m a d e d i f fi c u l t b y :Markings being worn. I n s u f fi c i e n t contrast with the general road surface.Sensors being negated by:
Driving in snow or heavy rain.Driving on roads that are covered with mud or water puddles.
If there is prolonged interference, contact a CITROËN dealer.
Page 83 of 216
85
IIIA
B
C
D
A U T O M A T I C A I R C O N D I T I O N I N G
A. Sunlight sensor
B. Soft diffusion system
C. Temperature and humidity sensor
D. Ventilated stor-age under the central armrest
Page 84 of 216
86
III
A U T O M A T I C A I R C O N D I T I O N I N G
AIR CONDITIONING
This system automatically adjusts the temperature, the fl o w o f a i r a n d t h e d i s t r i b u t i o n o f a i r i n s i d e t h e c a b i n , depending on your desired comfort level.
Provided you retain automatic mode (by pressing button “AUTO ” ) a n d a l l t h e a i r v e n t s a r e o p e n , y o u w i l l m a i n -tain an optimum comfort level, also removing humidity and misting, whatever the ambient climatic conditions.
The temperature inside the cabin cannot be lower than the temperature outside if the air conditioning is not operating.
To be effective, the air conditioning should only be used with the windows closed. If after a lengthy stop in bright sunlight the interior temperature is excessive, air the passenger compartment by opening the windows for a few moments, then close them again.
To keep the air conditioning compressor well sealed, it is essential to operate the air conditioning at least once in every month.
The air conditioning operates by using power from the engine. This results in a slight increase in fuel con-sumption.
Sensors
The automatic regulation of the air conditioning inside the cabin uses a number of sensors (sunlight, ambient t e m p e r a t u r e , i n s i d e t e m p e r a t u r e , e t c . ) r e l i e v i n g y o u o f the need to make your own adjustments within a normal temperature range.
The humidity sensor is there to prevent misting inside the vehicle.
Be careful not to obstruct the sensors A and C.
Air inlet
Check that the exterior grille for the air inlet, at the bot-tom of the windscreen, is clean and free of dead leaves, snow, etc.
If washing the vehicle with a high pressure jet, avoid targeting the air inlet zone.
Air circulation
For your comfort we advise you to maintain a proper distribution of air within the cabin, both at the front and at the rear.
The air vents to the face have thumbwheels so that you c a n a d j u s t t h e fl o w o f a i r , a n d g r i l l e s t o o r i e n t t h e d i r e c -tion.
T h e r e a r e a i r v e n t s o n t h e fl o o r u n d e r n e a t h t h e f r o n t seats and on the rear control panel, for enhanced heat-ing of the rear seat positions.
Do not obstruct the air outlets located in the boot area.
D u s t / p o l l e n fi l t e r
T h e r e i s a fi l t e r f o r e x c l u d i n g p o l l e n a n d d u s t .
T h i s fi l t e r h a s t o b e c h a n g e d a c c o r d i n g t o t h e v e h i c l e maintenance schedule. See “Maintenance Guide”.
Additional heating
Vehicles with an HDi engine may be provided with auto-matic additional heating for enhanced comfort.
It is normal to notice slight odours or smoke emissions, especially when the vehicle is idling or stationary.
Page 140 of 216
143
V
T A B L E O F F U S E S
Ref.RatingFunction
F 1––
F 2––
F 35 AAirbags
F 410 ABraking system – Active bonnet – Cruise contol / speed limiter – Photochromic rear view mirror – Diagnostic socket – Multifunction screen inclination motor
F 530 AFront window – Sun roof
F 630 ARear window
F 75 ASun visor lighting – Glove box lighting – Interior lamps – Rear cigar-lighter
F 820 A C o n t r o l s a t t h e s t e e r i n g w h e e l – D i s p l a y – O p e n i n g o f w i n d o w s ( M i c r o - d e s c e n t ) – A l a r m – R a d i o
F 930 AFront cigar-lighter
F 1015 ABoot relay unit – Trailer relay unit
F 1115 ASteering lock
F 1215 A D r i v e r ’ s a n d f r o n t p a s s e n g e r ’ s s e a t b e l t w a r n i n g l a m p – O p e n i n g o f w i n d o w s ( M i c r o - d e s c e n t ) – E l e c t r i c s e a t s – P a r k i n g assistance – Audio system JBL
F 135 AActive bonnet – Rain and brightness sensor – Windscreen wiper – Engine relay unit supply
F 1415 ALane Departure Warning System – Air conditioning – Instrument pa nel – Head-up display – Airbags – Bluetooth® (Hands-®
f r e e k i t ) – B H I r e l a y
F 1530 ACentral locking – Child safety
F 16SHUNT–
F 1740 AVentilation
DASHBOARD FUSES (BOX C)
Page 150 of 216
153
VI
A
S A F E T Y R E C O M M E N D A T I O N S
It is recommended that you have your towbar installed and r e m o v e d b y a C I T R O Ë N d e a l e r .It is recommended that you have recommended that
If you are towing another vehicle, the latter must be free-wheeling (gearbox in neutral).
Dimensions ( i n m e t r e s ):
A: 0.971
TOWBAR
( B o a t , c a r a v a n , e t c . )
It is recommended that you have your towbar installed and r e m o v e d b y a C I T R O Ë N d e a l e r .have your towbar installed and towbar installed
If you are climbing a steep gradient and the engine gets excessively hot, certain functions become una-vailable (e.g. sequential control of the automatic gearbox, the air con- d i t i o n i n g ) .
If you are towing, it is necesaary to deactivate the parking assist-ance by pressing the control on the dashboard. See “Parking assist-ance”.
It is recommended that you remove the towing ball, so that it does not interfere with the functioning of the proximity sensors, when you are not using a trailer.
MAINTENANCE
if cleaning the vehicle with a high pressure systemYour P i l o t e d D e fl e c t o r h a s t o b e ourclosed.
It is not advisable to clean the underside of the vehicle, for fear of damaging the electric parking brake.As water may penetrate into the vehicle interior via the door apertures, do not target these areas.
Page 155 of 216
158
VI
It is imperative not to exceed a speed of 80 km / h (50 mph) on the spare wheel.
T h e w h e e l b o l t s a r e s p e c i fi c t o t h e t y p e o f w h e e l .
I f t h e t y p e o f w h e e l i s c h a n g e d , c h e c k w i t h y o u r C I T R O Ë N d e a l e r that the wheel bolts are compatible with the new wheels.
Note: take care to note down the code number engrav ed on the head of the anti-theft bolt socket. This will enable you to obtain replacement anti-theft bolt sockets from a dealership.
WHEEL FOR TEMPORARY USE
If your vehicle is equipped with a spare wheel for temporary use o n l y , w h e n fi t t i n g i t i t i s n o r m a l t o observe that the wheel bolts do not come to bear on the wheel rim.
The spare wheel is secured by the conical tapering of the wheel bolt’s shaft. See illustration.
W h e n r e fi t t i n g t h e o r i g i n a l w h e e l , ensure that the wheel bolt contact surfaces are clean and in good condition.
REFITTING A WHEEL1. Fit the wheel on the hub, using the centring guide. Make sure that the contact surface between the hub and the wheel is clean.2. Screw in the bolts but do not fully tighten them.3. Lower the jack and remove it.4. Tighten the wheel bolts, using the wheelbrace.5. R e fi t t h e e m b e l l i s h e r .6. Return the ground clearance to the normal position. See “Adjusting ground clearance”.7. Ensure the tyre pressure is c o r r e c t ( s e e “ V e h i c l e i d e n t i fi c a - t i o n ” ) a n d h a v e t h e b a l a n c i n g checked.
WHEEL EQUIPPED WITH DEFLATION DETECTION SENSOR
Such wheels have tyre pressure sensors. It is essential to have repairs carried out by a CITROËN dealer.
ANTI-THEFT BOLTS
Each wheel is equipped with one anti-theft bolt.
To remove it1. Remove the protector that is covering it by means of the tool 4 for “removing anti-theft protectors”.2. Use the anti-theft socket with the handle.
C H A N G I N G A W H E E L