–+ELEC
6 - 14
CHARGING SYSTEM
EC680000
CHARGING SYSTEM
EC681001
INSPECTION STEPS
If the battery is not charged, use the following inspection steps.
*1 marked: Refer to “FUSE INSPECTION ” section in the CHAPTER 3.
*2 marked: Refer to “BATTERY INSPECTION AND CHARGING ” section in the CHAPTER 3.
NOTE:
Remove the following parts before inspection.
1) Seat assembly
Refer to “FRONT FENDER, SEAT ASSEMBLY AND FUEL TANK ” section in the CHAPTER 4.
Use the following special tool in this inspection.
Pocket tester:
YU-03112-C/90890-03112
*1 Check fuse. Replace fuse and
check wire harness.
*2 Check battery. Recharge or replace.
Check each coupler and wire connection. Repair or replace.
Check charging voltage. Charging system is
good.
Check AC magneto. Charging coil Replace.
Replace rectifier/regulator.
OK
OK
OK
No good
OK
No good
OK
No good
No good
No good
–+ELEC
6 - 16
CARBURETOR HEATING SYSTEM
CARBURETOR HEATING SYSTEM
INSPECTION STEPS
Use the following steps for checking the possibility of the malfunctioning carburetor heating system.
NOTE:
Remove the following parts before inspection.
1) Seat
2) Fuel tank
Refer to “FRONT FENDER, SEAT ASSEMBLY AND FUEL TANK ” section in the CHAPTER 4.
Use the following special tools in this inspection.
Pocket tester:
YU-03112-C/90890-03112
Check entire carburetor
heating system for connec- tion. Repair or replace.
Check thermo switch. Replace.
Check carburetor heater. Replace. Check AC magneto. Lighting coil Replace.
Replace rectifier/regulator.
OK
OK
OK
OK
No good
No good
No good
No good
