Page 55 of 212
53
COMFORT
FRONT SEATS
1 . F o r w a r d s - b a c k w a r d s a d j u s t m e n t
Lift the control and slide the seat for-
wards or backwards.
2 . D r i v e r ' s o r p a s s e n g e r ' s s e a t h e i g h t a d j u s t m e n t
Pull the handle upwards or push it
downwards as many times as neces-
sary to obtain the required position.
3 . S e a t b a c k a n g l e a d j u s t m e n t
Push the handle towards the rear.
4 . A c c e s s t o r e a r s e a t s ( 3 d o o r )
Pull the handle to fold the seat back
and move the seat forwards.
On repositioning, the seat returns to
its initial position.
Note: you can also use control 3 .
Then adjust the angle.
No person or object must pre-
vent the seat slide from re-
turning to its initial position; a
return to this position is nec-
essary for the seat to lock in place.
Page 78 of 212
ACCESS
70
Simultaneous locking or
unlocking of the tailgate and the
doors
The tailgate is locked or unlocked
by the remote control or the driver’s
door lock.
To open, pull handle A and lift the
tailgate.
Note: the tailgate locks automatically
when the vehicle is being driven at
6 mph (10 km/h), even if the auto-
matic central locking is deactivated.
It unlocks when one of the doors is
opened or when the central lock-
ing button is pressed (speed below
6 mph (10 km/h)). TAILGATE
Saloon This enables the tailgate to be un-
locked in the event of a central locking
fault.
Fold back the rear seats to gain
access to the lock from inside the
boot.
Insert a small screwdriver into
hole B of the lock to unlock the
tailgate.
Estate
"Tailgate open" warning
If the tailgate is not properly closed:
- with the engine running , you
are warned by a diagram and a
message on the multifunction dis-
play for a few seconds,
- when the vehicle is moving
(speed above 6 mph (10 km/h)),
the service warning light comes
on. It is accompanied by an audi-
ble signal, a diagram and a mes-
sage on the multi-function display
for a few seconds.
Tailgate release
Page 97 of 212
LAYOUT
87
BOOT LAYOUT (ESTATE)
4 . B o o t l o o r a n d p i l l a r s t o w i n g rings
5. Rear seat stowing rings
6. Luggage retaining net
Secure the net hooks in the stowing
r i n g s o n t h e l o o r o r o n t h e f o l d e d
r e a r s e a t ( t w o h o r i z o n t a l p o s i t i o n s ) o r
secure the net hooks in the stowing
rings on the boot pillars and in the
l o o r r i n g s a t t h e r e a r o f t h e b o o t ( o n e
vertical position).
7. 12 volt socket (100 W max)
This is a lighter type socket, installed
on the load space cover left support.
It is supplied from the "Running"
position. 8 . H i g h l o a d r e t a i n i n g n e t i x i n g s
The high load retaining net can be
installed behind the front or rear
seats.
Open the covers of the corresponding
u p p e r i x i n g s .
Fit the ends of the metal bar in these
i x i n g s .
To install the high load retaining net:
- behind the front seats, lift the rear
seat cushion, hook the net straps
o n t h e i x i n g s t h e n f o l d t h e r e a r
seat;
- behind the rear seat, hook the net straps in the stowing rings on the
l o o r .
The rings are located directly below
t h e c o r r e s p o n d i n g u p p e r i x i n g s .
Pull the two straps taut.
9. Grab handles and coat hooks
1. Load space cover
To install it:
- position the front ends of the
cover on its support and press
gently to put it in place,
- unfold the cover fully,
- position the rear ends of the cover on its support and press gently to
put it in place.
To remove it:
- unclip the rear ends,
- fold the cover fully,
- unclip the front ends and remove the cover.
To store it, slide it under the rear
seats (location A ).
2. Floor storage trays (2/3 - 1/3)
3. Storage nets
One of them contains the luggage
retaining net.
