2006 YAMAHA MAJESTY 180 change wheel

• Always obey the speed limit
and never travel faster than
warranted by road and traffic
conditions.
• Always signal before turning or
changing lanes. Make sure that
other motorists can see you.
The posture of the operator and
passenger is important for proper
control.
• The operator should keep both
hands on the handlebar and
both feet on the footboard
during operation to maintain
control of the scooter.
• The passenger should always
hold onto the operator, the seat
strap or grab bar, if equipped,
with both hands and keep both
feet on the passenger foo-
trests.
• Never carry a passenger
unless he or she can firmly pla-
ce both feet on the passenger
footrests.
Never ride under the influence of
alcohol or other drugs.
This scooter is designed for on-
road use only. It is not suitable for
off-road use.
Protective apparel
The majority of fatalities from scooter
accidents are the result of head inju-
ries. The use of a safety helmet is the
single most critical factor in the pre-
vention or reduction of head injuries.
Always wear an approved hel-
met.
Wear a face shield or goggles.
Wind in your unprotected eyes
could contribute to an impair-
ment of vision which could delay
seeing a hazard.
The use of a jacket, substantial
shoes, trousers, gloves, etc., is
effective in preventing or redu-
cing abrasions or lacerations.
Never wear loose-fitting clothes,
otherwise they could catch on
the control levers or wheels and
cause injury or an accident.
Never touch the engine or
exhaust system during or after
operation. They become very hot
and can cause burns. Always
wear protective clothing thatcovers your legs, ankles, and
feet.
Passengers should also observe
the above precautions.
Modifications
Modifications made to this scooter
not approved by Yamaha, or the
removal of original equipment, may
render the scooter unsafe for use and
may cause severe personal injury.
Modifications may also make your
scooter illegal to use.
Loading and accessories
Adding accessories or cargo to your
scooter can adversely affect stability
and handling if the weight distribution
of the scooter is changed. To avoid
the possibility of an accident, use
extreme caution when adding cargo
or accessories to your scooter. Use
extra care when riding a scooter that
has added cargo or accessories. Here
are some general guidelines to follow
if loading cargo or adding accessories
to your scooter:1
tSAFETY INFORMATION
1-2
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 8

ODOMETER READING (x 1000 Km) ANNUAL
CHECK
NoITEM CHECK OR MAINTENANCE JOB 1 10 20 30 40
9 * Rear brake • Check operation, fluid level and vehicle for fluid leakage.√√ √ √√ √
•Replace brake pads. Whenever worn to the limit
10 * Wheels • Check runout and for damage.√√√√
11 * Wheel bearings • Check bearing for looseness or damage.√√√√
12 * Steering bearings • Check bearing play and steering for roughness.√√ √ √√
• Lubricate with lithium-soap-based grease. Every 24000 km
13 * Chassis fasteners • Make sure that all nuts, bolts and screws are √√√√ √
properly tightened.
14 Sidestand, centerstand • Check operation.
• Lubricate.√√√√ √
15 * Sidestand switch • Check operation.√√ √ √√ √
16 * Front fork • Check operation and for oil leakage.√√√√
17 * Shock absorber • Check operation and shock absorbers for oil leakage.√√√√
assemblies
18 * Carburetor • Adjust engine idling speed.√√ √ √√ √
19 Engine oil • Change. (See page *-*.)√When the oil change
indicator light comes on (every 3000 km)
• Check oil level and vehicle for oil leakage. Every 3000 km√
20 * Engine oil strainer • Clean.√
21 * Cooling system • Check coolant level and vehicle for coolant leakage.√√√√ √
• Change. Every 3 years
22 Final gear oil • Check oil level and vehicle for oil leakage.√√ √
• Change.√√√
23 * V-belt • Replace. Every 10000 km
PERIODIC MAINTENANCE AND MINOR REPAIR
6-3
6
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 32

EAU20011
Final gear oil
1. Oil filler cap
The final gear case must be checked
for oil leakage before each ride. If any
leakage is found, have a Yamaha dea-
ler check and repair the vehicle. In
addition, the final gear oil must be
changed as follows at the intervals
specified in the periodic maintenance
and lubrication chart.
EWA10370
s s
WARNING
Make sure that no foreign
material enters the final gear
case.
Make sure that no oil gets on
the tire or wheel.
To check the final gear oil level
1. Place the vehicle on the centers-
tand.
1. Drain bolt
NOTE:
The final gear oil level must be
checked on a cold engine.
Make sure that the vehicle is posi-
tioned straight up when checking
the oil level. A slight tilt to the side
can result in a false reading.
2. Remove the oil filler bolt, and
then check the oil level in the final
gear case.
NOTE:
The oil level should be at the brim of
the filler hole.
3. If the oil is below the brim of the
filler hole, add sufficient oil of the
recommended type to raise it to
the correct level.
4. Install the oil filler bolt, and then
tighten it to the specified torque.
To change the final gear oil
1. Place an oil pan under the final
gear case to collect the used oil.
2. Remove the oil filler bolt and
drain bolt to drain the oil from the
final gear case.
3. Install the final gear oil drain bolt,
and then tighten it to the speci-
fied torque.
Tightening torque:
Final gear oil filler bolt:
22 Nm (2,2 m•kgf, 15,91 ft•lbf)
1
1
6
PERIODIC MAINTENANCE AND MINOR REPAIR
6-9
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 38

DimensionsOverall length
2030 m
Overall width
745 mm
Overall height
1285 mm
Seat height
774 mm
Wheelbase
1480 mm
Ground clearance
102 mm
Minimum turning radius
102 mm
WeightWith oil and fuel
142 kg
EngineEngine type
Liquid cooled 4-stroke, SOHC
Cylinder arrangement
Forward-inclined single cylinder
Displacement
124.1 cm
3
175.6 cm3
Bore x stroke
53.7 x 54.8 mm
62.2 x 57.8 mm
Compression ratio
11 : 1
11 : 1
Starting system
Electric starterLubrication system
Wet sump
Engine oilType
SAE10W30 or SAE10W40 SE type
Engine oil quantityPeriodic oil change
1.30 L
Transmission oilType
YAMALUBE 4 (10W30) or SAE10W30
type SE motor oil
Cooling systemCoolant reservoir capacity (up to the maxi-
mum level mark)
0.60 L
Air filterAir filter element
Dry element
FuelRecommended fuel
Regular unleaded gasoline only
Fuel tank capacity
10.5 L
CarburetorManufacturer
TEIKEI
Type x quantity
TK28 x 1
TK28 x 1
Spark plug (s)Manufacturer/model
NGK/CR8ESpark plug gap
0.7-0.8 mm
ClutchClutch type
Dry, centrifugal automatic
TransmissionPrimary reduction system
Helical gear
Primary reduction ratio
40/15 (2.666)
Secondary reduction system
Helical gear
Secondary reduction ratio
44/12 (3.666)
Transmission type
V-belt automatic
ChassisFrame type
Steel tube underbone
Caster angle
28.00 degree
Trail
104.0 mm
Front tireType
Tubeless
Size
120/70-12 47L
Manufacturer/model
MICHELIN
CHENG SHIN
PIRELLI
8
SPECIFICATIONS
8-1
5XL-F8199-E3.qxd 19/09/2005 16:26 Página 58