2007 CADILLAC CTS V AUX

A high electrical load occurs when several of the
following loads are on: headlamps, high beams,
fog lamps, rear window defogger, climate
control fan at high speed, heated seats, engine
cooling fans, trailer loads, and loads plugged into
accessory power outlets.
EPM works to prevent excessive discharge of the
battery. It does this by balancing the generator’s
output and the vehicle’s electrical needs. It
can increase engine idle speed to generate more
power, whenever needed. It can temporarily
reduce the power demands of some accessories.
Normally, these actions occur in steps or levels,
without being noticeable. In rare cases at the
highest levels of corrective action, this action may
be noticeable to the driver. If so, a Driver
Information Center (DIC) message might be
displayed, such as Battery Saver Active or Service
Battery Charging System. If this message is
displayed, it is recommended that the driver
reduce the electrical loads as much as possible.
SeeDIC Warnings and Messages on page 232.Battery Run-Down Protection
Your vehicle has a feature to help prevent the
battery from being drained, in case the underhood
lamp, vanity mirror lamps, cargo lamps, reading
lamps, console, or glove box lamps are
accidentally left on, or something is left plugged
into the accessory power outlet or cigarette lighter.
If any of the accessory lamps are left on, they
will automatically time-out after about 20 minutes.
To reset the battery protection, all of the above
lamps must be turned off or the ignition must be in
the Acc. position.
Accessory Power Outlet(s)
Accessory power outlets can be used to connect
auxiliary electrical equipment, such as a cellular
telephone or CB radio.
186

Transmission Fluid Hot Message
When you see this
ashing symbol, the
transmission uid
temperature is high
(290°F (143°C)).
To acknowledge this warning, press either button
on the outboard switch on the left spoke of the
steering wheel. After you press this button, the
warning will redisplay every 10 minutes until the
temperature returns to the normal operating range.
If this message appears, you may continue to drive
at a slower speed while monitoring the transmission
uid temperature. Ideally, the transmission oil
temperature should not rise above 265°F (129°C). If
you regularly experience temperatures above this
limit due to high performance operation, it is
recommended to use an auxiliary uid cooler for the
transmission and differential. See your dealer for
details. If this warning is displayed during normal
vehicle operation on at roads, your vehicle may
need service. See your dealer for an inspection.
SeeDIC Warnings and Messages on page 232and
Manual Transmission Fluid on page 354for more
information.
Hot Coolant Temperature Warning
Message
When you see this
ashing symbol, the
engine coolant
temperature is high
(257°F (125°C)).
To acknowledge this warning, press either button
on the outboard switch on the left spoke of the
steering wheel. After you press a button, this
warning will come on every 10 minutes until the
temperature returns to the normal operating range.
Driving aggressively or driving on long hills can
cause the engine coolant temperature to be higher
than normal. The Engine Coolant Temperature
Warning Light should also come on. SeeEngine
Coolant Temperature Warning Light (CTS) on
page 207for more information. If this warning is
displayed during normal vehicle operation on
at roads, your vehicle may need service.
See your dealer for an inspection.
219

Battery Saver Active
This message appears when the system detects
that the battery voltage is dropping beyond a
reasonable level. The battery saver system will
start reducing certain features of the vehicle which
you may be able to notice. At the point that the
features are disabled, this message is displayed. It
means that the vehicle is trying to save the
charge in the battery.
Turn off all unnecessary accessories to allow the
battery to recharge.
The normal battery voltage range is
11.5 to 15.5 volts. You can monitor battery voltage
on the DIC by pressing the INFO button until
BATTERY VOLTS appears.
Battery Voltage High
This message indicates that the electrical charging
system is overcharging the battery. When the
system detects that the battery voltage is above
an estimated 16 volts, this message will be
displayed.To reduce the charging overload, use the vehicle’s
accessories. Turn on the exterior lamps and
radio, set the climate control on AUTO and the fan
speed on the highest setting, and turn the rear
window defogger on.
The normal battery voltage range is
11.5 to 15.5 volts when the engine is running. You
can monitor battery voltage on the DIC by pressing
the INFO button until BATTERY VOLTS appears.
Battery Voltage Low
This message will appear when the electrical
system is charging less than 10 volts or if
the battery has been drained.
If this message appears immediately after starting
the engine, it is possible that the generator can
still recharge the battery. The battery should
recharge while driving but may take a few hours to
do so. Consider using an auxiliary charger to
boost the battery after returning home or to a nal
destination. Make sure you follow the
manufacturer’s instructions.
233

(h)Change automatic transmission uid and lter
if the vehicle is mainly driven under one or
more of these conditions:
In heavy city traffic where the outside
temperature regularly reaches 90°F (32°C)
or higher.
In hilly or mountainous terrain.
When doing frequent trailer towing.
Uses such as high performance operation.
If you do not use your vehicle under any of these
conditions, the uid and lter do not require
changing.
(i)Drain, ush, and rell cooling system.
This service can be complex; you should have
your dealer perform this service. See Engine
Coolant on page 356 for what to use. Inspect
hoses. Clean radiator, condenser, pressure cap,
and ller neck. Pressure test the cooling
system and pressure cap.
(j)If using DOT-4 brake uid only: Drain, ush,
and rell brake hydraulic system at a regular
maintenance service (IorII) every two years.
This service can be complex; you should have
your dealer perform this service. See Brakes
on page 371.(k)A uid loss in any vehicle system could
indicate a problem. Have the system inspected
and repaired and the uid level checked. Add uid
if needed.
(l)Change uid if the vehicle is used for high
performance operation.
(m)Change uid whenever the vehicle has been
driven for 3,000 miles (5 000 km) with the
transmission temperature at 290°F (143°C) or
higher without using an auxiliary uid cooler.
See Message Center (CTS-V) on page 215 and
Transmission Fluid Hot Message on page 219.
(n)If you drive regularly under dusty conditions,
inspect the lter at each engine oil change.
(p)Visually inspect belt for fraying, excessive
cracks, or obvious damage. Replace belt if
necessary.
468