2007.5 Citroen C4 PICASSO lock

124III
Manual control
The rear doors are locked by operating the lever.
When the manual safety is in use, the aperture is at
an angle.
Electric operation
The electrical safety is activated by pressing the con-
trol located to the rear of the electric windows panel.
This prohibits movement of the rear electric windows
and opening of the rear passenger doors.
it is still possible to open the doors from the outside,
provided the vehicle is not locked.
Note : with the ignition on, if the child safety is
activated for the two rear doors, the warning
lamp comes on then goes out again approx.
10 seconds after the engine is started.
When the ignition is switched on, the warning
lamp comes on then goes out again approx.
10 seconds after the engine is started.
Note :
Activation of the function is confirmed by the
temporary lighting of the warning lamp accompanied
by a message.
C H i L d S A F E T Y

A
B
C
III
129
A i R C R A F T- S T Y L E R E A R TA B L E S
Rear tables
The backrests of the front seats are fitted with aircraft-
style tables. These incorporate a cup-holder
A and a
retaining strap B, for the placing of objects.
Operation table
- Pull the table downwards to open.
- To restow the table, raise it until the latch locks.
Note : For safety reasons, these collapse downwards
if excessive pressure is exerted. Individual reading lamps
Reading lamps
C may be incorporated in the front seat
backrests, behind the tables. These light the surface
of the tables without disturbing the other passengers.
They are accessible only while the table is down.
- Press on the on/off button to turn the lamp on or
off.
Rear table stowed
Rear table opened

1
1
2
130III
2. Interior lamp with three positions
in this position, the interior
lamp comes on when you
open a door or the boot.
in this position, it is deac
-
tivated and thus perma-
nently off.
in this position, lighting is
permanent.
They come on immediate-
ly you unlock the vehicle
or open a door.
They go out 30 seconds after the
doors have been closed, or when
the ignition is switched on.
Automatic illumination of the
interior lamps
« PANORAMIC GLASS ROOF »
LAMPS
The panoramic glass roof lamps
have two operating modes :
- automatic lighting when you
open a door or when the front in-
terior lamp is in the permanent
position,
- permanent lighting.
i N T E R i o R L i G H T i N G
Note :
- the opening of a door switches the interior lamps on.
- the opening of the tailgate switches the third-row interi or lamp on, also the boot lamps.
INTERIOR LAMPS
1. Reading lamps
A press on one of the buttons
switches the corresponding spot-
lamp on or off.
They do not come on if the ignition
is switched off or if the vehicle is in
economy mode. When you leave the vehicle :
-
they come on when you remove the
ignition key (for about 30 seconds),
or when a door is opened
.
-
they go out after 30 seconds with
the doors closed, or immediately the
vehicle is locked, or after 10 minutes
if a door is open
.

A
BCD
III
137
Replacing a cartridge
The recharge for the air freshener consists of a car-
tridge B and its sealed container C.
1. Remove the protective film D.
2. Place the head of the cartridge
B on the button A
of the air freshener.
3. Rotate it a quarter turn to lock it on the button and
remove the container.
4. insert the air freshener into its housing.
You can change cartridges at any time, keeping the
used cartridges in their original containers.
For safety, use only cartridges that are provided for this purpose.
Do not attempt to take cartridges apart.
Never recharge the cartridges with fragrances not suppli ed by CITROËN.
Keep them out of reach of children and animals.
Avoid all contact with the skin and with the eyes.
In the event of swallowing, consult a doctor and show hi m the product packaging or label.
Do not install or remove a cartridge while you are dri ving.
Air freshener button
The air freshener
button A is independent of the car-
tridge. Cartridges are supplied without the air fresh-
ener button A.
The button of the air freshener A can only be fixed into
the central dashboard with a cartridge attached.
Therefore always keep the air freshener button A and
one cartridge.
Note : Recharges are available, according to country, eit her
on the CiTRoËN internet site or from a CiTRoËN deal er.
Stowage points are provided in the glovebox for storing
of cartridges and containers.
S C E N T E d A i R F R E S H E N E R - C H A N G i N G T H E C A R T R i d G E

CD
AB
142 III
B o o T
- L U G G A G E C o V E R B L i N d - G R A N d C 4 P i C A S S o
Luggage-cover blind
Position 1 : (5-seat configuration, behind the secon d row)
Behind the second-row seats, with the third-row seats
folded away.
To install the roller :
1. Compress the left-hand end of the roller and place
it in notch A.
2. Position the right-hand end of the blind roller in
notch B.
3. Unroll the blind until it reaches the boot pillars.
4. insert the guides of the blind into the rails on the
pillars.
To remove the blind:
- Perform these operations in reverse order.
Note : the roller has a moving flap to avoid interference
with the second-row passengers when the seats are i n
the reclined position. Position 2 : (7-seat configuration)
Behind the third-row seats, this position conceals
objects stowed in the boot from outside view.
To install the roller :
1.
Roll up the blind, then remove the roller from its
initial position.
2. Position the roller, with the blind pull bar upper-
most, flap downward.
3. Fold the concertina plates in the vertical position.
4. Engage the lug on the left of the roller in notch C.
5. Pass the right-hand side above the third-row armre st.
6. Engage the lug in notch D.
7. Pull the seat belt(s) so that they will deploy without
locking.
8. Unroll the blind and engage the guides into the
rails on the pillars.
9. Lock the seat(s) in position.
10. Fold back the concertina plates, pressing them
firmly in position.

CDIII
143
B o o T
- L U G G A G E C o V E R B L i N d - G R A N d C 4 P i C A S S o
Position 2 : (continued)
To remove the roller :
1. Push the flap towards the seat backrest.
2. Lift the concertina plate by grabbing it at the side,
then position it vertically.
3.
Unlock the seat by pulling the strap G (see « Third-row
rear seats »).
4. Push the backrest towards the front.
5. Proceed in reverse order to installing.
Note : you can position the concertina plate vertically
to lodge a bulkier object in the boot well.
Position 3 : (7-seat configuration, stowage
position)
To install the roller :
1. Remove the blind from its current position.
2. Position the roller, with the blind pull bar upper-
most, flap downward.
3. Engage the lug on the left of the roller in notch C.
4. Pass the right-hand side above the third-row armre st.
5. Engage the lug in notch D.
To remove the roller :
- Proceed in reverse order to installing.

B
III
145
The rear pneumatic suspension enhances driving
comfort by maintaining a constant body height what-
ever the vehicle load.
OPERATION
- if there is an increase in vehicle load, a sinking of the rear of the vehicle is detected and the pneumatic
springs inflate in order to compensate for the extra
weight.
- if there is an decrease in load, a rising of the rear of the vehicle is detected and so the pneumatic springs
deflate to return the vehicle to its nominal height.
- if the vehicle has been unused for a long period, the pneumatic springs may inflate if necessary when you
unlock or open a door, so as to return the vehicle to
its nominal height. Note
: if you do not reactivate the system manually,
the automatic correction will be activated as soon as
the vehicle starts to move. during the correction, the
SERViCE warning lamp lights up and a message on the
screen reminds you not to exceed 10 km/h (6 mph).
Note : the automatic correction does not function if the
doors or the tailgate are open.
The automatic correction operates even if your vehicle
is in economy mode.
ACTIVATION / DEACTIVATION
The automatic correction can be deactivated :
- Press on the button B for approximately two seconds.
-
Release the button when you hear a beep. deactivati on
is confirmed by the lighting of the LED on the butto n B.
it is essential that you should deactivate the system in the following instances :
- working under the vehicle,
- changing a wheel,
- transporting the vehicle on a truck or on a boot.
To reactivate the automatic correction :
- Press again on the button B for approximately
two seconds.
- Release the button when you hear a beep. Activati on is
confirmed by the extinction of the LED on the button B .
In the event of the system malfunctioning, alert
messages, always in association with the SERVICE warning lamp, will display in the instrument panel.
Contact a CITROËN dealer as soon as possible
.
Grand C4 Picasso C4 Picasso
P N E U M AT i C S U S P E N S i o N

555555
IX
F R E Q U E N T LY - A S K E d Q U E S T i o N S
QUESTIONSANSWERSSOLUTIONS
The rec eption qualit y of the radio station being listened to gradually deteriorates.
The vehicle is too distant from the transmitter, or no transmitter is present in the geographical area you are passing th rough.
Activate the RdS function to allow the system to chec k whether a more power ful transmitter is to be found in the geographical area.
The environment (hills, high buildings, tunnels, underground car parks, etc.) is blocking reception, even in RdS mode.This phenomenon is normal and does not imply anythi ng wrong with the radio.
The aerial is absent or has been damaged (for example after going through a car wash or in an underground car park).Have the aerial checked by a CiTRoËN dealer.
When the engine is not running, the radio stops after a few minutes.
When the engine is switched off, the working time fo r the radio depends on the batter y charge. The interruption is nor mal: the radio goes into economy mode, cutting off in order to save the vehicle’s batter y.
You have to star t the engine so as to increase the bat-ter y charge.
T h e m e s s a g e “ t h e a u d i o s y s t e m i s o v e r h e a t i n g ” a p p e a r s o n t h e screen.
in order to protect the audio equipment in excessiv e ambient temperatures, the radio goes into an automatic thermic protection mode which results in a reduction in sound volume or stopping of the Cd player.
Switch off the audio system for a few minutes in order to allow the system to cool down.
Why is one not informed in real time of a hold-up on the route even though the option for guidance by “traffi c info” is activated ?
When you star t up, the system takes a few minutes to c apture the traf fi c information via RDS-TMC.Wait for the traf fi c information to be safely received (pictogrammes displayed on the map) and make sure that you use the major ar terial roads to have “inform ed” navigation.
only the major ar terial roads (motor ways and some d ual car-riageways) are featured in RDS-TMC traf fi c information).
It may happen that a hold-up is not repor ted by the tr af fi c info provider.
Why is a diversion not suggested when I have selected traf fi c info ?
Do not confuse the “traf fi c info” guidance option which can sug-gest a diversion (the “diver t” button appears in the w indow) with the menus “Display of traf fi c messages” or “Reading of traf fi c messages” which af fect only the display without recalculating the itinerar y (no “diver t” button in the window).
To have “informed” navigation with the detour proposi-tion, it is essential to activate the guidance option with “traf fi c info”.