Page 89 of 144
1
2
IV
9 0
S A L O O N C A B R I O L E T
A. Press the light grey control located on the interior face of the rear screen.
B. Lift the assembly a few centi-metres until it clicks in place.
The rear tailgate should be open throughout the operation to allow the pivoting of the cassette.
The telescopic locking handles of the arches should be completely retracted in their housings (see the following pages for removing the arches).
Before stowing the cassette in the boot, make sure that the boot is empty.
Prior conditions for the fold-ing operation:The ignition must be switched on.The soft roof must have fully slid onto the rear screen (Posi-tion 9).
The rear part of the movable fl o o r m u s t h a v e b e e n r e m o v e d .
The boot must be empty.The rear tailgate 2 should be open and the rear screen 1closed.
Make sure that the luggage r e t a i n i n g r i n g s a r e d o w n fl a t .
Page 90 of 144
IV
91
S A L O O N C A B R I O L E T
D. Cassette stowed.E. Reposition the rear part of the b o o t fl o o r .
F. Position the boot compartment cover.
C. Pivot it to stow it in the boot compartment.
Always use the handholds in the top and bottom of the cassette, to:Open or close the rear screen.
Move the cassette.
Never grab the cassette by the roof material or frame.
Do not exert pressure on the roof material or frame to clo se the rear screen or the cassette.
Page 91 of 144
1
2
2
IV
9 2
C A B R I O L E T S P I D E R
It is essential for the tailgate 2 to be closed when the vehicle is being driven.
Prior conditions for remov-ing the arches:The roof cassette should be stowed away.The tailgate 2 should be open and all the windows should be down.
A. Unlocking the arches
At the front of the arch, lower part 1 of the control then part 2 to unlock.
B. In the boot, bring the handle out from its housing.
Pull it upwards.
Page 92 of 144
1
2
IV
9 3
C A B R I O L E T S P I D E R
D. Remove the arch horizontally towards the rear, in the line of the vehicle.
E. Position the boot compartment cover and the side covers.
C. Removing the arches
Make sure that the handle is in the up position.
With one hand grab the arch at the centre 1, with the other hand hold the rear extremity 2.
Raise the rear part a few centime-tres.
Handle the arches with care so as not to damage the vehicle’s bodywork.
Place the arches down horizontally on a clean, dry surfa ce so that they rest on their inner sides to prevent damage to their outer faces.
Page 97 of 144
1
IV
9 8
B O O T C O M P A R T M E N T C O V E R
This movable cover consists of the main section and two side covers that are secured on the cover’s inner face.
The main section enables the boot to be closed off in Cabriolet or Spi- d e r c o n fi g u r a t i o n .
The side covers the bases of the a r c h e s w h e n i n S p i d e r c o n fi g u r a -tion.A. Positioning the boot compart-ment cover:Place yourself at one sde of the vehicle.
Unlock and tilt the rear seat backrest.
Lift the boot cover on one side then remove it from the boot.
B. Tilt the boot cover as shown and place the pin 1 in its hous- i n g . T h e n fl e x t h e b o o t c o v e r to place the other pin in the opposite housing.
C. Engage the pins in their hous-ings by pulling the boot cover rearwards.Reposition the rear seat.
Note:The tailgate is locked automatically as soon as the vehicle reaches a speed of approx. 10 km/h (6 mph).
To gain access to the boot, vehicle stationary, unlock the vehicle either by opening a door or by using the remote control or the key.
Page 98 of 144
1
2
IV
99
B O O T C O M P A R T M E N T C O V E R
D. To lock the boot compartment cover: First close the tailgate 1then the boot cover 2.
The tailgate opening control is a c c e s s e d v i a t h e m o b i l e fl a p i n t h e boot compartment cover.
To remove the boot compartment cover, proceed in reverse order.
Do not place any object on the boot compartment cover.
Page 99 of 144
IV
1 0 0
S I D E C O V E R S
The side covers are to be found on the interior face of the boot com-partment cover.
Positioning the side covers:
Deploy the ring located beneath the cover.
Make sure that the telescopic han-dles are in the fully up position when placing the side covers.
Place the cover in the location vacated by the arch.
Lower the telescopic handle with the palm of your hand to lock the cover in position.
Page 118 of 144
VI
119
C H A N G I N G B U L B S
Interior lamp
Unclip the transparent cover of the interior lamp to reach the bulb.
Bulb: W 5 W
Spotlamps
Unclip the transparent cover of the interior lamp to reach the bulb.
Bulb: W 5 W
Boot lamp
Unclip the transparent cover of the interior lamp to reach the bulb.
Bulb: W 5 W
