2007 Acura MDX ECU

Push and pull the child seat
f orward and f rom side to side to
verify that it is secure. Attach the tether strap hook to the
tether anchor, then tighten the
strap as instructed by the child
seat maker.To install a LATCH-compatible child
seat in the center seating position on
the second row seat, use the center
lower anchors as shown above. Follow step 1 through 4 as
described previously to secure the
child seat.
Lower the head restraint f irst.
Route the tether strap over the
head restraint and seat-back, then
attach the tether strap hook to the
anchor, making sure the strap is
not twisted.
Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure.
Pull up the cover below the
armrest and f ind one of the
anchors. The other anchor is
located underneath the f lap at the
bottom of the outer seat’s inner
bolster.
6.
7. 2.
3.
4.
1.
Using t he Cent er L A T CH
Installing a Child Seat
Driver and Passenger Saf ety
49
——y
y
()-yy

When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.
With the child seat in the desired
seating position, route the belt
th rough the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckl e. To
activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
th en let the belt feed back into the
retractor.
After the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps.
In
addition, the lap/shoulder belts in
all seating positions except the
driver’s have a lockable retractor
that must be activated to secure a
child seat.
If you intend to install a child seat in
the center seating position of second
row seat, make sure the detachable
seat belt is securely latched (see
page ). 1.
2.
3.
144
Installing a Child Seat with a L ap/
Shoulder Belt
Installing a Child Seat
50
——y

y
()-yy

Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure enough to
stay upright during normal driving
maneuvers. If the child seat is not
secure, unlatch the belt, allow it to
retract f ully, then repeat these
steps.A child seat with a tether can be
installed in any seating position in
the second or third row.
To deactivate the lockable retractor
and remove a child seat, unlatch the
buckle, unroute the seat belt, and let
the belt fully retract. Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available.
Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt.
4. 5.
CONT INUED
Installing a Child Seat with a
Tether
Installing a Child Seat
Driver and Passenger Saf ety
51
——y
y
()-yy

Each second row seat has a tether
anchorage point behind the seat-
back. After
properly securing the child
seat in the desired position (see
page ), lif t the head restraint,
then route the tether strap over
the seat-back. For the center seat, lower the head
restraint, then route the tether strap
over the head restraint and seat-back.
1.
50
Second Row Inst allat ion
Installing a Child Seat
52
TETHER ANCHORAGE POINT TETHER STRAP
Outer Seating Position
——y
y
()-yy

Route the tether strap over the
head restraint, then attach the
tether strap hook to the anchor,
making sure the strap is not
twisted.
Each
third row seat has a tether
an chorage point on the tailgate sill.
Secure the child seat in the
desired position (see page ).
Select
the anchor point you want
to use. Then open the anchor
cover with a small flat-tip
screwdriver.
Tighten
the strap according to the
seat maker’s instructions.
Attach
the tether strap hook to the
anchor, making sure the tether
strap is not twisted.
2. 1. 3.
2.
3.
50
Installing a Child Seat
T hird Row Inst allat ion
Driver and Passenger Saf ety
53
——y

y
()-yy

If you decide that a child can saf ely
ride up f ront, be sure to:Caref ully read the owner’s manual,
and make sure you understand all
seat belt instructions and all saf ety
inf ormation.
Move the vehicle seat to the rear-
most position.
Have the child sit up straight, back
against the seat, and feet on or
near the f loor.
Check that the child’s seat belt is
properly and securely positioned.
Supervise the child. Even mature
children sometimes need to be
reminded to f asten the seat belts
or sit properly. This could result
in serious neck injuries during a
crash.
This could
cause very serious injuries during
a crash. It also increases the
chance that the child will slide
under the belt in a crash and be
injured.
If they do, they
could be very seriously injured in a
crash. Devices intended to
improve a child’s comf ort or
reposition the shoulder part of a
seat belt can make the belt less
ef f ective and increase the chance
of serious injury in a crash.
Protecting L arger Children
Additional Saf ety Precautions
Do not let a child wear a seat belt
across t he neck.
Do not let a child put the shoulderpart of a seat belt behind t he backor under t he arm.
T wo children should never use thesame seat belt . Do not put any accessories on a
seat belt.
Driver and Passenger Saf ety
57
——y
y
()-yy

Î Î
Î
The U.S. instrument panel is shown. Differences for the Canadian models are noted in the text.
:
: If equipped
Instrument Panel
Instru me ntsand Cont ro ls
63
LOW TIRE PRESSURE
INDICATOR
CRUISE CONTROL
INDICATOR
ANTI-LOCK
BRAKE SYSTEM
INDICATOR SYSTEM
MESSAGE INDICATOR
HIGH BEAM INDICATOR MULTI-INFORMATION
DISPLAY
LOW OIL PRESSURE INDICATOR
VSA ACTIVATION INDICATOR
MALFUNCTION
INDICATOR
LAMP
A/T TEMPERATURE INDICATOR LIGHTS
ON INDICATOR
SEAT
BELT REMINDER INDICATOR
SUPPLEMENTAL RESTRAINT
SYSTEM INDICATOR
CHARGING SYSTEM INDICATOR
SECURITY SYSTEM INDICATOR
(P.65)
SIDE
AIRBAG OFF
INDICATOR
SH-AWD INDICATOR
IMMOBILIZER SYSTEM
INDICATOR
FOG LIGHT INDICATOR
ACTIVE
DAMPER SYSTEM
INDICATOR
PARKING BRAKE AND BRAKE SYSTEM INDICATOR
CRUISE
MAIN INDICATOR
(P.68)
(P.70)
(P.71)
(P.66)
(P.69) (P.69)
(P.65)
(P.68)
(P.65) (P.70) (P.67)(P.67)
(P.71)
(P.70)
(P.70)
LOW
FUEL
INDICATOR (P.71)(P.68)
(P.66)
(P.66)
(P.70)
(P.64)
(P.73)
VEHICLE STABILITY ASSIST (VSA) SYSTEM INDICATOR
(P.431)
——y
y
()-yy

Thisindicatornormallycomeson
when you turn the ignition switch to
theON(II), and remains on until the
engine starts.Ifthisindicato rcomes
on at anyothertime,thereisa
problem in thesystem.Whilethis
indicator is on, thecomfortbutton
will not work, and thesystemwill
not function.Youwill also see a
"CHECK ADSSYSTEM" message on
the multi-info rmation display. Have
the vehicl echeckedby your dealer as
soonaspossible.For more
info rmation,seep age. Thisindicato
rcomesonasa
reminderthatyoumustrefuelsoon.
Whentheindicatorcomeson,t here
isabout1.8USgal(7.0
)offuel
remainingi nthetankbeforethe
needlereachesE.Thereisasmall
reserveoffuelremaininginthetank
whentheneedledoesreachE. You T
hi
si ndic at orc
omesonwhenthe
securitysystemisset.Seepage formoreinformationonthe
securitysystem.
353
265
Active Damper System
Indicator
Low Fuel Indic
ator Security System Indicator
Instrument Panel Indicators
Instrument sand Cont ro ls
71
LOW FUEL INDICATOR SECURITY SYSTEM INDICATOR
——y
y
()-yy
will also see a "LOW FUEL" message
on the multi-information display (see
page 82).