2007 BUICK RANDEZVOUS tire size

If the tires have an all-season tread design, the
TPC spec number will be followed by an MS
for mud and snow. SeeTire Sidewall Labeling
on page 407for additional information.
{CAUTION:
Mixing tires could cause you to lose
control while driving. If you mix tires of
different sizes, brands, or types (radial and
bias-belted tires), the vehicle may not
handle properly, and you could have a
crash. Using tires of different sizes,
brands, or types may also cause damage to
your vehicle. Be sure to use the correct
size, brand, and type of tires on all wheels.
It is all right to drive with your compact
spare temporarily, as it was developed for
use on your vehicle. SeeCompact Spare
Tire on page 450.
{CAUTION:
If you use bias-ply tires on your vehicle,
the wheel rim anges could develop
cracks after many miles of driving. A tire
and/or wheel could fail suddenly, causing
a crash. Use only radial-ply tires with the
wheels on your vehicle.
If you must replace your vehicle’s tires with those
that do not have a TPC Spec number, make sure
they are the same size, load range, speed rating,
and construction type (radial and bias-belted tires)
as your vehicle’s original tires.
Your vehicle’s original equipment tires are listed on
the Tire and Loading Information Label. This label is
attached to the vehicle’s center pillar (B-pillar).
SeeLoading Your Vehicle on page 332, for more
information about the Tire and Loading Information
Label and its location on your vehicle.
419

Different Size Tires and Wheels
If you add wheels or tires that are a different size
than your original equipment wheels and tires, this
may affect the way your vehicle performs, including
its braking, ride and handling characteristics,
stability, and resistance to rollover. Additionally,
if your vehicle has electronic systems such as,
anti-lock brakes, traction control, and electronic
stability control, the performance of these systems
can be affected.
{CAUTION:
If you add different sized wheels, your
vehicle may not provide an acceptable
level of performance and safety if tires
not recommended for those wheels are
selected. You may increase the chance
that you will crash and suffer serious
injury. Only use GM specic wheel and
tire systems developed for your vehicle,
and have them properly installed by a GM
certied technician.SeeBuying New Tires on page 418and
Accessories and Modications on page 354
for additional information.
Uniform Tire Quality Grading
Quality grades can be found where applicable
on the tire sidewall between tread shoulder
and maximum section width. For example:
Treadwear 200 Traction AA Temperature A
The following information relates to the system
developed by the United States National Highway
Traffic Safety Administration (NHTSA), which
grades tires by treadwear, traction, and
temperature performance. This applies only to
vehicles sold in the United States. The grades are
molded on the sidewalls of most passenger car
tires. The Uniform Tire Quality Grading (UTQG)
system does not apply to deep tread, winter-type
snow tires, space-saver, or temporary use spare
tires, tires with nominal rim diameters of
10 to 12 inches (25 to 30 cm), or to some
limited-production tires.
420

Tire Chains
{CAUTION:
Do not use tire chains. There is not enough
clearance. Tire chains used on a vehicle
without the proper amount of clearance
can cause damage to the brakes,
suspension, or other vehicle parts. The
area damaged by the tire chains could
cause you to lose control of your vehicle
and you or others may be injured in a
crash.
CAUTION: (Continued)
CAUTION: (Continued)
Use another type of traction device only if
its manufacturer recommends it for use
on your vehicle and tire size combination
and road conditions. Follow that
manufacturer’s instructions. To help avoid
damage to your vehicle, drive slowly,
readjust or remove the device if it is
contacting your vehicle, and do not spin
the wheels. If you do nd traction devices
that will t, install them on the front tires
for front-wheel-drive vehicles. If your
vehicle has all-wheel drive, install traction
devices on either the front tires or all four
tires, but never on the rear tires only.
424

A. Hoist Shaft
B. Folding Wrench
C. Hoist AssemblyD. Retainer
E. Compact Spare Tire
1. Flip the rear cargo area carpet cut out to
expose the hoist shaft.
2. Attach the folding wrench into the hoist shaft.
3. Turn the folding wrench counterclockwise
to lower the spare tire to the ground.
Continue turning the wrench until the spare
tire can be pulled out from under the vehicle.4. Tilt the retainer and slip it through the wheel
opening to remove the spare tire from the
cable.
5. Turn the wrench clockwise to raise the cable
back up after removing the spare tire.
Do not store a full-size or a at road tire under
the vehicle. SeeStoring a Flat or Spare Tire
and Tools on page 444.
To continue changing the at tire, seeRemoving
the Flat Tire and Installing the Spare Tire on
page 436.
431

5. Tilt the retainer and slip it through the wheel
opening to remove the spare tire from the
cable.
6. Turn the wrench clockwise to raise the cable
back up after removing the spare tire.
Do not store a full-size or a at road tire under
the vehicle. SeeStoring a Flat or Spare Tire
and Tools on page 444.
To continue changing the at tire, seeRemoving
the Flat Tire and Installing the Spare Tire on
page 436.If the spare tire will not lower, the secondary latch
may be engaged causing the tire not to lower.
434

9. Tilt the retainer and slip it through the wheel
opening when the spare tire has been
completely lowered.
10. Turn the folding wrench clockwise to raise the
cable back up if the cable is hanging.
Have the hoist assembly inspected as soon as
you can. You will not be able to store a spare tire
using the hoist assembly until it has been
repaired or replaced.Storing a Flat or Spare Tire and Tools
Storing the Flat Tire (Vehicles without
Stowable Seat and without Rear
Convenience Center)
A. D-Ring
B. Wing Nut
C. J-HookD. Valve Stem
E. Full-Size Tire
1. Flip up the D-ring located in the rear cargo area.
2. Lay the tire in the rear cargo area of the
vehicle with the valve stem up with the
center hole of the tire over the D-ring.
444

For vehicles with aluminum wheels, remove
the center cap by tapping the back of the cap
with the folding wrench.
3. Remove the J-hook and the wing nut from the
back of the jack access door. Assemble the
wing nut and the J-hook.
4. Install the wing nut and the J-hook to the
D-ring through the center hole of the tire.
5. Tighten the wing nut to secure the tire to
the oor.
Push and pull on the tire to make sure the tire
is secure and does not move.
6. Put back all tools as they were stored in the
jack storage compartment and put the
compartment cover back on.
Slip the tabs on the side of the compartment
cover into the cover opening. Push the cover in
place and push down the tabs on the cover
so that it rests in the groove. This secures the
cover in place.Storing the Flat Tire (Vehicles
with a Rear Convenience Center)
A. D-Ring
B. Rear Convenience
Center
C. Wing Nut
D. J-HookE. Full-Size Tire
F. Cap on Bottom of
Storage
Compartment
1. Open the center storage compartment door of
the rear convenience center.
2. Remove the cap on the bottom of the storage
compartment and ip the D-ring up.
445

3. Lay the tire on top of the center storage
compartment with the valve stem down.
Make sure you can see the D-ring through
the center hole of the tire.
4. Remove the J-hook and the wing nut from the
back of the jack access door. Assemble the
wing nut and the J-hook.
5. Install the wing nut and the J-hook to the
D-ring through the center hole of the tire.
6. Tighten the wing nut to secure the tire to
the oor.
Push and pull on the tire to make sure the tire
is secure and does not move.
7. Put back all tools as they were stored in the
jack storage compartment and put the
compartment cover back on.
Slip the tabs on the side of the compartment
cover into the cover opening. Push the cover in
place and push down the tabs on the cover
so that it rests in the groove. This secures the
cover in place.Storing the Flat Tire
(Vehicles with a Stowable Seat)
A. Rear Convenience
Center
B. Full-Size Tire
C. D-RingD. Stowable Seat
Strap
E. Cargo Net Hook
F. J-Hook
G. Wing Nut
1. If the seatback is not in an upright position,
move it to an upright position.
2. There is a strap attached to each side of the
stowable seat. Hook the straps to the cargo
net hook in the rear of the vehicle.
446