2006 YAMAHA VX lock

1-13
E
EJU10011
Cruising limitations

Scan constantly for people, objects, and
other watercraft. Be alert for conditions
that limit your visibility or block your vision
of others.

Operate defensively at safe speeds and
keep a safe distance away from people,
objects, and other watercraft.

Do not follow directly behind watercraft or
other boats.

Do not go near others to spray or splash
them with water.

Avoid sharp turns or other maneuvers
that make it hard for others to avoid you or
understand where you are going.

Avoid areas with submerged objects or
shallow water.

Take early action to avoid collisions.
Remember, watercraft and other boats do
not have brakes.

Do not release the throttle when trying to
steer away from objects—you need throt-
tle to steer. Always check throttle and
steering controls before starting the
watercraft.

Ride within your limits and avoid aggres-
sive maneuvers to reduce the risk of loss
of control, ejection, and collision.

This is a high performance boat—not a
toy. Sharp turns or jumping wakes or
waves can increase the risk of back/spinal
injury (paralysis), facial injuries, and bro-
ken legs, ankles and other bones. Do not
jump wakes or waves.

Do not operate the watercraft in rough
water, bad weather or when visibility is
poor; this may lead to an accident caus-
ing injury or death. Be alert to the possi-
bility of adverse weather. Take note of
weather forecasts and the prevailing
weather conditions before setting out on
your watercraft.

As with any water sport, you should not
operate your watercraft without someone
else nearby. If you operate further than
swimming distance from shore, you
should be accompanied by another boat
or watercraft, but make sure you stay a
safe distance away. It’s good, common
sense!

Never operate in water that is less than
60 cm (2 ft) deep, otherwise you increase
your chance of hitting a submerged
object, which could result in injury.
E_F1K-70.book Page 13 Thursday, October 20, 2005 1:30 PM

2-5
E
EJU10090
Operation of controls and
other functions
EJU10100
Seat
There is a seat latch 1 at the rear of the
seat to remove the seat.
To remove the seat:
Pull the seat latch up, and then pull the
seat off.
To install the seat:
Insert the projection on the front of the
seat into the stay on the deck, and then
push the rear of the seat down to lock it in
place securely.
NOTE:@ Make sure that the seat is properly secured
before operating the watercraft.
@
E_F1K-70.book Page 5 Thursday, October 20, 2005 1:30 PM

2-6
E
EJU12130
Hood
To open the hood, pull the latch 1 up,
and then lift the hood up.
To close the hood, push the hood down to
lock it in place.
NOTE:@ Make sure that the hood is properly secured
before operating the watercraft.
@
EJU10120
Fuel tank filler cap
To remove the fuel tank filler cap 1, turn it
counterclockwise.
NOTE:@ Make sure that the fuel tank filler cap is
properly secured before operating the water-
craft.
@
E_F1K-70.book Page 6 Thursday, October 20, 2005 1:30 PM

2-10
E
EJU21161
Start switch
Push the start switch 1 (green button) to
start the engine.
NOTE:@ The engine will not start when the lock mode
of the Yamaha Security System has been
selected (for VX110 Deluxe), the clip is
removed from the engine shut-off switch, or
the throttle lever is squeezed. (See page
2-15 for Yamaha Security System and low-
RPM mode selection procedures.)
@
EJU10180
Throttle lever
Squeeze the throttle lever 1 to increase
engine speed.
Release the throttle lever to decrease
engine speed or to return it to the idle posi-
tion.
E_F1K-70.book Page 10 Thursday, October 20, 2005 1:30 PM

2-15
E
EJU19940
Yamaha Engine Management
System (YEMS)
This model is equipped with an inte-
grated, computerized management system
that controls and adjusts ignition timing, fuel
injection, engine diagnostics, and the Off-
Throttle Steering (OTS) system.
EJU20723
Yamaha Security System/
Low-RPM mode (for VX110
Deluxe)
This watercraft is equipped with a remote
control transmitter 1 that is used to select
the security system and low-RPM mode set-
tings. Since the watercraft is programmed to
recognize the internal code from this trans-
mitter only, the security system setting can
only be changed with this transmitter. If you
lose the remote control transmitter or it does
not operate properly, contact a Yamaha
dealer.
EJU21561
Yamaha Security System (for
VX110 Deluxe)
The Yamaha Security System functions to
help prevent unauthorized use or theft of the
watercraft. The engine cannot be started if
the security system is in the lock mode. The
engine can only be started in the unlock
mode.
E_F1K-70.book Page 15 Thursday, October 20, 2005 1:30 PM

2-16
E
EJU21572
Yamaha Security System lock and
unlock modes (for VX110 Deluxe)
The lock and unlock modes of this system
can only be selected while the engine is
stopped.
When the lock button 1 is pressed, the
beeper sounds once. This indicates the lock
mode is selected and the engine cannot be
started.
The “SECURITY” indicator light 2 comes
on when the security system is in the unlock
mode and goes off when the security sys-
tem is in the lock mode.
When the unlock button 3 is pressed for
a short time, the beeper sounds two times
for the normal mode or three times for the
low-RPM mode. The “SECURITY” indicator
light will come on and the engine can be
started. (See the items in “Selecting the nor-
mal mode/low-RPM mode” for operation
mode information.)
Number of
beepsYamaha Security
System modeEngine can
be started
1 beep Lock NO
2 beepsUnlock
(normal mode)YES
3 beepsUnlock
(low-RPM mode)YES
E_F1K-70.book Page 16 Thursday, October 20, 2005 1:30 PM

2-17
E
EJU21583
Selecting the normal mode/
low-RPM mode (for VX110 Deluxe)
The normal mode and low-RPM mode
can only be selected when the engine is
stopped in the unlock mode. Press the
unlock button for more than 4 seconds to
select the normal mode or low-RPM mode.
Normal mode
If the beeper sounds twice, the normal
mode is activated.
The watercraft can be ridden normally.
Low-RPM mode
If the beeper sounds three times, the
low-RPM mode is activated and the
“L-MODE” indicator light 1 comes on.
Maximum engine speed (r/min) in the
low-RPM mode is limited to approximately
90% of the maximum engine speed in the
normal mode.
NOTE:@
If neither the start switch nor the remote
control transmitter is operated within
25 seconds after the unlock button is
pressed to select the unlock mode, the
multifunction meter display and the
“L-MODE” indicator light will go off. If this
occurs, press the lock button briefly to
select the lock mode, press the unlock
button briefly to select the unlock mode,
and then press the unlock button again for
more than 4 seconds to select the normal
mode or low-RPM mode.

While the engine is running, input from
the remote control transmitter is not
received.
@
CAUTION:@ If the remote control transmitter does not
operate when its buttons are pressed,
the battery may be low. Have a Yamaha
dealer replace the battery.
@
E_F1K-70.book Page 17 Thursday, October 20, 2005 1:30 PM

2-23
E
EJU20801
“SECURITY” indicator light
(for VX110 Deluxe)
The “SECURITY” indicator light 1 comes
on when the unlock mode of the Yamaha
Security System is selected. The watercraft
can be ridden normally when this light is on.
(See page 2-15 for more information.)
EJU20811
“L-MODE” indicator light
(for VX110 Deluxe)
The “L-MODE” indicator light 1 comes
on when the low-RPM mode is selected.
(See page 2-15 for more information.)
E_F1K-70.book Page 23 Thursday, October 20, 2005 1:30 PM