2007.5 Citroen C5 DAG warning light
[x] Cancel search: warning lightPage 30 of 231
32
II
STOP warning lamp
When the warn-ing lamp comes on, you must stop the vehicle and switch off the engine. Contact a CITROËN dealer.switch off the engineswitch off
Parking brake
The permanent lighting of t h i s w a r n i n g l a m p c o n fi r m s that the parking brake is applied.
I f t h i s w a r n i n g l a m p fl a s h e s , i t i n d i -cates a fault with its application or release. Consult a CITROËN cates a fault with its application application
dealer as soon as possible.
See “Brakes”.
With the engine running, and when displayed at the same time as the STOP warning lamp, it indi- c a t e s t h a t t h e b r a k e fl u i d l e v e l i s too low.
If this warning lamp comes on, stop immediately and contact a CITROËN dealer.stop immediately and immediately
See “Brakes”.
Battery charge
This warning lamp comes on temporarily when the engine is switched on. If it remains on permanently, contact a CITROËN dealer.remains on permanens on
In the event of a battery failure, the application of the electronic parking brake when the engine is switched off is not guaranteed. You must therefore apply the parking brake before switching off the engine.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
SERVICE
This warning lamp remains on perma-nently, as long as the fault displayed on the instru-ment panel screen is present (for serious faults).
Consult a CITROËN dealer as soon as possible.
This warning lamp remains on only for a short time for faults that are minor.
Contact a CITROËN dealer.
ESP/ASR
Operating
If either of the ESP or ASR systems is active, the warning l a m p fl a s h e s .
For a malfunction
With the engine running, the light-ing of this warning lamp along with a message on the instrument panel screen, the lighting of the SERV-ICE warning lamp and a sound signal, indicates a system fault.
Contact a CITROËN dealer.
Deactivation
The lighting of this warning lamp and the light on the ESP deactiva- t i o n b u t t o n c o n fi r m s t h a t t h e s y s -tem is deactivated.
See “Dynamic stability control” (ESP).
Coolant temperature
It comes on for a few sec-onds each time you switch on the ignition.
If this warning lamp comes on, engine running, it tells you that the coolant temperature is rising abnormally.
This warning lamp is linked with the STOP warning lamp.
It is essential to stop the vehi-cle.
Check the coolant level.
If the level is too low, contact a CITROËN dealer.If the level is too
Page 31 of 231
33
II
Front passenger's airbag deactivation warning lamp
See “Airbags”.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
Front passenger's air-bag activation warn-ing lamp
See “Airbags”.
Seat belt not fastened
This warning lamp is located on the roof console, in front of the front interior lamp. It informs you of the driver and passenger seat belts which are not fastened.
The lit up locations represent the seat positions which are not fas-tened.
Driver's seat belt not fastened:The warning lamp lights up from 0 to 20 km/h (12 mph).Over 20 km/h (12 mph):
t h e w a r n i n g l a m p fl a s h e s ,a beep is repeated for about 2 minutes with 3 progressive loudness levels.
Page 32 of 231
34
II
The simultaneous lighting of the SERVICE warning lamp and the display of the message “ P a r t i c l e fi l t e r ( F A P ) a d d i -tive level too low” on the instrument panel screen indicates that the additive needs to be topped up.
Contact a CITROËN dealer as soon as possible.
I N S T R U M E N T P A N E L
P A R T I C L E F I L T E R
I n a d d i t i o n t o t h e c a t a l y t i c c o n v e r t e r , t h i s fi l t e r c o n t r i b u t e s a c t i v e l y t o t h e p r e s e r v i n g o f a i r q u a l i t y , b y c o l l e c t i n g t h e polluting particles that have not been burnt off. Black exhaust fumes are thus eliminated.
C l o g g i n g o f t h e p a r t i c l e fi l t e r
C l o g g i n g i s c a u s e d b y t h e p a r t i c l e fi l t e r s t a r t i n g t o b e s a t u r a t e d ( o w i n g t o e x c e p t i o n a l l y l o n g p e r i o d s s p e n t d r i v i n g i n u r b a n c o n d i t i o n s : l o w s p e e d s , t r a f fi c j a m s , e t c . ) .
I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d of 60 km/h or more for at least 5 minutes. If the problem persists, contact a CITROËN dealer. I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d
Note: If the vehicle has been running for long periods at very low speeds or at idle, vapour emissions may be seen coming from the exhaust under acceleration. These have no consequ ences for the running of the vehicle or for the environment.
The simultaneous lighting of the SERVICE warning lamp and the display of the message “Risk of saturation of par- t i c l e fi l t e r ( F A P ) ” on the instrument panel screen indicates an increased risk of saturation.
Contact a CITROËN dealer as soon as possible.
DIESEL additive level
Page 55 of 231
59
II
1
2
R E A R V I E W M I R R O R S
Functioning of the interior and exterior rear view mir-rors
Press on button 1.Warning lamp 2 on: automatic mode.
Warning lamp 2 off: automatic mode stopped. The mirror r e m a i n s i n i t s l i g h t e s t d e fi n i t i o n .Note: In order to ensure optimal visibility when manoeuvring, the interior and exterior rear view mir-rors lighten when reverse gear is engaged.
Page 62 of 231
66
II
3
5
4
2
1
C R U I S E C O N T R O L
To cancel the functionPress on button 5.
Select the cruise control func-tion.Or stop the engine.
The speed that was chosen is no longer memorised.
If there is a malfunction, a mes-sage is displayed accompanied by a sound signal and lighting of the SERVICE warning lamp.
Contact a CITROËN dealer.
Page 64 of 231
68
II
3
5
4
2
1
A
S P E E D L I M I T E R
Suspension or resumption of maximum speed
Press on button 3.
Temporary override of the maximum speed
The accelerator pedal has an end-of-travel switch. In order to exceed the memorised maximum speed at any time, you can press the pedal all the way down. While the speed is being exceeded, the speed dis-played in zone A w i l l fl a s h . Y o u have only to release the accelera-tor pedal to return below the maxi-mum speed, to restore the func-tion.
Remark: t h e s p e e d w i l l a l s o fl a s h if the speed limiter is not able to prevent the vehicle from exceeding the programmed speed (e.g. on a steep descent or under excessive acceleration).
To reactivate the speed limiter, release the accelerator to slow to a speed lower than the programmed speed.
To cancel the functionPress on button 5.Select the speed limiter func-tion.
Or stop the engine.
The speed that was chosen is no longer memorised.
If there is a malfunction, a mes-sage is displayed accompanied by a sound signal and lighting of the SERVICE warning lamp.
Contact a CITROËN dealer.
Page 65 of 231
69
II
A
D e fl a t i o n d e t e c t i o n
T h i s f u n c t i o n w a r n s y o u o f t y r e s t h a t a r e d e fl a t e d o r p u n c t u r e d .
Automatic detection
Sensors monitor the tyre pressures while driving. In the event of a n anom-aly, a message will appear on the instrument panel screen.
Driver request detection
You can check the tyre pressures at any given moment. To do so, press on button A (CHECK) ; the information will be displayed on the instrument panel screen.
Display of tyres in good condition
Automatic detection:
A m e s s a g e i n d i c a t e s t o y o u w h i c h t y r e i s d e fl a t e d .
Driver request detection:
T h e v e h i c l e o u t l i n e i n d i c a t e s t h e d e fl a t e d t y r e ( s ) .
T Y R E D E F L A T I O N D E T E C T I O N
T y r e d e fl a t i o n a l e r t
T h e s y s t e m i n d i c a t e s t o y o u t h a t t h e t y r e s a r e c o r r e c t l y i n fl a t e d .
This information is only available on the request of the driver.
Press on Check
Press on CheckAutomatic detection
The message is accompanied by the SERVICE warning lamp lighting up and a beep.
Check the tyre pressures as soon as possible.
Page 66 of 231
70
II
T Y R E D E F L A T I O N D E T E C T I O N
Wheel not detected
T h e d e fl a t i o n d e t e c t i o n s y s t e m i s a d r i v i n g a i d , b u t w h i c h d o e s n o t a b s o l v e t h e d r i v e r f r o m t h e n e e d t o b e v i g i l a n t a n d responsible.
T h i s s y s t e m d o e s n o t d i s p e n s e w i t h t h e r e q u i r e m e n t t o c h e c k t h e t y r e s o n a r e g u l a r b a s i s ( s e e “ V e h i c l e i d e n t i fi c a -tion”), to make sure that the vehicle is behaving correctly and to avoid premature tyre wear arising from driving too fast etc.
Do not forget to check the pressure in the spare wheel.
Any repair or replacement of a tyre on a wheel that is equipped with a sensor must be carried out by a CITROËN dealer.Any repair or replacement repair or
The system may suffer from temporary interference caused by radio transmissions on neighbouring frequencies.
Automatic detection:
A message indicates to you which tyre is punctured.
Driver request detection:
The vehicle outline indicates the punctured tyre(s).
Puncture
Automatic detection:
A message indicates to you which wheel is not detected.
Driver request detection:
The vehicle outline indicates the wheel(s) which is/are not detected.
Press on CheckAutomatic detection
Press on CheckAutomatic detection
The message is accompanied by the STOP warning lamp lighting up and a beep.
Note: I f y o u h a v e fi t t e d a w h e e l / w h e e l s n o t e q u i p p e d w i t h t y r e d e fl a t i o n d e t e c t i o n ( e . g . s n o w t y r e s ) , c o n t a c t a C I T R O Ë N dealer.
The message is accompanied by the SERVICE warning lamp lighting up and a beep.
Contact a CITROËN dealer to have the faulty sensor(s) replaced.