2007 BUICK LACROSSE key fob

5
E/M (English/Metric):On the base DIC,
press to choose English or Metric units.
On uplevel DICs, press the (Option)button until UNITS appears. Press the
(Set/Reset) button to choose English
or Metric units.
(Set/Reset)(if equipped): Press to
set/reset certain functions and to turn
off/acknowledge DIC messages.
(Gauges)(if equipped): Press to dis
play battery and oil life. To reset the OilLife System after an oil change, press
and hold the button while OIL LIFE
is displayed until it shows 100%.
(Fuel)(if equipped): Press to display
fuel range and average economy.
(Option) (if equipped): Press to dis
play English/Metric units, language,
personalization, compass zone andcompass calibration.
(Traction Control)(if equipped):
Press to turn traction control on or off.
(Hazard):Press to turn the hazard
warning flashers on or off.
Personalizing the DIC (if equipped)
Uplevel DICs can memorize selected
personalized settings for up to two drivers. (Some features are limited to asingle setting.)
1. Place the vehicle in Park (P) and turn
on the ignition.
2. Press the (Option) button until
PERSONALPROGRAM is
displayed.
3. Press the (Set/Reset) button
to display instructions.
4.Press the button to display
programmable features.
5. Press the button to change the
setting of each feature.
Your ignition key identifies you to the
vehicle.Two keys can be programmed
for certain features that correspond to
each driver. To personalize a key:
1. From the Personal Program menu,
press the (Option) button until
PERSONALIZE KEY is displayed.
2. Press the (Set/Reset) button until
YES is displayed.
3. Press the button.Personalization Features include:
Delayed Locking— Delays locking
of the vehicle doors for up to five
seconds after the last door is closed.
Two chimes will sound when the powerdoor lock switch or the Lock button onthe Remote Keyless Entry transmitter
is pressed when a door is open. Toprogram:
1. From the Personal Program menu,
press the (Option) button untilDELAYED LOCKING is displayed.
2. Press the (Set/Reset) button until
ON or OFF appears.
3.Press the button to select it.
The ignition key must be removed for
the feature to work after programming.
Key Fob Feedback— Choose from Off
(no feedback), Lights (exterior lightsflash) or Lights and Horn when you
press the Remote Keyless Entry transmitter (key fob) Lock button. To program:
1. From the Personal Program menu,
press the (Option) button until FOB LOCK FEEDBACK is displayed.
2. Press the (Set/Reset) button until
the desired setting is displayed.
3.Press the button to save the
setting.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 5

Getting to Know YourLaCrosse12
CONVENIENCE
Remote Vehicle Start
(if equipped)
Use the Remote Keyless Entry transmit
ter (key fob) to start the engine fromoutside the vehicle. (See the Driver
Information Center personalization menu
section to enable.) Automatic Climate
Control system vehicles will regulate the
inside temperature.
To remote start the vehicle:
1. Press and release the key fob Lock
button.
2. Press and hold the (Remote Start)
button until the turn signal lights flash.If the lights are not visible, hold theRemote Start button for four secondsand release.
The engine runs for 10 minutes. Extend
run time for 10 minutes from present bypressing the Lock and Remote Start but
tons again. Pressing only the Remote
Start button again will turn off the ignition. Maximum run time is 20 minutes.
After two remote starts have been pro
vided, the Remote Vehicle Start featurewill not operate.
See Section 2 of your Owner Manual.
Finding a Category Station
(if equipped)
Category (CAT) stations are available on
XM1 or XM2 bands only. To find a CATstation:
1. Press the CAT button to activate
Program Type (PTY) Select mode.
2. A category is displayed.
3. Rotate the Tune knob. When the
preferred category appears, press theSeek button to go to the first categorystation (pressing Seek for more thantwo seconds will activate CategoryScan).
4. To go to another station, press the
CAT button. The previously storedcategory will be displayed.
5. Press the up or down Seek button.
6. Press the CAT button to exit Program
Type Select mode.
Audio Steering Wheel Controls
(if equipped)
See Audio Systems for full details about
the functions of the following buttons:
•
(Seek)
•BAND
•1–6 (Preset Stations)
•(OnStar®/Mute):Press to silence
audio, and again to play. In OnStar
equipped vehicles, press to interactwith the OnStar system.
•
(VOLUME):Press up/down
arrow to increase/decrease volume.
See Section 3 of your Owner Manual.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 12