2006 YAMAHA SLIDER 50 brake

GIVE SAFETY THE RIGHT OF WAY
1
EAU03099
Further safe-riding points•
Be sure to signal clearly when making turns.
•
Braking can be extremely difficult on a wet road. Avoid hard braking, because the scooter could slide.
Apply the brakes slowly when stopping on a wet surface.
•
Slow down as you approach a corner or turn. Once you have completed a turn, accelerate slowly.
•
Be careful when passing parked cars. A driver might not see you and open a door in your path.
•
Railroad crossings, streetcar rails, iron plates on road construction sites, and manhole covers become
extremely slippery when wet. Slow down and cross them with caution. Keep the scooter upright, otherwise
it could slide out from under you.
•
The brake pads could get wet when you wash the scooter. After washing the scooter, check the brakes
before riding.
•
Always wear a helmet, gloves, trousers (tapered around the cuff and ankle so they do not flap), and a
bright colored jacket.
•
Do not carry too much luggage on the scooter. An overloaded scooter is unstable.
1-2

2
DESCRIPTIONLeft view
12345 6
7 8 9 10
1. Rear brake lever (page 3-5)
2. Left handlebar switches (page 3-4)
3. Speedometer unit (page 3-3)
4. Luggage hook (page 3-8)
5. Main switch (page 3-1)6. Seat lock (page 3-8)
7. Final transmission oil filler cap (page 6-6)
8. Air filter element (page 6-7)
9. Kickstarter (page 3-8)
10. Front brake pads (page 6-12)
2-1

2
DESCRIPTION
Right view
11. Front brake lever (Page 3-4)
12. Throttle grip (Page 6-8)
13. Right handlebar switches (Page 3-4)
14. Front brake fluid reservoir (Page 6-13)
15. Centerstand (Page 6-15)16. Battery (fuse) (Page 6-17 — 6-19)
17. Anti-theft device housing (Page 3-9)
18. Fuel tank cap (Page 3-5)
19. Oil tank cap (Page 3-5)
11 12 13 14
15
16 18 19
17
2-2

EAU00027
INSTRUMENT AND CONTROL FUNCTIONSMain switch / steering lock .................................................................. 3-1
Indicator and warning lights ................................................................ 3-2
Speedometer unit ................................................................................ 3-3
Handlebar switches ............................................................................. 3-4
Front brake lever ................................................................................. 3-4
Rear brake lever ................................................................................. 3-5
Fuel and 2-stroke engine oil tank caps ............................................... 3-5
Fuel ..................................................................................................... 3-6
2-stroke engine oil ............................................................................... 3-7
Catalytic converter .............................................................................. 3-7
Starter (choke) lever ........................................................................... 3-7
Kickstarter ........................................................................................... 3-8
Seat ..................................................................................................... 3-8
Luggage hook ..................................................................................... 3-8
Anti-theft device housing ..................................................................... 3-9
3

INSTRUMENT AND CONTROL FUNCTIONS
3
12
3
ZAUM0142
1
ZAUM0473
1
ZAUM0084
1. Horn switch “
”
2. Turn signal switch “
”
3. Dimmer switch “
,
”1. Start switch “
”1. Front brake lever
EAU00118
Handlebar switches
EAU00125
Turn signal switch “
”
To signal a right-hand turn, push this
switch to the right. To signal a left-hand
turn, push this switch to the left. When
released, the switch returns to the
center position. To cancel the turn si-
gnal lights, push the switch in after it
has returned to the center position.
EAU00129
Horn switch “
”
Press this switch to sound the horn.
EAU03888
Dimmer switch “
,
”
Set this switch to “
” for the high beam
and to “
” for the low beam.
EAUM0063
Start switch “
”
Push this switch while applying the front
or rear brake to crank the engine with
the starter.
EC000005
See page 5-1 for starting instruc-tions prior to starting the engine.
EAU03882
Front brake leverThe front brake lever is located on the
right handlebar grip. To apply the front
brake, pull this lever toward the
handlebar grip.
3-4

3
INSTRUMENT AND CONTROL FUNCTIONS
1
ZAUM0085
2 1
ZAUM0144
EAU00163
Rear brake leverThe rear brake lever is located on the
left handlebar grip. To apply the rear
brake, pull this lever toward the
handlebar grip.1. Rear brake lever
EAU03463
Fuel and 2-stroke engine oil
tank capsThe fuel tank cap and the 2-stroke
engine oil tank cap are located under
the seat. (See page 3-8 for seat
opening and closing procedures.)
Fuel tank cap
To remove the fuel tank cap, turn it
counterclockwise, and then pull it off.
To install the fuel tank cap, turn it
clockwise.2-stroke engine oil tank cap
To remove the 2-stroke engine oil tank
cap, pull it off.
To install the 2-stroke engine oil tank
cap, push it into the oil tank opening.
EW000025
Make sure that the fuel and 2-stroke
engine oil tank caps are properlyinstalled before riding the scooter.
1. Fuel tank cap
2. Oil tank cap
3-5

PRE-OPERATION CHECKS
4The condition of a vehicle is the owner’s responsibility. Vital components can start to deteriorate quickly and unexpectedly,
even if the vehicle remains unused (for example, as a result of exposure to the elements). Any damage, fluid leakage or
loss of tire air pressure could have serious consequences. Therefore, it is very important, in addition to a thorough visual
inspection, to check the following points before each ride.
ITEM CHECKS PAGE
•Check fuel level in fuel tank.
Fuel•Refuel if necessary.3-6•Check fuel line for leakage.
•Check oil level in oil tank.
Two-stroke engine oil•If necessary, add recommended oil to specified level. 3-7•Check vehicle for oil leakage.
Final transmission oil•Check oil level and vehicle for oil leakage. 6-6
•Check operation.
•If soft or spongy, have Yamaha dealer bleed hydraulic system.
Front brake•Check fluid level in reservoir. 3-4, 6-11
•If necessary, add recommended brake fluid to specified level.
•Check hydraulic system for leakage.
•Check operation.
Rear brake•Check lever free play. 3-5, 6-11•Adjust if necessary.
•Make sure that operation is smooth.
Throttle grip•Check cable free play.
6-8
•If necessary, have Yamaha dealer adjust cable free playand lubricate cable and grip housing.
EAU03439
Pre-operation check list
4-1

4
PRE-OPERATION CHECKS
ITEM CHECKS PAGE
NOTE :
Pre-operation checks should be made each time the scooter is used. Such an inspection can be accomplished in a veryshort time; and the added safety it assures is more than worth the time involved.
EWA00033
If any item in the Pre-operation check list is not working properly, have it inspected and repaired before operatingthe scooter.
4-2 •Check for damage.
Wheels and Tires•Check tire condition and tread depth.
6-9 — 6-10
•Check air pressure.
•Correct if necessary.
Brake levers•Make sure that operation is smooth.
3-4 — 3-5•Lubricate lever pivoting points if necessary.
Centerstand•Make sure that operation is smooth.
6-15•Lubricate pivot if necessary.
Chassis-fasteners•Make sure that all nuts, bolts and screws are properly tightened.
—•Tighten if necessary.
Instruments, lights•Check operation.
3-1 — 3-4, 6-20 — 6-21
signals and switches•Correct if necessary.
Battery•Check fluid level.
6-17
•Fill with distilled water if necessary.