2007 CHEVROLET IMPALA park assist

Automatic Door Lock
The doors will automatically lock when the shift
lever is moved out of PARK (P). The automatic
door locking feature cannot be disabled.
Programmable Automatic Door
Unlock
Your vehicle is programmed so that when the shift
lever is moved into PARK (P) all doors will unlock.
With the vehicle stopped and the engine running,
door unlocking can be programmed through
prompts displayed on the Driver Information
Center (DIC). These prompts allow the driver to
choose various unlock settings. For programming
information, seeDIC Vehicle Customization on
page 208.
Rear Door Security Locks
Your vehicle has rear door security locks, that
prevent passengers from opening the rear doors
from the inside.
The rear door security locks are located on the
inside edge of each rear door. You must open the
rear doors to access them.
To assist you in nding the lock, your vehicle will
have one of the following:
100

Read the instructions completely before attempting
to program the Universal Home Remote. Because
of the steps involved, it may be helpful to have
another person available to assist you in the
programming steps.
Keep the original hand-held transmitter for use in
other vehicles as well as for future Universal Home
Remote programming. It is also recommended that
upon the sale of the vehicle, the programmed
Universal Home Remote buttons should be erased
for security purposes. See “Erasing Universal
Home Remote Buttons” later in section.
When programming a garage door, it is advised to
park outside of the garage. Be sure that people
and objects are clear of the garage door or
gate operator you are programming.
It is recommended that a new battery be installed in
your hand-held transmitter for quicker and more
accurate transmission of the radio-frequency signal.Programming the Universal Home
Remote System
Follow these steps to program up to three
devices:
1. Press and hold down the two outside Universal
Home Remote buttons, releasing only when
the Universal Home Remote indicator light
begins to ash, after 20 seconds. Do not hold
down the buttons for longer than 30 seconds
and do not repeat this step to program a
second and/or third hand-held transmitter to
the remaining two Universal Home Remote
buttons.
2. Hold the end of your hand-held transmitter
about 1 to 3 inches (3 to 8 cm) away from
the Universal Home Remote buttons
while keeping the indicator light in view.
3. At the same time, press and hold both the
desired Universal Home Remote button and
the hand-held transmitter button. Do not
release the buttons until Step 4 has been
completed.
134

Read the instructions completely before attempting
to program the transmitter. Because of the steps
involved, it may be helpful to have another person
available to assist you in programming the
transmitter.
Be sure to keep the original remote control
transmitter for use in other vehicles, as well as,
for future programming. You only need the original
remote control transmitter for Fixed Code
programming. It is also recommended that upon
the sale or lease termination of the vehicle, the
programmed buttons should be erased for security
purposes. See “Erasing Universal Home Remote
Buttons” later in this section.
When programming a garage door, it is advised to
park outside of the garage. Be sure that people
and objects are clear of the garage door or
security device you are programming.
Programming Universal Home
Remote — Rolling Code
Most garage door openers sold after 1996 are
Rolling Code units.Programming a garage door opener involves
time-sensitive actions, so read the entire procedure
before you begin. If you do not follow these actions,
the device will time out and you will have to repeat
the procedure.
Follow these steps to program up to three devices:
1. From inside the vehicle, press the two
outside buttons at the same time for one to
two seconds, and immediately release them.
138

Changing a Flat Tire
If a tire goes at, avoid further tire and wheel
damage by driving slowly to a level place. Turn on
your vehicle’s hazard warning ashers. SeeHazard
Warning Flashers on page 152for more information.
{CAUTION:
Changing a tire can be dangerous. The
vehicle can slip off the jack and roll over
or fall on you or other people. You and
they could be badly injured or even killed.
Find a level place to change your tire. To
help prevent the vehicle from moving:
1. Set the parking brake rmly.
2. Put the shift lever in PARK (P).
3. Turn off the engine and do not restart
while the vehicle is raised.
4. Do not allow passengers to remain in
the vehicle.
To be even more certain the vehicle will
not move, you should put blocks at the
CAUTION: (Continued)
CAUTION: (Continued)
front and rear of the tire farthest away
from the one being changed. That would
be the tire, on the other side, at the
opposite end of the vehicle.
When your vehicle has a at tire, use the following
example as a guide to assist you in the placement
of wheel blocks.
The following information will tell you next how to
use the jack and change a tire.
374

Rear Safety Belt Comfort Guides.................. 37
Rear Seat Armrest...................................... 144
Rear Seat Passengers, Safety Belts.............. 35
Rear Storage Area...................................... 144
Rearview Mirror, Automatic Dimming
with OnStar
®............................................ 126
Rearview Mirror with OnStar®...................... 126
Rearview Mirrors......................................... 126
Reclining Seatbacks...................................... 11
Recommended Fluids and Lubricants.......... 417
Recreational Vehicle Towing........................ 282
Remote Keyless Entry (RKE) System............ 90
Remote Keyless Entry (RKE) System,
Operation................................................... 91
Removing the Flat Tire and Installing
the Spare Tire.......................................... 377
Removing the Spare Tire and Tools............ 375
Replacement Bulbs..................................... 349
Reporting Safety Defects
Canadian Government............................. 441
General Motors........................................ 441
United States Government....................... 440
Restraint System Check
Checking the Restraint Systems................. 84
Replacing Restraint System Parts
After a Crash......................................... 85
Retained Accessory Power (RAP)................ 113Right Front Passenger Position,
Safety Belts............................................... 33
Roadside
Assistance Program................................. 432
Rocking Your Vehicle to Get it Out.............. 277
Routing, Engine Drive Belt.......................... 420
Running the Engine While Parked............... 125
S
Safety Belt
Passenger Reminder Light....................... 177
Pretensioners............................................. 40
Reminder Light........................................ 177
Safety Belts
Care of.................................................... 390
Center Front Passenger Position................ 34
Driver Position........................................... 24
How to Wear Safety Belts Properly............ 23
Questions and Answers About
Safety Belts............................................ 22
Rear Safety Belt Comfort Guides............... 37
Rear Seat Passengers............................... 35
Right Front Passenger Position.................. 33
Safety Belt Extender.................................. 40
Safety Belt Use During Pregnancy............. 33
Safety Belts Are for Everyone.................... 18
Shoulder Belt Height Adjuster.................... 32
456