2007 Alfa Romeo 166 check oil

When the cap (B) is
screwed off the reser-
voir ensure that the
electrical connections are not dis-
connected. Make sure that the
highly corrosive brake fluid
does not drip onto the paint-
work. If it does, wash it off
immediately with water.
IMPORTANT Contact Alfa Romeo Au-
thorized Services for maintenance and re-
pair operations.Oil consumption is very
low; if topping up again
is needed shortly after-
wards, have the system checked
for possible leaks by Alfa Romeo
Authorized services.
CHECKING AND TOPPING UP
THE BRAKE AND CLUTCH
FLUID
(fig. 11)
Check that the fluid level in the reservoir
is at maximum. Top up with the brake flu-
id specified in the table “Fluids and lubri-
cants” (see section “Technical Specifica-
tions ").
NOTEClean accurately the tank cap A
and the surrounding surface. When open-
ing the cap take the utmost care to pre-
vent impurities entering the tank. When
topping up, always use a funnel with
built-in filter with mesh equal to or lower
than 0.12 mm. On JTD 20V Multijet versions insert the
tube on the cap and refit the cover fasten-
ing with the three screws.
Do not allow power
steering fluid to touch hot
engine parts: it is inflammable.
WARNING
A0D0102m
fig. 11
216
IMPORTANTFor this operation it is
however recommended to contact Alfa
Romeo Authorised Services.
From time to time check the instrument
panel warning light by pressing cover (B)
of the reservoir (A) (with the ignition
key at MAR) the instrument warning
panel light
xshould come on.

225
– Application of enamels with greater
resistance to atmospheric pollutants.
– Adoption of “open” boxed parts to
prevent condensation from triggering cor-
rosion from the inside.
The underbody is treated with the appli-
cation of a special protective material.
If this protective layer requires restora-
tion the exhaust system, lambda probe
and catalytic converter must be left free
of any wax, oil, plastic and/or inflamma-
ble product.
This should therefore be carried out by
Alfa Romeo Authorized Services.SPRAY JETS
Make sure that the windscreen and
headlight washer jets deliver a jet of fluid
which is adequate and correctly directed.
If the spray devices are not working
check that the supply circuit is not
blocked. If necessary unclog the nozzles
using a needle.
BODYWORK
PROTECTION FROM
ATMOSPHERIC AGENTS
Alfa Romeo employs manufacturing
technologies which are designed to pro-
tect the bodywork against chemical corro-
sion caused by various factors, for exam-
ple:
– atmospheric pollution.
– Salty air and humidity (coastal areas,
hot-humid climates).
– Road surfaces covered with salt and
de-icing products during the winter.
To further increase resistance against
corrosion the following procedures have
been adopted:
– painting system and paint products
which render the vehicle particularly resis-
tant to corrosion and abrasion.
– Wide use of sheet metal which is ex-
tremely resistant to corrosion.
– Spraying of the underbody, engine
bay, wheel arches and boxed parts with
suitable products which adhere strongly
to the metal parts and have a high pro-
tection capability.

228 INTERIOR FITTINGS
Periodically check that water is not
trapped under the carpets (due to water
dripping off shoes, umbrellas etc.) which
could cause oxidisation of the sheet metal.
CLEANING SEATS AND CLOTH
PA R T S
– For the seats and parts in fabric (vel-
vet, suede, etc.)dust may be removed us-
ing a soft brush.
– To remove grease stains specific prod-
ucts may be used closely following the
manufacturer’s instructions.
– For more accurate cleaning, rub the
seats with a sponge moistened with a so-
lution of water and neutral detergent in
the proportions stated on the package.Never use spirit or alco-
hol-based products.
CLEANING LEATHER PARTS
– Remove dried on dirt with a chamois
leather or a lightly moistened cloth with-
out pressing too hard.
– Remove liquid and grease stains with
a dry absorbent cloth without rubbing.
Following this wipe with a soft cloth or
chamois leather moistened with water
and neutral soap.
If the stain persists use specific products
in accordance with the instructions for
use.
Never use inflammable
products such as fuel oil
ether or rectified petrol. The elec-
trostatic charges generated by rub-
bing when cleaning may cause fire.
WARNING
Upholstery of your car
has been designed to
withstand wear deriv-
ing from common use of
the car. You are however recom-
mended to avoid strong and/or
continuous scratching with cloth-
ing accessories such as metallic
buckles, studs, Velcro fastenings
and the like, since these items
cause circumscribed stress of the
cover fabric that could lead to
yarn breaking, and damage the
cover as a consequence.

264
Engine starting ..............................134
EOBD (system) ..............................113
First aid kit ..................................199
Fluids and lubricants ......................243
Fog lamps ......................................93
"Follow me home" device ................60
Front roof lamp..............................100
Fuel consumption ..........................240
Fuel flap ........................................94
Fuel oil filter ..................................219
Fuel reserve ....................................73
Fuel tank cap ................................127
Fuses and relays ............................186
Gear shift ......................................95
Getting to know your car........11
Glovebox ........................................98
Handbrake ....................................95
Hazard warning lights ......................93Headlamps ....................................110
Headrests........................................33
High beam headlamps ......................58
Identification data..................232
In an emergency ............................157
In the event of an accident ..............198
Inside rear-view mirror ......................36
Installation of electric/
electronic devices ......................156
Instrument cluster ............................12
Instrument light dimmer ....................94
Interior equipment ............................96
Interior maintenance ......................228
Keys............................................ 16
Level checking ..............................209
Light switch ....................................57
Low beam headlamps ......................58
Luggage compartment ....................110
Maintenance
- Additional operations ................206
- Annual Inspection Programme ....206
- Maintenance programme ..........204
- Scheduled Maintenance ............202
Mileage recorder ..............................70
Number plate lights ......................179
Oddments compartments........103-104
Oddment compartment light ............183
Parking ......................................138
Parking lights ..................................58
Parking sensors................................67
Performance ..................................239
Pollen/dust filter ......................90-219
Position lights ..................................58
Power steering ..............................142
Power windows ..............................38