Page 130 of 216
133
VA
B
C
D
L E V E L S
A i r fi l t e r
Follow the requirements set out in the Maintenance Guide.
REFER TO THE CHAPTER: USER PRECAUTIONS.
Screen wash and h e a d l a m p w a s h fl u i d
Use CITROËN-approved products wherever possible.
Capacity: See “Capacities”.
Engine coolant
T h e fl u i d l e v e l s h o u l d b e between the marks MIN. and MAX. on the header tank.
Engine hot, wait at least 15 minutes.
Quality: See “Maintenance Guide”.
Never do anything relating to the cooling system of an engine that is hot.
Poles “+” and “-” for starting with a slave battery
See “Starting with a slave battery”.
Engine oil
Check the engine oil level on horizontal ground with the engine having been switched off for at least 15 min-utes.
Quality: See “Maintenance Guide”.
Pull out the manual dip-stick.
The level should be between the marks MIN.and MAX. on the gauge.
It must never exceed the maximum.
MAX.
MIN.
B r a k e fl u i d
T h e l e v e l o f fl u i d s h o u l d b e between the marks MIN.and MAX. on the reser-voir.
Quality: See “Maintenance Guide”.
If the warning lamp comes on while you are driving, stop imme- d i a t e l y a n d c o n t a c t a C I T R O Ë N while you are driving, stop imme-stop imme-
dealer.
Power steering and suspension oil
For topping up, it is neces-sary to go to a CITROËN For topping up, it is neces-neces-
dealer.
Quality: See “Maintenance Guide”.
If opening the bonnet when the engine is hot, even if it is Ifstopped and the ignition is switched off, remember that the cooling fan may operate at any moment.
Between routine servicing visits, check the level of engine oil frequently as well as before going on a long journey.
Page 135 of 216
138
V
A
D
C
B
BATTERY LOCATION AND ACCESS
The battery is located in the boot under the left hand wing trim. To access the battery, rotate the pin o n t h e fl a p b y a 1 / 4 .
CHANGING THE BATTERY ( C o n t a c t a C I T R O Ë N d e a l e r ) .1. Release the two pins on each side at the back of the boot, and remove t h e b o o t fl o o r .2. O n e a c h s i d e t r i m , r e l e a s e t h e t w o fi x i n g p i n s A.3. Undo the two screws B on each side and remove the sill embellisher.4. On the side trim close to the battery, release the pin D.5. Separate the side trim close to the battery, pulling hard to free the other fi x i n g p o i n t s .6. Unclip the boot lamp C.7. Disconnect both battery terminals.8. Release the battery from its support.9. Remove the battery.
Before changing or repairing the battery, open all four windows.
If you have to unlock your vehicle with the key because of a problem with the battery, any opening/closing of a door with the window closed may seriously damage the glass to the point of breaking it.
1 2 V B A T T E R Y
Page 136 of 216
139
V
STARTING THE ENGINE AFTER DISCONNECTING AND RECONNECTING THE BATTERY1. Turn the ignition key.2. Wait approximately 1 minute before operating the starter in order to allow the electronic systems to re-initialise.
After the battery has been disconnected for a lengthy period o f time, it may be necessary to re-initialise the following functions:The anti-pinch on the windows.
The anti-pinch on the sun roof.
The m u l t i f u n c t i o n d i s p l a y p a r a m e t e r s ( d a t e , t i m e , l a n g u a g e , u n i t s o f d i s t a n c e a n d o f t e m p e r a t u r e ) .The Radio stations.
The NaviDrive. See NaviDrive instructions.
IMPORTANT
In the event of a battery failure, and if the boot is closed, it is then necessary to feed an electrical supply to your vehicle. See following page.
Page 137 of 216
140
V
BC
A
1 2 V B A T T E R Y
STARTING THE ENGINE WITH AN ASSISTING BATTERY
If the battery is discharged, it is possible to use either a separate emergency battery or a battery on another vehicle.
If you use the battery on another vehicle, stop the engine on the latter. The two vehicles must not come into direct contact with each other.
C h e c k t h a t t h e a s s i s t i n g b a t t e r y h a s s u f fi c i e n t v o l t a g e ( 1 2 V ) .
Connect the cables according to the order indicated in orderthe diagram.
A Pole “+” on the vehicle being assisted (under the r e d c o v e r ) .B Assisting battery.C Pole “– ” o n t h e a s s i s t e d v e h i c l e ( u n d e r t h e b o n n e t ) .
C h e c k t h a t t h e l e a d s a r e w e l l s e c u r e d ( r i s k o f s p a r k s ) .
Start the engine of the assisting vehicle.Let the engine run for around 1 minute at a slightly accelerated idle.
Operate the starter on the vehicle being assisted.
It is essential to follow the indicated sequence cor-rectly.
N e v e r a p p r o a c h w i t h a fl a m e o r c r e a t e s p a r k s i n t h e v i c i n i t y o f t h e b a t t e r y ( e x p l o s i v e g a s ) .
The battery contains dilute sulphuric acid which is hig hly corrosive.
When handling batteries, always protect your face and es pecially your eyes.
In the event of any contact with the skin, rinse immediatel y with copious amounts of fresh water.
ADVICE
Do not touch the leads during the operation.
Do not lean over the batteries.
Disconnect the cables in reverse order, making sure they do not touch together.
Page 143 of 216
146
V
53 41 2
G36G37 G38 G39 G40
F U S E S I N T H E B O O T
FUSEBOX
To access the fusebox located under the left hand wing trim:1. Move aside the trim on the LH side. See “12V battery: Chang-ing the battery”.2. Move aside the electrical cables connecting to the fuse-box.3. Open the fusebox.
Ref.RatingFunction
F 115 A F u e l fl a p
F 2––
F 3––
F 415 A S p e e d - s e n s i t i v e r e a r s p o i l e r ( d e fl e c t o r )
F 540 AHeated rear screen
G 3615 A / 25 A R e a r L H e l e c t r i c h e a t e d s e a t ( P a c k L o u n g e ) / B e n c h s e a t
G 3715 A / 25 A R e a r R H e l e c t r i c h e a t e d s e a t ( P a c k L o u n g e ) / B e n c h s e a t
G 3830 A R e a r e l e c t r i c s e a t a d j u s t m e n t s ( P a c k L o u n g e )
G 3930 ACigar-lighter – Rear accessory socket
G 4025 AElectric parking brake
Page 170 of 216
101010
I
N A V I G A T I O N / G U I D A N C E
WHAT YOU NEED TO DO IN ORDER TO USE THE NAVIGATION SYSTEM ?
You have to initialise the navigation sys-tem: w h e n y o u fi r s t u s e t h e n a v i g a t i o nfollowing a battery disconnection.Park the vehicle in the open air so that it can make contact with a satellite.Place the ignition key in the “Ignition” position for 15 minutes. I f t h e n a v i g a t i o n s y s t e m h a s d i f fi c u l t y i n receiving its GPS positioning from satel-lites, this may be caused by the presence of bridges, underground carparks, etc., which may temporarily interfere with vehi-cle location or guidance calculation.
