2007.5 Citroen C5 DAG light
[x] Cancel search: lightPage 20 of 231
23
II
R E M O T E C O N T R O L
Folding and ejecting the key
Button D is for folding and ejecting the key from its housing in the remote control.
If you do not press on button D, you could damage the key mechanism.
Changing the remote control battery
Unclip the cover to gain access to the battery.
Battery: CR 0523 de 3 V.
Re-initialisation of the remote control
After a change of battery, it is necessary to re-initialise the remote control. To do that, switch on the ignition and immediately press bu tton C of your remote control until you achieve the desired result. This may take some ten seconds.Note: Make a careful note of the numbers for the keys and for the remot e control on the ASSISTANCE card. Keep this in a safe place.
Do not throw away used batteries. Return them to a CITROËN dealer or dealertake them to an authorised recycling facility (camera shops, etc).
Except when reinitialising, the remote control cannot function while the key is in the ignition, even when switched off.
Warning: by inadvertently actioning the remote control, when for example it is in your pocket, you can unlock the vehicle without your realising it.
However, if none of the doors is opened within thirty seconds following an unlocking, the doors will automatically relock.
Warning: there is a risk of damage if the replacement batte ry is not the correct one.
Only use batteries that are identical or equivalent to those approved by CITROËN.
Guide-me-home lighting
A press on button B activates the guide-me-home lighting (lighting of the sidelamps, dipped beams, registration plate lights for around 1 minute).
A second press prior to the end of this timing cancels the guide-me-home lighting.
Locating of the vehicle
To locate the vehicle in a carpark, press button C. Locating of the v e h i c l e i s c o n fi r m e d b y : T h e fl a s h i n g o f t h e d i r e c t i o n indicators for a few seconds.The interior lighting coming on.
The vehicle remains locked.
Page 24 of 231
27
II
A N T I - I N T R U S I O N A L A R M
Operating the alarm
First make sure all the doors are closed.
The alarm is armed by pressing button C on the remote control.
With the alarm armed, the protections are active after 5 seconds (perimeter) and 45 seconds (volumetric).
When the alarm is armed (on standby), any intrusion will trigger the siren for 30 seconds, accompanied by the direction indicators lighting up.
The alarm then goes back on standby. The triggering remains memorised. The warning lamp on button A fl a s h e s q u i c k l y w h e n t h e a l a r m i s d e a c t i v a t e d b y p r e s s -ing the unlocking button B . T h i s fl a s h i n g s t o p s w h e n you switch on the ignition.
The siren is also triggered if there is a cutting of the electrical supply. To stop it, restore the electrical supply then press on the unlocking button B.Note:If you want to lock your vehicle without arming the alarm, just lock with the key only.
If you lock your vehicle and a door, or the boot, is still open, the central locking does not operate but the alarm will arm itself after approx. 45 seconds.Note: The siren is automatically deactivated (for exam-ple for disconnecting the battery) as soon as the vehicle is unlocked using the remote control.
Page 27 of 231
30
II
G
C
F
ADBE
I N S T R U M E N T P A N E L
A Fuel gaugeB Indicator:Coolant temperature
Cruise control/Speed limiter informationC Speed indicatorD Rev counterE Indicator:Engine oil temperature
Gear selector position and gear engaged (Auto-matic gearbox)
F Controls:Lighting rheostat
Resetting to zero of trip mileage computer and maintenance indicator
Page 28 of 231
43
II
A
2121
I N S T R U M E N T P A N E L
Engine oil temperature gauge
Under normal operating condi-tions, the bars should be within section 1.
In severe operating conditions, the bars may extend into section 2.
In this event, slow down, and if nec-essary, stop the engine and check the levels (see chapter - Mainte-nance - “Levels”).
Fuel gauge
On horizontal ground, the lighting of the fuel low warning lamp warns you that you are using the reserve tank.
A message alert is displayed on the instrument panel.
Coolant temperature indica-tor
Under normal operating condi-tions, the bars should be within section 1.
In severe operating conditions, the bars may extend into section 2, the engine coolant temperature warn-ing lamp A and the STOP warning lamp will light up, stop immedi-ately.Switch off the ignition. The cooling fan may continue to operate for a certain time. Allow the engine to cool down while tak-ing the precautions indicated in chapter - Maintenace - “Levels”.
Contact a CITROËN dealer.
If the SERVICE warning lamp lights up, check the levels (see chapter - Maintenance - “Levels”).
Page 30 of 231
32
II
STOP warning lamp
When the warn-ing lamp comes on, you must stop the vehicle and switch off the engine. Contact a CITROËN dealer.switch off the engineswitch off
Parking brake
The permanent lighting of t h i s w a r n i n g l a m p c o n fi r m s that the parking brake is applied.
I f t h i s w a r n i n g l a m p fl a s h e s , i t i n d i -cates a fault with its application or release. Consult a CITROËN cates a fault with its application application
dealer as soon as possible.
See “Brakes”.
With the engine running, and when displayed at the same time as the STOP warning lamp, it indi- c a t e s t h a t t h e b r a k e fl u i d l e v e l i s too low.
If this warning lamp comes on, stop immediately and contact a CITROËN dealer.stop immediately and immediately
See “Brakes”.
Battery charge
This warning lamp comes on temporarily when the engine is switched on. If it remains on permanently, contact a CITROËN dealer.remains on permanens on
In the event of a battery failure, the application of the electronic parking brake when the engine is switched off is not guaranteed. You must therefore apply the parking brake before switching off the engine.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
SERVICE
This warning lamp remains on perma-nently, as long as the fault displayed on the instru-ment panel screen is present (for serious faults).
Consult a CITROËN dealer as soon as possible.
This warning lamp remains on only for a short time for faults that are minor.
Contact a CITROËN dealer.
ESP/ASR
Operating
If either of the ESP or ASR systems is active, the warning l a m p fl a s h e s .
For a malfunction
With the engine running, the light-ing of this warning lamp along with a message on the instrument panel screen, the lighting of the SERV-ICE warning lamp and a sound signal, indicates a system fault.
Contact a CITROËN dealer.
Deactivation
The lighting of this warning lamp and the light on the ESP deactiva- t i o n b u t t o n c o n fi r m s t h a t t h e s y s -tem is deactivated.
See “Dynamic stability control” (ESP).
Coolant temperature
It comes on for a few sec-onds each time you switch on the ignition.
If this warning lamp comes on, engine running, it tells you that the coolant temperature is rising abnormally.
This warning lamp is linked with the STOP warning lamp.
It is essential to stop the vehi-cle.
Check the coolant level.
If the level is too low, contact a CITROËN dealer.If the level is too
Page 31 of 231
33
II
Front passenger's airbag deactivation warning lamp
See “Airbags”.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
Front passenger's air-bag activation warn-ing lamp
See “Airbags”.
Seat belt not fastened
This warning lamp is located on the roof console, in front of the front interior lamp. It informs you of the driver and passenger seat belts which are not fastened.
The lit up locations represent the seat positions which are not fas-tened.
Driver's seat belt not fastened:The warning lamp lights up from 0 to 20 km/h (12 mph).Over 20 km/h (12 mph):
t h e w a r n i n g l a m p fl a s h e s ,a beep is repeated for about 2 minutes with 3 progressive loudness levels.
Page 32 of 231
34
II
The simultaneous lighting of the SERVICE warning lamp and the display of the message “ P a r t i c l e fi l t e r ( F A P ) a d d i -tive level too low” on the instrument panel screen indicates that the additive needs to be topped up.
Contact a CITROËN dealer as soon as possible.
I N S T R U M E N T P A N E L
P A R T I C L E F I L T E R
I n a d d i t i o n t o t h e c a t a l y t i c c o n v e r t e r , t h i s fi l t e r c o n t r i b u t e s a c t i v e l y t o t h e p r e s e r v i n g o f a i r q u a l i t y , b y c o l l e c t i n g t h e polluting particles that have not been burnt off. Black exhaust fumes are thus eliminated.
C l o g g i n g o f t h e p a r t i c l e fi l t e r
C l o g g i n g i s c a u s e d b y t h e p a r t i c l e fi l t e r s t a r t i n g t o b e s a t u r a t e d ( o w i n g t o e x c e p t i o n a l l y l o n g p e r i o d s s p e n t d r i v i n g i n u r b a n c o n d i t i o n s : l o w s p e e d s , t r a f fi c j a m s , e t c . ) .
I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d of 60 km/h or more for at least 5 minutes. If the problem persists, contact a CITROËN dealer. I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d
Note: If the vehicle has been running for long periods at very low speeds or at idle, vapour emissions may be seen coming from the exhaust under acceleration. These have no consequ ences for the running of the vehicle or for the environment.
The simultaneous lighting of the SERVICE warning lamp and the display of the message “Risk of saturation of par- t i c l e fi l t e r ( F A P ) ” on the instrument panel screen indicates an increased risk of saturation.
Contact a CITROËN dealer as soon as possible.
DIESEL additive level
Page 39 of 231
41
IIB
A
I N S T R U M E N T P A N E L
M A I N M E N U
“Vehicle parameters” menu
This allows you to access the parameters relating to:The vehicle lighting.
The comfort levels in the vehicle.
See “Instrument panel - Vehicle parameters”.