Page 342 of 442
ÛÝ
ÛÝ
When you see this message, have
the indicated maintenance done by
your dealer immediately. The system message indicator on
the instrument panel will also come
on, and a beeper will sound.
The system message will appear
again by pressing the INFO ( / )
button af ter cancel it.
You will also see the system
message every time you turn the
ignition switch to the ON (II)
position until your vehicle have the
indicated maintenance perf ormed by
your dealer.
To cancel the system message, press
and release the INFO ( / ) button
on the steering wheel. At this time,
the system message indicator will be turned of f . Then the display
will change to the engine oil lif e
display. You will see the engine oil
lif e blinking and a ‘‘SERVICE’’
message along with the maintenance
item code(s) on the multi-
inf ormation display.
Maintenance Minder
not
338
——
y
y
() yy
Page 343 of 442

ÛÝ
ÛÝ The system message will appear
again by pressing the INFO ( / )
button af ter cancel it.
You will also see the system
message every time you turn the
ignition switch to the ON (II)
position until your vehicle have the
indicated maintenance perf ormed by
your dealer.
Negative mileage means your
vehicle has passed the maintenance
required point.
If the indicated maintenance is not
perf ormed, you will see a " SERVICE
PAST DUE" message along with the
maintenance item code(s), and the
negative mileage will be also
displayed. The negative mileage
continues to display af ter the vehicle
has been driven 10 miles (10 km) or
more. To cancel the system message, press
and release the INFO ( / ) button
on the steering wheel. At this time,
the system message indicator will
be turned of f . Then the display
will change to the engine oil lif e
display. You will see the negative
mileage blinking and a ‘‘SERVICE’’
message along with the maintenance
item code(s) on the multi-
inf ormation display. Immediately have the service
perf ormed, and make sure to reset
the display as described on the
f ollowing.
Maintenance Minder
not
Maint enance
339
U.S.
U.S.
Canada Canada
——
y
y
() yy
Page 347 of 442

Î
Î
Ì Ì
Ì
Î
Maintenance Minder
343
: Maintenance
Main Items
Replace engine oil
Replace engine oil and oil filter
Inspect front and rear brakes
Check parking brake adjustment
Inspect these items:
Tie rod ends, steering gear box, and boots
Suspension components
Driveshaft boots
Brake hoses and lines (including ABS)
All fluid levels and condition of fluids
Exhaust system
Fuel lines and connect ions Maintenance
Sub Items
Rotate tires
Replace air cleaner element
If you drive in dusty conditions, replace
every 15,000 miles (24,000 km).
Replace dust and pollen filter
If you drive primarily in urban areas that have high
concentrations of soot in the air from industry and
from diesel-powered vehicles, replace every 15,000
miles (24,000 km).
Inspect drive belt
Replace transmission and transfer fluid
Driving in mountainous areas at very low vehicle
speeds or trailer towing results in higher
transmission and transfer temperatures. This
requires transmission and transfer fluid changes
more frequently than recommended by the
maintenance minder. If you regularly drive your
vehicle under these conditions, have the transmission
and transfer fluid changed at 60,000 miles
(100,000 km), then every 30,000 miles (48,000 km).
Replace spark plugs
Inspect valve clearance
Replace engine coolant
Replace rear differential fluid
Driving in mountainous areas at very low vehicle
speeds or trailer towing results in higher level of
mechanical (shear) stress to fluid. This requires
differential fluid changes more frequently than
recommended by the Maintenance Minder. If you
regularly drive your vehicle under these conditions,
have the differential fluid changed at 7,500 miles
(12,000 km), then every 15,000 miles (24,000 km).
A
B
Symbol
Symbol
1
2
3
4
5
6
1
1
If the message ‘‘SERVICE’’ does not appear more than 12 months after the
display is reset, change the engine oil every year.
If the message ‘‘SERVICE DUE NOW’’ does not appear more than 12 months
after the display is reset, change the engine oil every year.
See information on maintenance and emissions warranty on page .
Adjust the valves during services A, B, 1, 2, or 3 only if they are noisy. Inspect idle speed every 160,000 miles (256,000 km). Independent of the maintenance items in the information display, replace
the brake fluid every 3 years.
NOTE: 1:
342
On RDX model
On RDX with Technology Package model
Maintenance Minder
——
y
y
() yy
Page 353 of 442

Always change the oil and f ilter
according to the maintenance
messages shown on the inf ormation
display or multi-inf ormation display
(depending on models). The oil and
f ilter collect contaminants that can
damage your engine if they are not
removed regularly.Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood, and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.Remove the oil f ilter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Install a new oil f ilter according to
the instructions that come with it. Check the oil f ilter to make sure
its gasket did not stick to the f ilter
base. A stuck gasket could cause
an oil leak.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
technician. 1.
2.3.
4.
5.
Changing the Oil and Filter
Maint enance
349
WASHER
OIL
FILTER
OIL DRAIN
BOLT
——
y
y
() yy
Page 354 of 442
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
Refill the engine with the recom-
mended oil.
Engine oil change capacity
(including f ilter):Turn of f the engine and let it sit
f or several minutes, then check
the oil level on the dipstick. If
necessary, add more oil. Let the engine run f or several
minutes, then check the drain bolt
and oil f ilter f or leaks. Replace the engine oil f ill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn of f the
engine, and check your work.
6.
7. 8.
9.
10.
Changing the Oil and Filter
350
29 lbf·ft (39 N·m , 4.0 kgf·m)
4.9 US qt (4.6
) Improper disposal of engine oil can be
harmf ul to the environment. If you
change your own oil, please dispose of
the used oil properly. Put it in a sealed
container and take it to a recycling
center. Do not discard it in a trash bin
or dump it on the ground.
——
y
y
() yy
Page 363 of 442

Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
cargo area or pull a trailer,
readjustment may be required.
Adjustmentsshouldbedonebyyour
dealer or other qualif ied technician.
The low beam headlight bulbs are a
type of high voltage discharge tube.
High voltage can remain in the
circuit even with the light switch of f
and the key removed. Because of
this, you should not attempt to
examine or change a low beam
headlight bulb yourself . If a low
beam headlight bulb fails, take the
vehicle to your dealer to have it
replaced.Your vehicle has halogen headlight
bulbs. When replacing a bulb, handle
it by its base, and protect the glass
f rom contact with your skin or hard
objects. If you touch the glass, clean
it with denatured alcohol and a clean
cloth.
Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
Push the electrical connector onto
the new bulb.
Turn on the headlights to test the
new bulb.
Remove the bulb by turning it
about one-quarter turn
counterclockwise. Remove the electrical connector
f rom the bulb by pushing on the
tab and pulling the connector
down. Open the hood.
1.
2. 3.
4.
5.
Headlight A iming
L ow Beam Headlight Bulb
Replacement
Replacing a High Beam Headlight
Bulb
Lights
Maint enance
359
BULB
CONNECTORHalogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.
——
y
y
() yy
Page 384 of 442

Fill the f uel tank.
Change the engine oil and f ilter.
Wash and dry the exterior
completely.
Cleantheinterior.Makesurethe
carpeting, floor mats, etc., are
completely dry.Block the rear wheels.
If the vehicle is to be stored f or a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
Cover the vehicle with a
‘‘breathable’’ cover, one made
f rom a porous material such as
cotton. Non-porous materials, such
as plastic sheeting, trap moisture,
which can damage the paint.
If you need to park your vehicle f or
an extended period (more than 1
month), there are several things you
should do to prepare it f or storage.
Proper preparation helps prevent
deterioration and makes it easier to
get your vehicle back on the road. If
possible, store your vehicle indoors. Leave one window open slightly (if
the vehicle is being stored
indoors).
Disconnect the battery.
Support the f ront and rear wiper
blade arms with a f olded towel or
ragsotheydonottouchthe
windshield.
To minimize sticking, apply a
silicone spray lubricant to all door
and tailgate seals. Also, apply a
vehiclebodywaxtothepainted
surfaces that mate with the door
and tailgate seals.If possible, periodically run the
engine until it reaches f ull
operating temperature (the
cooling f ans cycle on and of f
twice). Pref erably, do this once a
month.
Leave the parking brake off. Put
the transmission in Park.
Vehicle Storage
380
——
y
y
() yy
Page 412 of 442

ÎÎ
Î
Î
Specif ications
408
Dimensions
Weights
Engine
Capacities
Capacities
1.66 US gal (6.3)
8.1 US qt (7.7
)
2.6 US qt (2.5
)
2.9 US qt (2.7)
Length
Width
Height
Wheelbase
Track
65.2 in (1,655 mm)
104.3 in (2,650 mm)
61.9 in (1,572 mm)
62.6 in (1,590 mm)
Gross vehicle weight rating See the certification label attached to the driver’s doorjamb.
Type
BorexStroke
Displacement
Compression ratio
Spark plugs Water cooled 4-stroke DOHC
i-VTEC 4-cylinder gasoline engine with turbo charger
3.39 x 3.90 in (86.0 x 99.0 mm) 140.4 cu-in (2,300 cm
)
8.8 : 1
Fuel tank
Engine oil 18.0 US gal (68
)
5.0 US qt (4.7
)
4.6 US qt (4.4)
6.1 US qt (5.8) Excluding the oil remaining in the engine
Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity:
0.190 US gal (0.72
)
180.7 in (4,590 mm)
73.6 in (1,870 mm)
2.40 US gal (9.1
)
3.5 US qt (3.3)
2.6 US qt (2.5
)
4.8 US qt (4.5)
Engine
coolant
Automatic
transmission
fluid
Rear
differential
fluid
Windshield
washer
reservoir
SILKR8A-S
Approx.
Front
Rear
Change
Without filter
Total Change
Total
Change
Total
Change
Total
U.S. Vehicles
Canada
Vehicles
1:
2:
(NGK)
1 2
Including filter
——
y
y
() y
y