Page 170 of 442
You can use the inside of the lid f or a
pen holder, a coin holder and a card
holder.The console compartment has two
shelves to divide it into two levels.
To store small items, you can use the
upperhalfofthespacebyputting
the shelves down until they latch.
The f ront and rear shelves can be
used separately.When you store a large item like a
brief case, lif t the shelves up to
create a large space.
The console compartment light
comes on when the parking lights
are on. The items on each shelves should
not exceed 11 lbs (5 kg). Heavy
items may damage the shelves.The maximum dimensions of the
item you can store in the console
compartment are:
Length: 16.9 in (430 mm)
Height: 12.2 in (310 mm)
Width: 5.5 in (140 mm)
Interior Convenience Items
166
LID
CARD HOLDER PEN HOLDER
COIN
HOLDER
SHELVES
——
y
y
() y
y
Page 412 of 442

ÎÎ
Î
Î
Specif ications
408
Dimensions
Weights
Engine
Capacities
Capacities
1.66 US gal (6.3)
8.1 US qt (7.7
)
2.6 US qt (2.5
)
2.9 US qt (2.7)
Length
Width
Height
Wheelbase
Track
65.2 in (1,655 mm)
104.3 in (2,650 mm)
61.9 in (1,572 mm)
62.6 in (1,590 mm)
Gross vehicle weight rating See the certification label attached to the driver’s doorjamb.
Type
BorexStroke
Displacement
Compression ratio
Spark plugs Water cooled 4-stroke DOHC
i-VTEC 4-cylinder gasoline engine with turbo charger
3.39 x 3.90 in (86.0 x 99.0 mm) 140.4 cu-in (2,300 cm
)
8.8 : 1
Fuel tank
Engine oil 18.0 US gal (68
)
5.0 US qt (4.7
)
4.6 US qt (4.4)
6.1 US qt (5.8) Excluding the oil remaining in the engine
Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity:
0.190 US gal (0.72
)
180.7 in (4,590 mm)
73.6 in (1,870 mm)
2.40 US gal (9.1
)
3.5 US qt (3.3)
2.6 US qt (2.5
)
4.8 US qt (4.5)
Engine
coolant
Automatic
transmission
fluid
Rear
differential
fluid
Windshield
washer
reservoir
SILKR8A-S
Approx.
Front
Rear
Change
Without filter
Total Change
Total
Change
Total
Change
Total
U.S. Vehicles
Canada
Vehicles
1:
2:
(NGK)
1 2
Including filter
——
y
y
() y
y
Page 414 of 442

µ
The tires on your vehicle meet all
U.S. Federal Saf ety Requirements.
All tires are also graded f or
treadwear, traction, and temperature
perf ormance according to
Department of Transportation
(DOT) standards. The f ollowing
explains these gradings.
Quality grades can be f ound where
applicable on the tire sidewall
between the tread shoulder and the
maximum section width. For
example: The treadwear grade is a compara-
tive rating based on the wear rate of
the tire when tested under controlled
conditions on a specif ied government
test course. For example, a tire
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative perf ormance of
tires depends upon the actual condi-
tions of their use, however, and may
depart signif icantly f rom the norm
due to variations in driving habits,
service practices, and dif f erences in
road characteristics and climate.The traction grades, f rom highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specif ied government test surf aces
of asphalt and concrete. A tire
marked C may have poor traction
perf ormance.
Warning: The traction grade
assignedtothistireisbasedon
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
All passenger car tires must conf orm
to Federal Saf ety Requirements in
addition to these grades.
DOT Tire Quality Grading (U.S. Vehicles)
T readwear 200
Traction AA
Temperature A
Unif orm T ire Quality Grading Treadwear
Traction AA, A, B, C
410
——
y
y
() y
y
Page 416 of 442

µµ
µ µ µ
µ µ
µ
µ
µ
µ µ
The tires that came on your vehicle
have a number of markings. Those
you should be aware of are described
below.
Speed symbol (an
alphabetical code indicating
the maximum speed rating). Load index (a numerical code
associated with the maximum
load the tire can carry).
Whenever tires are replaced, they
should be replaced with tires of the
same size. Below is an example of
tire size with an explanation of what
each component means. Tire width in millimeters.
Aspect ratio (the tire’s section
height as a percentage of its
width).
Tire construction code (R
indicates radial).
Rim diameter in inches. The tire identif ication number (TIN)
is a group of numbers and letters
that look like the f ollowing example
TIN. TIN is located on the sidewall
of the tire.
Max Load The maximum load the
tire can carry at maximum air
pressure. Max Press The maximum air
pressurethetirecanhold.
Date of manuf acture.
Tire type code. Manuf acturer’s
identification mark.
This indicates that the tire
meets all requirements of
the U.S. Department of
Transportation.
R DOT
B97R
FW6X2202
235
55
18 99
V
Tire Labeling
Tire Size
T ire Ident if icat ion NumberMaximum T ire L oad
Maximum T ire Pressure
412
P235/55R18 99V
DOT B97R FW6X 2202
——
y
y
() y
y