2006 YAMAHA YFM700R lock

8-127
4. Push the headlight bulb holder in and turn
it counterclockwise to remove.
5. Remove the defective bulb and replace it
with a new bulb.
w
Do not touch a headlight bulb when it is on
or immediately after it is turned off. You can
be burned or a fire could start if the bulb
touches something flammable. Wait for the
bulb to cool before touching or removing it.
cC
Do not touch the glass part of the headlight
bulb to keep it free from oil, otherwise the
transparency of the glass, the luminosity of
the bulb, and the bulb life will be adversely
affected. Thoroughly clean off any dirt and
fingerprints on the headlight bulb using a
cloth moistened with alcohol or thinner.
1. Headlight bulb holder1. Fixation d’ampoule de phare1. Portabombillas del faro
1. Do not touch the glass part of the bulb.
1. Ne pas toucher le verre de l’ampoule1. Ne tocar la parte de cristal de la bombilla
1S3-9-60 9-11 4/27/05 2:13 PM Page 8-127

8-129
6. Push the headlight bulb holder in and turn
it clockwise to install.
7. Install the headlight bulb holder cover.
8. Connect the headlight coupler.
9. Install the headlight assembly by installing
the bolts.
10. Adjust the headlight beam if necessary.
1S3-9-60 9-11 4/27/05 2:13 PM Page 8-129

9-1
EBU04180
CLEANING AND STORAGE
A. CLEANING
Frequent, thorough cleaning of your machine
will not only enhance its appearance but will
improve its general performance and extend the
useful life of many components.
1. Before cleaning the machine:
a. Block off the end of the exhaust pipe to
prevent water entry. A plastic bag and
strong rubber band may be used.
b. Make sure the spark plug and all filler caps
are properly installed.
2. If the engine case is excessively greasy,
apply degreaser with a paint brush. Do not
apply degreaser to the chain, sprockets or
wheel axles.
3. Rinse the dirt and degreaser off with a gar-
den hose. Use only enough pressure to do
the job.
1S3-9-60 9-11 4/27/05 2:13 PM Page 9-1

9-9
4. Lubricate all control cables.
5. Block up the frame to raise all wheels off
the ground.
6. Tie a plastic bag over the exhaust pipe out-
let to prevent moisture from entering.
7. If storing in a humid or salt-air atmosphere,
coat all exposed metal surfaces with a light
film of oil. Do not apply oil to any rubber
parts or the seat cover.
8. Remove the battery and charge it. Store it
in a dry place and recharge it once a
month. Do not store the battery in an
excessively warm or cold place (less than
0 °C (30 °F) or more than 30 °C (90 °F)).
NOTE:
Make any necessary repairs before storing the
machine.
1S3-9-60 9-11 4/27/05 2:13 PM Page 9-9