2007 Abarth Grande Punto stop start

66
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
POWER WINDOWS/
WINDOW WINDERS
On the driver side front door’s arm rest
there are two switches fig. 73which, with
starter’s key in MARposition, control the
following: Automatic continuos operation
The driver side front door’s window is
provided with an up-down automatic de-
vice.
The window screen starts upliftpres-
sing the relevant switch for more than half
a second. The window screen stops its
upstroke when reaching the final up po-
sition or when the switch is pressed again.
IMPORTANT With ignition key at STOP
or removed, the power windows remain
activated for about 2 minutes and are de-
activated immediately the moment a door
is opened.
IMPORTANT On certain versions, press-
ing the remote control button
Ëfor over
2 seconds will open the windows where-
as pressing the remote control button
Áfor over 2 seconds will close them. Ato open/close the left front window;
Bto open/close the right front window.
fig. 73F0M0136m

GENERAL INSTRUCTIONS FOR
USING THE SEAT BELTS
The driver must comply with (and have
the car occupants follow) all the local le-
gal regulations concerning the use of seat
belts. Always fasten the seat belts before
starting.Seat belts are also to be worn by expec-
tant mothers: the risk of injury in the case
of accident is greatly reduced for them and
the unborn child if they are wearing a seat
belt.Of course they must position the lower
part of the belt very low down so that it
passes under the abdomen, see fig. 4.
95
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
The belt should not be twist-
ed. The upper part should
pass over the shoulder and cross the
chest diagonally. The lower part
should adhere to the pelvis and not
the abdomen of the passenger, see
fig. 5. Do not use any objects (pegs,
stoppers, etc.) to keep the belts away
from the body.
WARNING
fig. 4F0M026Abfig. 5F0M027Abfig. 6F0M028Ab

110
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
ENGINE STARTING
The car is fitted with an electronic engine
lock device: if the engine fails to start, see
the paragraph “The Fiat CODE system” in
section “Dashboard and controls”.
The engine may be noisier than usual dur-
ing the first seconds of operation, espe-
cially after it has not been used for a while.
This characteristic feature does not com-
promise functionality or reliability of the
hydraulic tappets: the timing system de-
vised to limit servicing.
We recommend that during
the initial period you do not
drive to full car performance
(e.g.: excessive acceleration,
long journeys at top speed, sharp brak-
ing, etc.).
When the engine is switched
off never leave the key into
the ignition switch to prevent
pointless current absorption
from draining the battery.
Running the engine in con-
fined areas is extremely dan-
gerous. The engine consumes oxygen
and produces carbon monoxide
which is a highly toxic and lethal gas.
WARNING
Remember that the servo-
brake and power steering
are not operational until the engine
has been started, therefore much ef-
fort than usual is required on the
brake pedal and steering wheel.
WARNING
Proceed as follows:
❒ensure that the handbrake is up;
❒put the gear lever into neutral;
❒ press the clutch pedal down to the
floor without touching the accelerator;
❒turn the ignition key to AVVand let
it go the moment the engine starts.
If the engine does not start at the first at-
tempt, return the ignition key to STOP
before repeating starting.
If, when the ignition key is at MAR, warn-
ing light
Yremains lit together with
warning light Uturn the key to STOP
STOP and then back to MAR; if the warn-
ing light remains on, try with the other
keys provided with the car.
IMPORTANT If the instrument panel
warning light Ystays on glowing steadi-
ly, contact immediately Abarth Dealership.
IMPORTANT Never leave the ignition key
to MARwhen the engine is off.

111
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
STOPPING THE ENGINE
Turn the ignition to STOPwhile the en-
gine is idling.
IMPORTANT After a taxing drive, you
should allow the engine to “catch its
breath” before turning it off by letting it
idle to allow the temperature in the en-
gine compartment to fall.
A quick burst on the acceler-
ator before turning off the en-
gine serves absolutely no
practical purpose, it wastes
fuel and is damaging especially to tur-
bocharged engines.HOW TO WARM UP THE
ENGINE AFTER IT HAS JUST
STARTED
Proceed as follows:
❒ Drive off slowly, letting the engine turn
at medium revs. Do not accelerate
abruptly;
❒Do not drive at full performance for the
initial kilometres. Wait until the coolant
temperature gauge starts moving.
Remember that the servo-
brake and power steering are
not operational until the en-
gine has been started, there-
fore much effort than usual is required
on the brake pedal and steering wheel.
Never bump start the engine
by pushing, towing or coast-
ing downhill as this could
cause fuel to flow into the
catalytic exhaust system and damage
it beyond repair.

123
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
AIR BAG FAILURE (red)
Turning the ignition key in the
MARposition the warning
light turns on, it has to turn off
after a few seconds.
If the warning light does not turn off this
indicates a failure in the air bag system.
The display visualizes the specific message.
¬
If the ¬warning light does
not turn on while turning the
ignition key in the MAR position or
if it stays lighted while the car is in
motion there may be a failure in the
restraint systems; in this case the air
bags or the pretensioners may be de-
activated in the event of a collision
or, in a limited number of cases, ac-
tivate incorrectly. Before going on re-
fer to the Abarth Dealership in order
to have the system immediately in-
spected.
WARNING
The ¬warning light failure
(light off ) is signalled by the
flashing for over the normal 4 seconds
of the light “that signals that the
passenger-side air bag is deactivated.
WARNING
ENGINE COOLANT
HIGH TEMPERATURE
(red)
Turning the ignition key in the
MARposition the warning light turns on,
it has to turn off after a few seconds.
The light turns on when the engine is
overheated.
If the light turns on the following steps
must be followed:
❒if in normal driving conditions:
stop the vehicle, turn off the engine
and check that the water level in the
reservoir is not under the MINmark.
In this case wait a few minutes in or-
der to let the engine cool down, then
open slowly and very carefully the tap,
fill up with the coolant, making sure
that the coolant level is between the
MINand MAXmarks on the reser-
voir. Besides visually check the pres-
ence of possible leaks of coolant. If the
light turns on again after starting up
the engine refer to the Abarth Deal-
ership.
ç
❒in case of demanding use of the
vehicle(for example during uphill
hauling of trailers or when the vehi-
cle is fully loaded): slow down and, if
the light stays on, halt the car. Stop for
2 or 3 minutes keeping the engine on
and slightly revved up in order to
favour the active circulation of the
coolant, after that turn off the engine.
Check the level of the coolant in the
reservoir as previously described.
IMPORTANT In case of very exacting
routes it is advisable before turning off the
engine to keep it on and slightly revved up
for a few minutes.
The display visualizes the specific message.

124
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
LOW ENGINE OIL
PRESSURE (red)
Turning the ignition key in the
MAR position the warning light turns on,
it has to turn off as soon as the engine is
started.
The display visualizes the specific message.
v
If the warning light vturns on (together with the
message on the display) while driving,
stop immediately and refer to the
Abarth Dealership.
WARNING
EBD SYSTEM
FAILURE (red)
(amber)
The simultaneous lighting of the
xand>lights when the car is moving indicates
a problem with the EBD system or that
the system itself is not available; in this
case under heavy braking you may have a
premature rear wheel lock-up with the
possibility of skidding. Driving very care-
fully immediately reach the closest Abarth
Dealership in order to have the system in-
spected.
The display visualizes the specific message.
x>
SEAT BELTS NOT
FASTENED (red)
The light on the dashboard turns
on and stays fixed when the vehicle is not
in motion and the driver-side seat belt is
not correctly fastened. The light will flash
together with an acoustic warning signal
(buzzer), when the car is in motion and the
front seat belts are not correctly fastened.
The buzzer of the S.B.R. system (Seat Belt
Reminder) can be deactivated by the
Abarth Dealership.
It is possible to reactivate the system by
means of the set up menu.
<

137
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
❒make sure the compressor switch D-
fig. 5is set to 0 (off), start the engine
and fit plug E-fig. 6into the nearest
current outlet and then turn on the
compressor by setting switch D-fig. 5
to I(on). Inflate the tyre to the pres-
sure specified in paragraph “Inflation
pressure” in section “Technical Speci-
fications”. Check tyre pressure on gauge F-fig.
5 with compressor off to obtain pre-
cise reading;
❒if after 5 minutes it is still impossible
to reach at least 1.5 bar, disengage com-
pressor from valve and current outlet,
then move the car forth for approx. ten
metres in order to distribute the seal-
ing fluid inside the tyre evenly, then re-
peat the inflation operation;
❒If after this operation it is still impossi-
ble after 5 minutes to reach at least 1.8
bar, do not start driving since the tyre
is excessively damaged and the quick
tyre repair kit cannot guarantee suit-
able sealing, contact Abarth Dealership;
❒if reaching the tyre pressure specified
in paragraph “Inflation pressure” in sec-
tion “Technical Specifications”, start
driving immediately;
Apply the sticker in a visible
position for the driver to in-
dicate that the tyre has been treat-
ed with the quick tyre repair kit. Dri-
ve carefully especially when corner-
ing. Do not exceed 80 km/h. Avoid
heavy braking and accelerating.
WARNING
❒after driving for about 10 minutes stop
and check again the tyre pressure; pull
up the handbrake;
If the pressure falls below 1.8
bars, do not drive any further:
the quick tyre repair kit Fix & Go au-
tomatic cannot guarantee proper hold
because the tyre is too much damaged.
Contact Abarth Dealership.
WARNING
fig. 5F0M0202m
fig. 6F0M0203m
fig. 7F0M039Ab

173
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
WHEELS AND TYRES
Check the pressure of each tyre, includ-
ing the spare, every two weeks and before
long journeys. The pressure should be
checked with the tyre rested and cold.
For the correct tyre inflation pressure, see
“Wheels” in “Technical specifications”
section.
Incorrect pressure causes abnormal tyre
wearfig. 6:
Anormal pressure: tread evenly worn.
Blow pressure: tread particularly worn
at the edges.
Chigh pressure: tread particularly worn
in the centre.
Tyres must be replaced when the tread
wears down to 1.6 mm. In any case, com-
ply with the laws in the country where the
car is being driven.
fig. 6F0M0160m
IMPORTANT NOTES
❒As far as possible, avoid sharp braking
and screech starts etc. Be careful not
to hit the kerb, potholes or other ob-
stacles hard. Driving for long stretch-
es over bumpy roads can damage the
tyres;
❒periodically check that the tyres have
no cuts in the side wall, abnormal
swelling or irregular tyre wear. If any of
these occur, have the car seen to at a
Abarth Dealership;
❒avoid overloading the car when travel-
ling: this may cause serious damage to
the wheels and tyres;
❒if a tyre is punctured, stop immediate-
ly and charge it to avoid damage to the
tyre, the rim, suspensions and steering
system;
❒tyres age even if they are not used
much. Cracks in the tread rubber are
a sign of ageing. In any case, if the tyres
have been on the car for over 6 years,
they should be checked by specialised
personnel, to see if they can still be
used. Also remember to check the
spare wheel;
❒ in the case of replacement, always fit
new tyres, avoiding those of dubious
origin;
❒ if a tyre is changed, also change the in-
flation valve;
❒to allow even wear between the front
and rear tyres, it is advisable to change
them over every 10-15 thousand kilo-
metres, keeping them on the same side
of the car so as not to reverse the di-
rection of rotation.
Remember that road holding
depends also on the correct
tyre inflating pressure.
WARNING