PRE-DELIVERY INSPECTION REPORT
f. Wheels
Tyre :Tyre pressure Solo Double
(PSI)
Front 25 25
Rear 32 32
R i m : Runout - Radial - 1.5 mm (Max)
- Lateral - 1.5 mm (Max)
Spokes : No loosenes
g. Locks Operation : • Ignition
Steering Fuel Tank Cap Side Cover (L.H.)
h. Fasteners Specified Torque
(Ft-Lb)
1. Front Wheel Axle Nuts25-40
2. Front Fork (Crown Handle & Inner Tube)13-202. Front Fork under Bracket Stem Nut18-223. Handle Bar Mounting Bolts13-204. Rear Shock Absorber Mounting Bolts22-355. Rear Swing Arm Pivot Shaft Nut32-526. Rear Wheel Axle/Sprocket. Shaft Nuts60-70
B. ENGINE
a. Engine Oil : Oil Level (For checking - Refer Pg. 6-11)
Check for any Leakages
10-32
SERVICE2.pmd9/24/2005, 8:01 AM 2
3.6 KEEP OUR ENVIRONMENT CLEAN.
Please follow simple steps
DO’S ()
1
Always use genuine ‘spare parts’ purchased from
YMIS
Authorised Dealers.
2
Always use only genuine oils
4T - 20W/40 SG grade - YAMALUBE 4T
3 Always keep your engine well tuned. Save environment and also improve Fuel Efficiency
4 ALWAYS GET YOUR MOTORCYCLE REPAIRED AND MAINTAINED ONLY AT YMIS AUTHORISED
DEALER.
YMIS serves you through a large network of Authorised Dealers.
5.Check the Following at every scheduled service:-
a) Spark Plug : Check/Reset Gap/Replace as per the recommendations
in this Owner’s Manual (page no 6-7)
b) Carburetor : Cleaning/Adjustment Every 4500 kmsc) Air Filter : Clean every 2000 kms as per the environment conditions.
d) Piston/Rings/Cylinder : Check / Clean / Replace if necessary
e) Exhaust System : Check / Replace if necessary
f) Valve Timing : Check / Adjust every 4500 kms
g) Compression pressure : Check / Diagnose.
DO’S AND DON’TS FOR THE MOTORCYCLE
2
greenbook.pmd9/24/2005, 8:00 AM 4
