2006 YAMAHA YFZ450 weight

2-7
8Never operate on excessively rough, slippery
or loose terrain until you have learned and
practiced the skills necessary to control the
ATV on such terrain. Always be especially
cautious on these kinds of terrain.
8Always follow proper procedures for turning
as described in this manual. Practice turning
at low speeds before attempting to turn at
faster speeds. Do not turn at excessive
speed.
8Never operate the ATV on hills too steep for
the ATV or for your abilities. Practice on
smaller hills before attempting larger hills.
8Always follow proper procedures for climbing
hills as described in this manual. Check the
terrain carefully before you start up any hill.
Never climb hills with excessively slippery or
loose surfaces. Shift your weight forward.
Never open the throttle suddenly or make
sudden gear changes. Never go over the top
of a hill at high speed.
5TG-9-62 1-3 5/13/05 10:06 AM Page 2-7

2-9
8Always follow proper procedures for going
down hills and for braking on hills as
described in this manual. Check the terrain
carefully before you start down any hill. Shift
your weight backward. Never go down a hill at
high speed. Avoid going down a hill at an
angle that would cause the vehicle to lean
sharply to one side. Go straight down the hill
where possible.
8Always follow proper procedures for crossing
the side of a hill as described in this manual.
Avoid hills with excessively slippery or loose
surfaces. Shift your weight to the uphill side of
the ATV. Never attempt to turn the ATV
around on any hill until you have mastered
the turning technique described in this manual
on level ground. Avoid crossing the side of a
steep hill if possible.
5TG-9-62 1-3 5/13/05 10:06 AM Page 2-9

4-29
EBU14082
Front shock absorber adjustment
The spring preload, rebound damping and com-
pression damping forces of the front shock
absorbers can be adjusted to suit the rider’s
weight and the riding conditions.
w
These shock absorbers contain highly pres-
surized nitrogen gas. Read and understand
the following information before handling the
shock absorbers.
8Do not tamper with or attempt to open the
cylinder assemblies.
8Do not subject the shock absorbers to an
open flame or other high heat source. This
may cause the unit to explode due to
excessive gas pressure.
8Do not deform or damage the cylinders in
any way. Cylinder damage will result in
poor damping performance.
8Take the shock absorbers to a Yamaha
dealer for any service.
5TG-9-62 4 5/12/05 5:18 PM Page 4-29

4-39
EBU14102
Rear shock absorber adjustment
The spring preload, rebound damping and com-
pression damping forces of the rear shock
absorber can be adjusted to suit the rider’s
weight and the riding conditions.
w
This shock absorber contains highly pres-
surized nitrogen gas. Read and understand
the following information before handling the
shock absorber.
8Do not tamper with or attempt to open the
cylinder assembly.
8Do not subject the shock absorber to an
open flame or other high heat source. This
may cause the unit to explode due to
excessive gas pressure.
8Do not deform or damage the cylinder in
any way. Cylinder damage will result in
poor damping performance.
8Take the shock absorber to a Yamaha
dealer for any service.
5TG-9-62 4 5/12/05 5:18 PM Page 4-39

6-31
8Do not mount an accessory where it could
interfere with your ability to control the ATV.
Examples include (but are not limited to) a
heavy or bulky object attached to the handle-
bars which could make steering difficult, an
accessory that limits your ability to move
around on the seat, or one that limits your
view.
8Use extra caution when riding an ATV with
accessories. The ATV may handle differently
than it does without accessories.
EBU02240
Loading
As originally equipped, this ATV is not designed
to carry cargo or tow a trailer. If you choose to
add accessories so that you can carry cargo or
tow a trailer, you must use common sense and
good judgement. Keep the following points in
mind:
8Never exceed the weight limits shown. An
overloaded ATV can be unstable.
5TG-9-62 5-6 5/13/05 1:45 PM Page 6-31

6-33
8Load cargo on the carriers as close to the
center of the vehicle as possible. Put cargo at
the rear of the front carrier and at the front of
the rear carrier. Center the load from side to
side.
8Tie down cargo securely to the carriers. Make
sure cargo in the trailer cannot move around.
A shifting load can cause an accident.
8Make sure the load does not interfere with
controls or your ability to see where you are
going.
8Ride more slowly than you would without a
load. The more weight you carry, the slower
you should go. Although conditions vary, it is
good practice not to exceed 2nd gear when-
ever you are carrying heavier loads or when
towing a trailer.MAXIMUM LOADING LIMIT
Vehicle loading limit (total weight of rider,
cargo and accessories): 100 kg
5TG-9-62 5-6 5/13/05 1:45 PM Page 6-33

6-35
8Allow more braking distance. A heavier vehi-
cle takes longer to stop.
8Avoid making sharp turns unless at very slow
speeds.
8Avoid hills and rough terrain. Choose terrain
carefully. Added weight affects the stability
and handling of the ATV.
w
Never exceed the stated load capacity for
this ATV. Overloading this ATV or carrying
or towing cargo improperly could cause
changes in vehicle handling which could
lead to an accident.
Cargo should be properly distributed and
securely attached. Reduce speed when car-
rying cargo or pulling a trailer. Allow greater
distance for braking.
5TG-9-62 5-6 5/13/05 1:45 PM Page 6-35

7-19
w
8Never exceed the stated load capacity for
this ATV.
8Cargo should be properly distributed and
securely attached.
8Reduce speed when carrying cargo or
pulling a trailer. Allow greater distance for
braking.
8Always follow the instructions in your
Owner’s Manual for carrying cargo or
pulling a trailer.
MAXIMUM LOADING LIMIT
Vehicle loading limit (total weight of rider,
cargo and accessories):
100 kg
5TG-9-62 7 5/12/05 4:28 PM Page 162