2007 BUICK LACROSSE lock

4. Turn the wing nut counterclockwise and
remove it.
5. Remove the compact spare tire.6. Turn the nut holding the jack counterclockwise
and remove it. Then remove the jack and
wrench.
428

2. Use the wheel wrench to loosen the plastic
wheel nut caps, if the vehicle has them, in a
counterclockwise direction.
If needed, nish loosening them by hand.
The nut caps will not come off of the wheel
cover.
3. Use the at end of the wheel wrench and pry
along the edge of the cover until it comes off.
Pull off the wheel cover and set it aside.
The edge of the wheel cover could be sharp,
so do not try to remove the cover with your
bare hands. Do not drop the cap or lay it face
down, as it could become scratched or
damaged.
If the vehicle has aluminum wheels and wheel
center caps, the wheel nuts are hidden behind the
center cap. Remove the center cap by using
the at end of the wheel wrench at the notch.
Do not drop the cap or lay it facedown, as it could
become scratched or damaged.Once you have removed the wheel cover or
center cap, use the following procedure to remove
the at tire and install the spare tire.
1. Place the wheel wrench securely over
the wheel nut. Turn the wheel wrench
counterclockwise to loosen all the wheel
nuts, but do no remove them yet.
2. Turn the jack handle clockwise to raise
the jack lift head.
Removing the Wheel Nuts
430

5. Raise the vehicle by turning the jack handle
clockwise. Raise the vehicle far enough off
the ground for the compact spare tire to
t under the vehicle.6. Remove all wheel
nuts and take off
the at tire.
432

10. Lower the vehicle by turning the jack handle
counterclockwise. Lower the jack completely.
{CAUTION:
Incorrect wheel nuts or improperly
tightened wheel nuts can cause the wheel
to come loose and even come off. This
could lead to an accident. Be sure to use
the correct wheel nuts. If you have to
replace them, be sure to get new GM
original equipment wheel nuts. Stop
somewhere as soon as you can and have
the nuts tightened with a torque wrench
to the proper torque specication. See
Capacities and Specifications on page 454
for wheel nut torque specication.
Notice:Improperly tightened wheel nuts can
lead to brake pulsation and rotor damage.
To avoid expensive brake repairs, evenly
tighten the wheel nuts in the proper sequence
and to the proper torque specication. See
Capacities and Specifications on page 454for
the wheel nut torque specication.
434

Electrical System
Add-On Electrical Equipment
Notice:Do not add anything electrical to your
vehicle unless you check with your dealer
rst. Some electrical equipment can damage
your vehicle and the damage would not
be covered by your warranty. Some add-on
electrical equipment can keep other
components from working as they should.
Add-on equipment can drain your vehicle’s battery,
even if your vehicle is not operating.
Your vehicle has an airbag system. Before
attempting to add anything electrical to your
vehicle, seeServicing Your Airbag-Equipped
Vehicle on page 80.
Headlamp Wiring
The headlamp wiring is protected by a circuit
breaker in the underhood fuse block. An electrical
overload will cause the headlamps to go on
and off, or in some cases to remain off. If this
happens, have the headlamp system checked
right away.
Windshield Wiper Fuses
The windshield wiper motor is protected by a
circuit breaker and a fuse. If the motor overheats
due to heavy snow, etc., the wiper will stop
until the motor cools. If the overload is caused by
some electrical problem, have it xed.
449

Power Windows and Other Power
Options
Circuit breakers in the instrument panel fuse block
protect the power windows and other power
accessories. When the current load is too heavy,
the circuit breaker opens and closes, protecting
the circuit until the problem is xed.
Fuses and Circuit Breakers
The wiring circuits in the vehicle are protected
from short circuits by a combination of fuses,
circuit breakers and in the fuse block wiring itself.
This greatly reduces the chance of res caused
by electrical problems.
Look at the silver-colored band inside the fuse.
If the band is broken or melted, replace the fuse.
Make sure a bad fuse is replaced with a new
one of the identical size and rating.
Instrument Panel Fuse Block
The instrument panel
fuse block is located on
the passenger’s side
of the instrument panel.
Pull off the cover
labeled FUSES to
expose the fuse block.
450

Fuses Usage
DR/LCK
TRUNKDoor Locks, Trunk
RFA/MOD Remote Keyless Entry
PRK/SWTCH Ignition Key Lock
CLSTR Cluster
STR/WHL/
ILLUMSteering Wheel Controls
Illumination
ONSTAR/ALDL OnStar
®, Data Link
Fuses Usage
INT/ILLUM Interior Lamps
PWR/SEAT Power Seat
S/ROOF Sunroof
CNSTR Canister Vent
HVAC Climate Control System
HAZRD Turn Signal, Hazard
PRK/LAMP Park Lamps
CHMSL/BKUPCenter-High-Mounted
Stoplamp/Back-up Lamps
PWR/MIR Power Mirrors
CRUISE Cruise Control
RDO/AMP Radio, Amplier
HTD/SEAT Heated Seats
HTD/MIR Heated Mirrors
PWR/WNDW Power Window
Relays Usage
RAP Retained Accessory Power
PRK/LAMP Park Lamp Relay
R/DEFOG Rear Defogger Relay
451

Underhood Fuse Block
Some fuses and relays are located in the
underhood fuse block on the passenger’s side of
the vehicle in the engine compartment. See
Engine Compartment Overview on page 350for
more information on location.
Mini-Fuses Usage
1 Driver’s Side High-Beam
2 Passenger’s Side High-Beam
3 Driver’s Side Low-Beam
Mini-Fuses Usage
4 Passenger’s Side Low-Beam
5 Windshield Wiper
6 Washer/Regulated Voltage Control
7 Fog Lamps
8 Transaxle Control Module
9 Supplemental Inatable Restraint
10 Auxiliary Power
11 Horn
12 Emission
13 Air Conditioner Clutch
14 Oxygen Sensor
15 Powertrain Control Module
16Powertrain Control Module,
Electronic Throttle Control
17 Electronic Throttle Control
18 Display
19 Anti-lock Brake Solenoid
20 Fuel Injector
21 Transaxle Solenoid
22 Fuel Pump
23 Anti-lock Brake System
24 Ignition
452