2007 Alfa Romeo GT key

GETTING TO KNOW YOUR CAR
58
DIGITAL MULTIFUNCTION DISPLAY (where fitted)
The digital multifunction display shows the following: clock, outside temperature, buzzer setting (buzzer on/off), rheostat (light adjustment),
condition of the inertial fuel cut-off switch (FPS on).
CONTROL BUTTONS (fig. 75)
To make use of the information the digital display (with the ignition key at MAR) is able to give, you should firstly familiarise with the con-
trol buttons on the plate at the side of the steering column, using them as described in the following paragraphs. Before doing anything at all,
you are advised to read this chapter in full.
To decrease the value displayed
To decrease the value displayed Press for less than 1 second (pulse), indicated with
Qin the following de-
scriptions, to access the various adjustments
Press for more than 2 seconds, indicated with
Rin the following descriptions,
to confirm the choice required and return to the previous display
fig. 75
A0A1105b

GETTING TO KNOW YOUR CAR
63
Engine oil level check
(JTD versions)
Turning the ignition key to MARthe dis-
play shows the engine oil level for a few sec-
onds. During this phase, to clear the display
and move to next screen, press briefly but-
tonMODE.
IMPORTANTTo make sure that the en-
gine oil level displayed is correct, carry out
the check with the car on level ground.
Fig. 85refers to the correct engine oil
level display. As the oil level gradually falls,
the full bars go off leaving room for the emp-
ty ones.
fig. 85
A0A9101g
fig. 86
A0A9102g
fig. 87
A0A9103g
Fig. 86refers to the display with an oil
level below the preset minimum. In this con-
dition the bars are all empty.
IMPORTANTIn this case the correct en-
gine oil level should be restored as soon as
possible, see “Checking levels” in section
“Car maintenance”. Fig. 87refers to the display with an oil
level above the preset maximum. In this con-
dition the bars are all full.
IMPORTANTIn this case, contact Alfa
Romeo Authorised Services who will restore
the correct engine oil level.

GETTING TO KNOW YOUR CAR
68
BUZZER
This option enables to adjust the volume
of the roger-beep accompanying the acti-
vation of the car buttons and any fail-
ure/warning indication shown on the dis-
play.
To adjust the volume proceed as follows:
❒press briefly button MODE: the display
will show the previously set volume
“level”;
❒press buttons ▲/▼for setting;
❒press briefly button MODEto go back
to the menu screen or press the button
for long to go back to the standard
screen.
IMPORTANTIn the buzzer OFFcon-
dition, any buzzer failure warnings are main-
tained.
SERVICE
Through this function it is possible to dis-
play information connected to proper car ser-
vicing.
To consult this function, proceed as follows:
❒press briefly button MODE: service in
“km” or “mi” according to previous
setting, will be displayed (see para-
graph “UNITS”);
❒press buttons ▲/▼to display the re-
quired service info;
❒press briefly button MODEto go back
to the menu screen or press the button
for long to go back to the standard
screen.
IMPORTANTThe Service Schedule in-
cludes car maintenance every 20,000 km;
this is shown automatically, with the igni-
tion key to MAR, starting from 2,000 km
(or mi) from this deadline and it will be dis-
played again every 200 km. The display can
only be reset by Alfa Romeo Authorized Ser-
vices.
MENU OFF
Selecting this option will bring back to stan-
dard screen.
❒press briefly button MODEto select
the consumption unit (or press the but-
ton for long to go back to the standard
screen);
❒If the distance unit set is “km”, the dis-
play will show “l/100km” or
“km/l”: press buttons
▲/▼for set-
ting. If the distance unit set is “mi”, the
display will show “mpg”;
❒press briefly button MODEto go back
to the menu screen or press the button
for long to go back to the standard
screen.
IMPORTANTThe temperature unit (°C
or °F) set on the display is also shown on
the displays of the two-zone climate control
(where provided) and radionavigator (where
provided).

GETTING TO KNOW YOUR CAR
71
SET BUTTON
This button, set on the right steering col-
umn stalk (fig. 86), shall be used (with
ignition key MAR), to enter the GENERAL
TRIP and TRIP B functions.
ButtonSETshall also be used to reset the
GENERAL TRIP and TRIP B functions to start
a new mission:
-short push: to go to next screen;
-long push: to reset and then start a
new mission. Start of journey procedure
(reset)
With ignition key at MAR, press and keep
buttonSETpressed for over 2 seconds to
reset.
The reset operation (button SETpressed
for over 2 seconds) in the presence of the
screens concerning the GENERAL TRIP makes
it possible to reset also the TRIP B.
The reset operation (button SETpressed
for over 2 seconds) in the presence of the
screens concerning only the TRIP B makes
it possible to reset only the information as-
sociated with this function.
IMPORTANTRANGE and ACTUAL CON-
SUMPTION information cannot be reset. New mission(reset)
Reset can be:
❒“manual”: reset is performed by the dri-
ver by pressing for long button SET;
❒“automatic”: reset is performed when
the “travel distance” reaches 9999.9
km (or mi), when “travel time” reach-
es 99:59 (99 hours and 59 minutes)
or after disconnecting and then recon-
necting the battery.
fig. 86
A0A0021b

GETTING TO KNOW YOUR CAR
72
Handbrake on
The warning light turns on when the hand-
brake is on. HIGH ENGINE
COOLANT
TEMPERATURE (red)
Turning the ignition key to MARthe warn-
ing light turns on, but it should go off after
few seconds.
The warning light turns on (together with
message + symbol on the display) when the
engine is overheated: if the warning light
comes on when driving, stop the car leav-
ing the engine on and slightly accelerated
to further activate the circulation of the
coolant fluid.
If the warning light does not turn off with-
in the next 2 or 3 minutes, stop the engine
and contact Alfa Romeo Authorized Services.
WARNING LIGHTS
AND MESSAGES
IMPORTANTThe presence of warning
lights depends on the type of engine and
equipment with which the car is fitted.
LOW BRAKE FLUID
LEVEL (red)
HANDBRAKE
ON (red)
Turning the ignition key to MARthe warn-
ing light turns on, but it should go off after
few seconds.
Low brake fluid level
The warning light turns on (together with
message + symbol on the display) when the
level of the brake fluid in the reservoir falls
below the minimum level, due to possible
leak in the circuit.
x
If the warning light turns
on when travelling, check
that the handbrake is not
engaged. If the warning light stays
on with handbrake disengaged,
stop the car immediately and con-
tact Alfa Romeo Authorized Ser-
vices.
u

GETTING TO KNOW YOUR CAR
73
LOW ENGINE
OIL PRESSURE
Message + symbol are displayed when en-
gine oil pressure is low.
LOW BATTERY
CHARGE
Message + symbol are displayed when the
battery charge is low.
If message + symbol are displayed, con-
tact immediately Alfa Romeo Authorized Ser-
vices.
AIR BAG FAILURE
(red)
Turning the ignition key to MARthe warn-
ing light turns on, but it should go off after
few seconds.
The warning light stays on glowing steadi-
ly if there is a failure in the air bag system.
¬vw
If when turning the igni-
tion key to MAR, the
warning light
¬does not
turn on or if it stays on when trav-
elling there could be a failure in
safety systems; in this event air
bags or pretensioners could not
trigger in case of impact or, in a mi-
nor number of cases, they could
trigger accidentally. Before restart-
ing contact Alfa Romeo Authorized
Services.
The failure of the warning
light
¬(warning light off)
is also indicated by the
flashing for more than the normal
4 seconds of the air bag warning
light
¬.
If message + symbol are
displayed when travelling
stop the engine immedi-
ately and contact Alfa Romeo Au-
thorized Services.

GETTING TO KNOW YOUR CAR
74
BRAKE PAD WEAR
With the brake pedal pressed, the display
will show message + symbol when front
brake pads are worn; in this case have them
changed as soon as possible.
IMPORTANTSince the car is fitted with
wear sensors for the front brake pads, when
changing them, check also the rear brake
pads.
SELESPEED
TRANSMISSION
FAILURE
(2.0 T.SPARK
Selespeed versions)
On versions with Selespeed transmission,
message + symbol are displayed when there
is a failure in the Selespeed transmission. In
the event of Selespeed transmission failure,
go as soon as possible to the nearest Alfa
Romeo Authorized Services and have the
system checked.
ENGINE CONTROL
SYSTEM FAILURE
(EOBD) (amber)
(upon request for versions/
markets where applicable)
In normal conditions, turning the ignition
key to MAR, the warning light turns on,
but it should go off when the engine has
started. The initial turning on indicates that
the warning light is working properly.
If the warning light stays on or turns on
when travelling (together with message +
symbol on the display):
glowing steadily- means a fault in the
supply/ignition system which could cause
high emissions at the exhaust, possible lack
of performance, poor handling and high con-
sumption levels. In these conditions it is pos-
sible to continue driving without however re-
quiring heavy effort or high speed from the
engine. Prolonged use of the car with the
warning light on may cause damages. Con-
tact Alfa Romeo Authorized Services as soon
as possible. The warning light goes off if the
fault disappears, but it is however stored by
the system;
SEAT BELTS NOT
FASTENED (red)
The warning light turns on glowing steadi-
ly with ignition key at MAR, when the dri-
ver’s seat belt is not fastened correctly.
INCOMPLETE DOOR
LOCKING
Message + symbol are displayed when
one or more doors or the bonnet are not
properly shut.
´
t
U

GETTING TO KNOW YOUR CAR
75
ALFA ROMEO CODE
SYSTEM
Turning the key to MARthe symbol on
the display shall flash only once and then
go off. If with the ignition key at MAR, the
symbol stays on the display (together wit
the message), this indicates a possible fail-
ure (see “Alfa Romeo CODE system”).
IMPORTANTThe turning on at the
same time of warning light
Uand sym-
bol
Yindicates a failure of the Alfa Romeo
CODE system.
If with the engine running, the display
shows message + symbol, this means that
the car is not protected by the engine im-
mobilising device (see “Alfa Romeo CODE
system” in this section). Contact Alfa Romeo
Authorized Services to have all the keys
memorised.
GLOW PLUG
WARMING
(diesel versions)
GLOW PLUG WARMING
FAILURE (diesel versions)
Glow plug warming
Turning the ignition key to MAR, the dis-
play shows message + symbol. The symbol
will turn off when glow plugs reach the pre-
set temperature. Start the engine immedi-
ately after the symbol turns off.
IMPORTANTWith mild or hot ambient
temperature, warning light stays on for very
short time. flashing- indicates the possibility of dam-
age to the catalyst (see “EOBD system” in
this section). If the light flashes, it is nec-
essary to release the accelerator pedal to
lower the speed of the engine until the warn-
ing light stops flashing; continue the journey
at moderate speed, trying to avoid driving
conditions that may cause further flashing
and contact Alfa Romeo Authorized Services
as soon as possible.
Y
If, turning the ignition key
to MAR, the warning light
Udoes not turn on or if it
turns on glowing steadily or flash-
ing when travelling, contact Alfa
Romeo Authorized Services as
soon as possible.
m