2006 YAMAHA VX steering

3-29
E
EJU19960
Turning the watercraft
Steering control depends on the combi-
nation of handlebar position and the amount
of throttle.
Water sucked in through the intake grate
is pressurized by the impeller in the jet
pump. As the pressurized water is expelled
from the pump through the jet thrust nozzle,
it creates thrust to move and steer the
watercraft. The higher the engine speed, the
more thrust produced.
The amount of jet thrust, in addition to the
position of the handlebars, determines how
sharply you turn.
A. More throttle produces higher thrust, so
the watercraft will turn more sharply.
B. Less throttle produces lower thrust, so
the watercraft will turn more gradually.
C. Releasing the throttle lever completely
produces only minimum thrust. If you are
traveling at speeds above trolling, you
will have rapidly decreasing ability to
steer without throttle. You may still have
some turning ability immediately after
releasing the throttle lever, but once the
engine slows down, the watercraft will no
longer respond to handlebar input until
you apply throttle again or you reach
trolling speed.
At trolling speed, the watercraft can be
turned gradually by handlebar position
alone using just the amount of thrust
available at idle.
D. If the engine is stopped while riding,
there is no thrust. The watercraft will go
straight even though the handlebars are
turned.
You need throttle to steer.
E_F1K-70.book Page 29 Thursday, October 20, 2005 1:30 PM

3-30
E
WARNING@
Do not release the throttle lever when
trying to steer away from objects—you
need throttle to steer. A collision could
result in severe injury or death.

When operating at higher speeds,
make gradual turns or slow down
before turning. Sharp high-speed turns
may cause the watercraft to slide side-
ways or spin, throwing the operator
and passengers overboard which
could cause an injury.
@
This model has the Yamaha Engine Man-
agement System (YEMS) that includes an
Off-Throttle Steering (OTS) system. It will
activate at planing speeds should you
attempt to steer the watercraft after releas-
ing the throttle lever (see condition C
above). The OTS system assists in turning
by continuing to supply some thrust while
the watercraft is decelerating, but you can
turn more sharply if you apply throttle while
turning the handlebars. The OTS system
does not function below planing speeds or
when the engine is off. Once the engine
slows down, the watercraft will no longer
turn in response to handlebar input until you
apply throttle again or you reach trolling
speed.
E_F1K-70.book Page 30 Thursday, October 20, 2005 1:30 PM

4-3
E
EJU21270
Lubrication
WARNING@ Do not spray flammable rust inhibitor
products on engine surfaces while the
engine is hot. The sprayed substance or
propellants could catch fire.
@
1. Remove the seat. (See page 2-5 for seat
removal and installation procedures.)
2. Loosen the clamp screw 1 and discon-
nect the air intake duct 2.
3. Spray a rust inhibitor into the intake
opening 3 for 3 seconds.
4. Connect the air intake duct and tighten
the clamp screw.
5. Start the engine in a well-ventilated area
and let it run at idle for 15 seconds.
CAUTION:@ Do not run the engine for more than
15 seconds. The engine could overheat.
@
6. Lubricate all cables such as the throttle
and steering cables.
NOTE:@ Use a suitable marine grease applicator to
pressure lubricate the cables and purge out
any moisture between the inner and outer
cables.
@
7. Lubricate the areas of the watercraft
specified under Lubrication points on
page 4-18.
E_F1K-70.book Page 3 Thursday, October 20, 2005 1:30 PM

4-14
E
EJU21280
Checking the air filter element
Have a Yamaha dealer check and clean
or replace the air filter element every
12 months or every 100 hours of operation.
EJU18891
Inspecting the jet thrust nozzle
angle
Check for smooth operation of the handle-
bars and jet thrust nozzle.
Turn the handlebars as far as possible to
the right and left and check that the differ-
ence of distances A and B between the jet
thrust nozzle and the nozzle is within specifi-
cation.
If steering is stiff or misadjusted, have a
Yamaha dealer service it.
EJU21290
Inspecting the shift cable
(for VX110 Deluxe)
Place the shift lever in the reverse posi-
tion.
Make sure that the reverse gate makes
contact with the stopper 1.
If the reverse gate does not make contact
with the stopper, have a Yamaha dealer ser-
vice it. Difference of A and B:
Maximum 5 mm (0.20 in)
E_F1K-70.book Page 14 Thursday, October 20, 2005 1:30 PM

4-18
E
EJU21310
Lubrication points
To keep moving parts sliding or rotating
smoothly, coat them with water-resistant
grease.
Recommended water-resistant grease:
Yamaha Marine Grease/
Yamaha Grease A

Throttle cable (handlebar end)
Pull the throttle lever and remove the
seal1. Spray a rust inhibitor into the
outer cable. Refit the seal securely.

Steering cable (handlebar end)

Steering cable (nozzle end)

Nozzle pivot shaft
E_F1K-70.book Page 18 Thursday, October 20, 2005 1:30 PM

6-2
E
Limitations on who may operate the
watercraft .............................................. 1-12
“L-MODE” indicator light
(for VX110 Deluxe)................................ 2-23
Location of main components ................. 2-1
Lubrication............................................... 4-3
Lubrication points .................................. 4-18
M
Maintenance and adjustments ................ 4-7
Manufactured date label.......................... 1-4
Model information (For Europe only)....... 1-3
Multifunction meter ....................... 2-18, 3-14
O
Oil pressure warning indicator............... 2-21
Operating your watercraft...................... 3-20
Operation .............................................. 3-15
Operation of controls and other
functions .................................................. 2-5
Operation requirements ........................ 1-14
Other labels ........................................... 1-10
Owner’s/Operator’s Manual and
tool kit ...................................................... 4-9
P
Periodic maintenance chart................... 4-10
Post-operation checks........................... 3-34
Pre-operation check list........................... 3-5
Pre-operation check points ..................... 3-6
Pre-operation checks .............................. 3-5
Primary Identification (PRI-ID) number ... 1-1
R
Recommended equipment .................... 1-16
Remote control transmitter
(for VX110 Deluxe).................................. 2-7
Replacing the fuses............................... 4-23
Reverse on waterways
(for VX110 Deluxe)................................ 3-33
Riding watercraft with passengers ........ 3-21
Rough water operation .......................... 3-33
S
Safe boating rules ................................. 1-21
Safety information ................................. 1-12
Seat ......................................................... 2-5
“SECURITY” indicator light
(for VX110 Deluxe)................................ 2-23Selecting the normal mode/
low-RPM mode (for VX110 Deluxe) ...... 2-17
Shift lever and reverse gate
(for VX110 Deluxe) ................................ 3-12
Shift lever (for VX110 Deluxe) ............... 2-13
Specifications ........................................ 4-24
Speedometer......................................... 2-19
Starting and boarding in shallow
water ..................................................... 3-23
Starting from a dock .............................. 3-23
Starting the engine ................................ 3-17
Starting the watercraft ........................... 3-22
Start switch............................................ 2-10
Steering system ...........................2-12, 3-12
Stern drain plug ....................................... 3-9
Stopping the engine .............................. 3-19
Stopping the watercraft ......................... 3-31
Storage.................................................... 4-1
Storage compartments .......................... 2-24
Submerged watercraft ............................. 5-8
Switches ................................................ 3-14
T
Tachometer ........................................... 2-19
Throttle .................................................. 3-11
Throttle lever ......................................... 2-10
Towing the watercraft .............................. 5-7
Transporting .......................................... 3-36
Troubleshooting ...................................... 5-1
Troubleshooting chart ............................. 5-1
Turning the watercraft ........................... 3-29
W
Warning labels ........................................ 1-6
Watercraft characteristics ...................... 1-17
Water separator ...................................... 3-8
Water-skiing .......................................... 1-19
Y
Yamaha Engine Management
System (YEMS) ..................................... 2-15
Yamaha Security System
(for VX110 Deluxe) ................................ 2-15
Yamaha Security System lock and
unlock modes (for VX110 Deluxe) ........ 2-16
Yamaha Security System/Low-RPM
mode (for VX110 Deluxe) ...................... 2-15
E_F1K-70.book Page 2 Thursday, October 20, 2005 1:30 PM