2007.5 Peugeot 307 CC boot

i
54
ACCESS
This provides two types of protection: - exterior protection: it sounds if
a door, the boot or the bonnet is
opened.
- interior protection: it sounds if
the volume inside the passenger
compartment changes (breaking
of a window or a movement inside
the vehicle).

Note: the interior protection alarm
does not function if the vehicle’s roof
is open (cabriolet position). When the alarm is triggered, the siren
sounds and the direction indicator
lights l ash for thirty seconds.
After triggering, the alarm remains
set.

 Switch off the ignition,

 In the next ten seconds, press
button A until the indicator light is
on continuously,

 Get out of the vehicle,

 Set the alarm by locking or
deadlocking using the remote
control (button A indicator light
l ashes once a second).
In order for the alarm to be set in
this mode, these operations must be
carried out each time the ignition is
switched off.
Setting the alarm

 Switch off the ignition and get
out of the vehicle.

 Set the alarm by locking or
deadlocking using the remote
control (button A indicator light
l ashes once per second).

Note: if you wish to lock your vehicle
without setting the alarm, use the
door lock.
Disarming
Unlock the vehicle with the remote
control key (button A indicator light
goes out).

Note: if the alarm has been triggered
while you were away from your vehicle,
the rapid l ashing of the indicator light will
stop when you switch on the ignition.
To set the alarm with exterior
protection only
If, while you are away from the vehicle,
you wish to leave a window partially
open or a pet inside the vehicle, you
should choose exterior protection only.
Incorrect operation
When the ignition is switched on, if
button A lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have
the system checked.
Automatic activation *
The alarm is activated automatically
two minutes after the last closure of a
door or the boot.
In order to avoid accidental triggering
of the alarm when a door or the boot is
opened, it is essential to i rst press the
unlocking button on the remote control.
Failure of the remote control

 Unlock the door with the key and
open it. The alarm is triggered.

 Switch on the ignition. The alarm
is disarmed.
THE ALARM
If button A indicator light l ashes rapid-
ly, the alarm has been triggered while
you were away from your vehicle.
45 seconds following pressing of the
locking button on the remote control,
the alarm is set, regardless of the
status of the doors or boot.
When washing your vehicle, to avoid
triggering the alarm:
- lock the doors using the key,
or
-
set the exterior protection alarm only.
If the alarm has been triggered ten
times in succession, on the elev-
enth time it becomes inactive.
* According to country.

59
ACCESS
Pressing button A permits:
- locking of the vehicle,
- unlocking of the vehicle (and in particular the boot) if you place
the key in the switch.
The red indicator light on the button
comes on when the vehicle is locked
and is switched off when the vehicle
is unlocked.

Note: if the vehicle is locked or
deadlocked from the outside, the red
indicator light l ashes and button A is
inoperative. In this case, use the key
or the remote control to unlock.
Automatic central locking
of the doors
The doors lock automatically when
driving [speed greater than 6 mph
(10 km/h)].
Above 6 mph (10 km/h), a brief press
on button A momentarily unlocks the
doors.
You can activate or disarm this func-
tion.
Activation
Press and hold button A .
Activation of the function is accom-
panied by a message on the multi-
function display.
Disarming
Press and hold button A .
Disarming of the function is accom-
panied by a message on the multi-
function display.
Notes
If one of the doors is open, the au-
tomatic central locking and locking
from the inside do not function.
If the boot is open, the automatic
central locking of the doors is active. Driver’s door
Insert the key in the lock to lock or
unlock the door.
Passenger’s door
- to lock, insert the key in the lock
(located on the edge of the door)
then turn an eighth of a turn to the
left.
- to unlock, use the interior door
opening control (see corresponding
section).
Boot
The boot is locked, contact a PEUGEOT
dealer.
MANUAL LOCKING/
UNLOCKING
(EMERGENCY MODE)
Locking/Unlocking from the
inside

!
58
ACCESS
Vehicle locked/deadlocked

 Press button D on the remote
control to unlock and partially
open the boot.
This action will also unlock the
doors. To protect the boot against theft,
button
E can be disarmed. Turn the
lock F a quarter turn to the right using
the key.
The boot can only be opened using
the remote control.
Opening the boot "Boot open" warning
If the tailgate is not properly closed:
- with the engine running , you
are warned by a diagram and a
message on the multifunction
display for a few seconds,
- when the vehicle is moving
(speed above 6 mph (10 km/h)),
the service warning light comes
on. It is accompanied by an
audible signal, a diagram and a
message on the multifunction
display for a few seconds.
Closing the boot

 Use the interior grab handles to
close the boot.

 Press the centre of the boot with
both hands until it locks.
BOOT Permanent locking
Automatic locking
The boot locks automatically when
driving above 6 mph (10 km/h).
It unlocks either:
- manually by pressing the interior central locking/unlocking button,
- automatically when one of the doors is opened.
For this to take place, the key must
be in the ignition and button E
must not have been disarmed by
means of the lock F. Following automatic locking, if
the key is removed from the ig-
nition before a door is opened or
before the interior central lock-
ing/unlocking button is pressed,
the boot remains locked and
cannot be opened by pressing
button
E .

In all cases, the boot can still
be unlocked by pressing but-
ton D on the remote control.
Vehicle unlocked

 Press button D on the remote
control to partially open the boot,
or press button E on the boot.

Note
: if you have unlocked the vehicle
using the key, pressing the remote
control deactivates the alarm.

59
ACCESS
Pressing button A permits:
- locking of the vehicle,
- unlocking of the vehicle (and in particular the boot) if you place
the key in the switch.
The red indicator light on the button
comes on when the vehicle is locked
and is switched off when the vehicle
is unlocked.

Note: if the vehicle is locked or
deadlocked from the outside, the red
indicator light l ashes and button A is
inoperative. In this case, use the key
or the remote control to unlock.
Automatic central locking
of the doors
The doors lock automatically when
driving [speed greater than 6 mph
(10 km/h)].
Above 6 mph (10 km/h), a brief press
on button A momentarily unlocks the
doors.
You can activate or disarm this func-
tion.
Activation
Press and hold button A .
Activation of the function is accom-
panied by a message on the multi-
function display.
Disarming
Press and hold button A .
Disarming of the function is accom-
panied by a message on the multi-
function display.
Notes
If one of the doors is open, the au-
tomatic central locking and locking
from the inside do not function.
If the boot is open, the automatic
central locking of the doors is active. Driver’s door
Insert the key in the lock to lock or
unlock the door.
Passenger’s door
- to lock, insert the key in the lock
(located on the edge of the door)
then turn an eighth of a turn to the
left.
- to unlock, use the interior door
opening control (see corresponding
section).
Boot
The boot is locked, contact a PEUGEOT
dealer.
MANUAL LOCKING/
UNLOCKING
(EMERGENCY MODE)
Locking/Unlocking from the
inside

69
LAYOUT
BOOT LAYOUT
* According to country.
1. Stowing rings
Use the stowing rings located on the
boot l oor and on the boot rear inner
panel to secure your luggage.
2. Luggage retaining net
Hooked onto the stowing rings, this
enables your luggage to be secured.
3. 12 volt socket (100 W max)
This is a lighter type socket, installed
on the boot side trim on the left-hand
side.
It is supplied from the "Running"
position.
4. Signalling triangle *
Two elastic straps permit the securing
of a signalling triangle.

10
97
PRACTICAL INFORMATION
Access to the spare wheel and
the jack in the boot

 Place the vehicle in the coupé
position.


Detach the luggage retaining net.


Lift the boot mat using the handle. Tools
The following tools are located in
a holder in the centre of the spare
wheel:

1. Wheelbrace.

2. Jack with handle.

3. Centralising tool.

4. Socket for anti-theft bolt.

5. Removable towing eye.

6. Alloy wheel bolt trim remover.
A diagram on the holder indicates the
location of the tools.
Parking the vehicle

 As far possible, park the vehicle
on level, stable and non-slippery
ground.

 Apply the handbrake, àswitch off
the ignition and engage i rst or
reverse gear (position P for the
automatic gearbox).
CHANGING A WHEEL

10
98
PRACTICAL INFORMATION
Extracting the wheel
Removing the wheel

 If necessary, place a chock under
the wheel diagonally opposite to
the one to be changed.

 Remove the trim, using the
wheelbrace 1 , pulling at the valve
passage hole.

 Loosen the wheel bolts (for vehi-
cles i tted with alloy wheels, re-
move the chrome trims i rst. See
paragraph on "Special features of
alloy wheels").

 Place the jack 2 in contact with
one of the four locating points A
on the sub-frame, the one which
is closest to the wheel to be
changed.

 Extend the jack 2 until its base
is in contact with the ground. En-
sure that the centre line of the
base of the jack is directly below
the locating point A used. Fitting a wheel

 Position the wheel using the
centralising tool 3 to assist you.

 Tighten the bolts by hand and
remove the centralising tool.

 Partly tighten the bolts using the
wheelbrace 1 .

 Fold the jack 2 and remove it.

 Fully tighten the bolts using the
wheelbrace 1 .

 Replace the wheel trim, starting
by placing the wheel trim notch
opposite the valve, and press it
on using the palm of the hand.

 Raise the vehicle.

 Unscrew the bolts and remove
the wheel.

 Unscrew the yellow central bolt a
quarter turn.

 Raise the spare wheel towards
you from the rear.

 Remove the wheel from the
boot.

10
!
103
PRACTICAL INFORMATION

 Unclip the corresponding boot lid
trim at two points.

 Move the trim aside gently to
access the bulb holder 6 .

 Unscrew the bulb holder a
quarter of a turn.

 Remove the bulb holder.

 Change the faulty bulb.

Note: when rei tting, take care to
position the bulb holder correctly.

1. Brake lights (diodes).

2. Side lights (diodes).

3. Direction indicators (P 21 W).

4. Reversing light (P 21 W), left
side.
Fog lamp (P 21 W), right side.
 Remove the 3 bolts of the corre-
sponding boot side trim to access
the light (use the 20 Torx
TM adaptor
of tool C located in the handbook
pocket).


 Remove the light i xing nut inside
the boot.

 Remove the light.

 Unscrew the bulb holder 5 a
quarter of a turn.

 Remove the bulb holder.

 Change the faulty bulb.

Note: when rei tting, take care to po-
sition the bulb holder and the light
correctly.
Rear lights Direction indicators Reversing light/fog lamp
All work on the diode lights must
be carried out by a PEUGEOT
dealer.