2007.5 Peugeot 207 CC Dag fog light

!
INSTRUMENTS and CONTROLS
19
The indicator/warning light comes
on continuously or l ashes.
Some indicator/warning lights may
light in two different ways. Only by
relating the type of lighting to the
vehicle operating status can it be
ascertained whether the situation
is normal or whether a fault has oc-
curred.
Indicator and warning lights
Visual indicators which inform the driv-
er when a system comes into opera-
tion (operation or deactivation indicator
lights) or of the occurrence of a fault
(warning light).
Associated warnings
The lighting of certain indicator/warning
lights may be accompanied by an audi-
ble signal and a message on the multi-
function display. Operation indicator lights
The lighting of one of the following indica-
tor lights coni rms that the corresponding
system has come into operation.
Left-hand direction indicator.
Handbrake applied.
Right-hand direction
indicator.
Main beam headlamps.
Dipped headlamps.
Diesel engine pre-heating.
Wait until this switches off be-
fore operating the starter.
Front fog lamps.
Rear fog lamps.
When the ignition is switched on
The warning lights come on for a few
seconds when the vehicle ignition is
switched on.
When the engine is started, these warn-
ing lights should switch off.
If they remain on, before moving off,
consult the text relating to the warning
light concerned.

!
i
VISIBILITY
76
Model with front and rear fog lamps
front and rear fog lamps

C. fog lamps selection ring.
These operate with the dipped and main
beam headlamps.

 To switch on the fog lamps, turn
push ring C forwards.

 To switch off the rear fog lamps, turn
push ring C rearwards twice in suc-
cession.
When the lights are switched off auto-
matically (on AUTO model) or when
the dipped headlamps are switched off
manually, the fog lamps and the side
lights will remain on.

 Turn the ring rearwards to switch
off the fog lamps, the side lights will
then switch off.
Do not forget to switch off the front
fog lamps and the rear fog lamps
when they are no longer neces-
sary. In normal light levels, the
power of their beams may dazzle
other drivers. Lights on reminder
The triggering of an audible sig-
nal when a door is opened warns
the driver that he has forgotten to
switch off his vehicle's lights, with
the ignition off.
In this case, switching off the lights
will stop the audible signal.
When the ignition is switched off, if
the dipped headlamps remain on,
they will be switched off automati-
cally after thirty minutes to prevent
discharging of the battery. This indicator light comes on
on the instrument panel.
* According to country.
Daytime lights *
On vehicles i tted with daytime lights,
the dipped headlamps come on when
the vehicle is started.
The instruments and controls (instru-
ment panel, multifunction display, air
conditioning control panel, ...) are not
lit, unless the automatic switching on of
the lights mode is activated or the lights
are switched on manually.

!
i
i
PRACTICAL INFORMATION
120
CHANGING A BULB
Procedure for the replacement of a
faulty bulb with a new bulb without the
use of tools.
1. Direction indicators
(PY 21 W amber).

2. Side lights (W 5 W).

3. Dipped headlamps (H7-55 W).

4. Main beam headlamps (H1-55 W).

5. Directional headlamps (H7-55 W).

6. Fog lamps (H11-55 W). Changing the direction indicators


Handle the bulbs with a dry cloth.
The headlamps are i tted with poly-
carbonate glass with a protective
coating:

 do not clean them using a dry
or abrasive cloth, or using a
detergent or solvent product,

 use a sponge and soapy water. In certain climatic conditions (low
temperature, humidity),
conden-
sation on the internal surface of
the headlamp glass is normal ; it
disappears a few minutes after the
lights are switched on .
Model with dipped headlamps with
elliptical module and directional
headlamps
Amber coloured bulbs, such as the
direction indicators, must be replaced
with bulbs of identical specii cation
and colour
.

 Turn the bulb holder one quarter of
a turn and remove it.

 Pull the bulb then change it.
To rei t, carry out these operations in
reverse order.
Front lights
Blown bulb
A message appears on the multifunc-
tion display to indicate the bulb to be
changed.
Refer to the appropriate procedure to
change the corresponding bulb.
Model with conventional lights

PRACTICAL INFORMATION
121
Changing the side lights

 Disconnect the main headlamp con-
nector.

 Remove the plastic protective cover
by pulling on the tab.

 Turn the bulb holder one quarter of
a turn and remove it.

 Pull the bulb and change it.
To rei t, carry out these operations in re-
verse order.
Changing the dipped headlamps,
main beam headlamps or directional
headlamps

 Disconnect the main headlamp
connector.

 Remove the corresponding plastic
protective cover by pulling on the
tab. Changing the integrated direction
indicator side repeaters

 Insert a screwdriver towards the
centre of the repeater between the
repeater and the base of the mirror.

 Tilt the screwdriver to extract the re-
peater and remove the repeater.

 Disconnect the repeater connector.
To rei t, carry out these operations in re-
verse order.
To obtain a replacement repeater, con-
tact a PEUGEOT dealer.

 Disconnect the connector of the
corresponding light.

 Move aside the spring to release the
bulb and remove the bulb.
To rei t, carry out these operations in
reverse order. Changing the fog lamps
For replacement of these bulbs, contact
a PEUGEOT dealer.

i
PRACTICAL INFORMATION
122
Rear lights

1. Brake lights (P 21 W).

2. Side lights (R 5 W).

3. Fog lamps (P 21 W).

4. Direction indicators
(PY 21 W amber).

5. Reversing lights (P 21 W). Changing bulbs
These i ve bulbs are changed from
outside the boot:

 i rst open the l ap to gain access to
the i xing bolt,

 remove the light i xing bolt,

 take out the light from the outside,

 disconnect the light connector,

 remove the light seal,

 press the four tabs and remove the
bulb holder,

 turn the bulb one quarter of a turn
and change it.
To rei t, carry out these operations in
reverse order.

Amber coloured bulbs, such as the
direction indicators, must be replaced
with bulbs of identical specii cation
and colour
.